Question is ⇒ A 3 phase star-connected load has one capacitor C in R phase and two equal resistances in Y and B phases.The phase sequence is RBY. Then, Options are ⇒ (A) VB0 > VY0, (B) VB0 < VY0, (C) VB0 = VY0, (D) VB0 = VBY, (E) , Leave your comments or Download question paper.

Question is ⇒ A 3 phase star-connected load has one capacitor C in R phase and two equal resistances in Y and B phases.The phase sequence is RBY. Then, Options are ⇒ (A) VB0 > VY0, (B) VB0 < VY0, (C) VB0 = VY0, (D) VB0 = VBY, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 3 phase star-connected load has one capacitor C in R phase and two equal resistances in Y and B phases.The phase sequence is RBY. Then
A.	V_B0 > V_Y0 [Correct Answer]
B.	V_B0 < V_Y0 [Wrong Answer]
C.	V_B0 = V_Y0 [Wrong Answer]
D.	V_B0 = V_BY [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is
0.12 H
0.08 H
0.06 H
0.04 H

⇒ When a p-n-p transistor is properly biased to operate in active region the holes from emitter.
diffuse through base into collector region
recombine with electrons in base
recombine with electrons in emitter
none of the above

⇒ Frequency modulation consists in
varying the frequency and amplitude of the carrier in accordance with the instantaneous value of modulating signal
varying the amplitude of the carrier in accordance with the instantaneous value of the modulating voltage
varying the frequency of the carrier voltage in accordance with the instantaneous value of the modulating voltage
vary the frequency of the carrier voltage

⇒ Which of the following statements is not correct regarding modes of electromagnetic energy transmission?
In TE mode the direction of electric field is always and everywhere transverse to the direction of propagation
In TM mode the magnetic field pattern is always and everywhere transverse to the direction of propagation
The subscripts is TE and TM designations denote the number of half sine wave variations of the field components in x and y directions respectively.
TM₁₁ is called the dominant mode.

⇒ Which of the following statements about the matched filter in a communication receiver are correct?

Its impulse response depends on the signed shape
It maximizes the SNR at the detection shape.
It produces ISI.
It may produce phase error if synchronization is improper.

Select the correct answer from the codes given below:
1 and 4 only
1 and 2 only
2, 3 and 4
1, 2 and 4

⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform

⇒ Which mode has the minimum cutoff frequency in rectangular wave guides?
TE₁₁
TE₁₀
TE₀₁
TE₂₀

⇒

Assertion (A): In CC amplifier the collector is at ac ground

Reason (R): CC amplifier is also called emitter follower

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): A thermocouple transducer is based on Seeback effect.

Reason (R): In a thermocouple transducer used for temperature measurement, the cold junction is usually kept in ice bath.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The gate width of a monostable multivibrator is given by
T = 1.1 RC
T = 0.693 RC
0.963 RC
T = 0.369 RC

⇒ Frequency band used for radar is generally
VLF
VHF
UHF
EHF

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The input voltage to the amplifier is
0.1 m V
0.4 m V
1 m V
4 m V

⇒ Current derating may be necessary when thyristors are operating in
series
parallel
series or parallel
none of the above

⇒ The input impedance for folded dipole antenna (two half dipole) is
73 n²
377 n²
73 n
377 n

⇒ Which of the following conversion is incorrect?
111110111₂ = 767₈
11011010₃ = 665₈
1011.1111₂ = 13.74₈
10101.11₂ = 26.5₈

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the base current will be
35 μA
25 μA
15 μA
5 μA

⇒ In which function is each term known as maxterm?
SOP
POS
Hybrid
SOP and Hybrid

⇒ The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10^-6 N-m on full scale. If B = 1 Wb/m², range of meter is
1 mA
2 mA
3 mA
4 mA

⇒ In an oscillator crystal, the parallel resonant frequency is
equal to
higher than
less than
series resonant frequency

⇒ The internal impedance of a source is 3 + j 7 Ω. For maximum power transfer, load impedance should be
3 + j 7 Ω
3 - j 7 Ω
7 + j 3 Ω
7 - j 3 Ω

⇒ If v(t) = 0 for t < 0 and e^-at for t ≥ 0 V(jω) = 1/(a + jω).
TRUE
FALSE

⇒ A sinusoidal voltage is written as v = I_m (R² + X_C²)^0.5 sin 314 t. Its peak value and frequency are
I_m and 50
I_m (R₂ + X²_C)^0.5 and 50
0.707 I_m (R₂ + X²_C)^0.5 and 50
2 I_m (R₂ + X²_C)^0.5 and 50

⇒ CMRR is the ratio of differential voltage gain to common mode gain.
TRUE
FALSE

⇒ An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of 0-5 V range through a 250 gain amplifier. For a displacement 0.5 mm the output of LVDT is 2 mV. The sensitivity of instrument is
0.1 V/mm
0.5 V/mm
1 V/mm
5 V/mm

⇒

Assertion (A): Ideal current sources and ideal voltage sources do not exist in reality.

Reason (R): All sources have finite internal impedances.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If a RAM has 34 bits in its MAR and 16 bits in its MDR, then its capacity will be
32 GB
16 GB
32 MB
16 MB

⇒ Parallel wire transmission line is an example of
lumped network
distributed
depend upon I/P signal strength
power I/P

⇒

Assertion (A): In a Schottky diode the reverse recovery time is almost zero.

Reason (R): A Schottky diode has aluminium silicon junction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ Macroscopic quantities of a given material
are absolutely constant
are a function of temperature
are a function of temperature, pressure field
none of the above