Question is ⇒ The time required for horizontal blanking is 16% of that for each horizontal line. If horizontal time is 63.5 μs, the horizontal blanking time for each line is about, Options are ⇒ (A) 1 μs, (B) 10 μs, (C) 100 μs, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The time required for horizontal blanking is 16% of that for each horizontal line. If horizontal time is 63.5 μs, the horizontal blanking time for each line is about, Options are ⇒ (A) 1 μs, (B) 10 μs, (C) 100 μs, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The time required for horizontal blanking is 16% of that for each horizontal line. If horizontal time is 63.5 μs, the horizontal blanking time for each line is about
A.	1 μs [Wrong Answer]
B.	10 μs [Correct Answer]
C.	100 μs [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As access time is decreased, the cost of memory
remains the same
increases
decreases
may increase or decrease

⇒ When a lead acid battery is being charged, the specific gravity of the electrolyte
decreases
increases
either increases or decreases
remains the same

⇒

Assertion (A): In a BJT, a_dc is about 0.98.

Reason (R): In a BJT, recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ ECL is a saturating logic.
TRUE
FALSE

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ The circuit shown in the figure is best described
bridge rectifier
ring modulator
frequency discriminator
voltage doubler

⇒ Which one is discrete time periodic signal?
sin 3pn
cos 2pn
sin 3pn
all

⇒ Some possible functions of AGC in a TV receiver are

To increase gain for weak signals
To decrease gain for strong signals
To change the contrast when we switch from one channel to other
To reduce flutter

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2, 3
2, 3, 4

⇒ In flip flops the duration of clock pulse is about
3 ns
10 ns
25 ns
50 ns

⇒ A circuit which cannot demodulate SSB is
balanced modulator
product detector
BFO
phase discriminator

⇒ Yettrium-iron garnet (Y₂Fe₅O₁₂) is a soft magnetic material suitable for applications involving
dc
50 Hz ac
ac of a few K Hz
ac of a few hundred MHz

⇒ A 14 pin NOT gate 1C has __________ NOT gates.
8
6
5
4

⇒ A direct current can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a standard resistance
by dc potentiometer in conjunction with volt ratio box
none of the above

⇒ The phase angle curve of G(jω) H(jω) is drawn by adding the phase angles of individual factors.
TRUE
FALSE

⇒ The unit of magnetic flux density is
farad/metre
ohm/metre
tesla
ampere/metre

⇒ Consider the following stateme
2 and 4
1 and 2
1 only
3 and 4

⇒ At room temperature the number of conducting electrons in an intrinsic semiconductor
is almost equal to the number of valence electrons
is about half the number of valence electrons
is small as compared to the number of valence electrons
is a very small fraction of the number of valence electrons

⇒ The Ebers-moll equation for I_E in CB configuration is given by
I_E = a_nI_CI_EC0
I_E = a_II_C + I_C0
I_E = a_nI_C + I_C0(e^qVEB/KT-1)
I_E = a_II_C + I_E0(e^qV_EB/KT - 1)

⇒ For the two port of figure, z_{1126/7 Ω
10/3 Ω
6 Ω
2 Ω}

⇒ As per Hall effect, if any specimen carrying a current I is applied in a transverse magnetic field B, then an electric field E is induced in the specimen in the direction.
parallel to I
perpendicular to B and parallel to I
parallel to I and B
perpendicular to both I and B

⇒ The contents of stack location 2109 H after the call operation wil
1111
1010101
100000
100010

⇒ Some ADCs are

Parallel
Updown
Single slope
Dual slope
Successive approximation
Stair step

Out of above which ones do not use DAC?
1 only
1, 3, 4
1, 2, 3
1, 5, 6

⇒

Assertion (A): If contents of F register in 8085 are 01010001, it means S = 0, Z = 1, AC= 1, P = 0 and CY = 1.

Reason (R): When an instruction is called from memory, the op. code of instruction is stored in instruction register.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In active filter circuits, inductances are avoided mainly because they
are always associated with some resistance
are bulky and unsuitable for miniaturisation
are non-linear in nature
saturate quickly

⇒ For the DAC in the given figure V_{O10 V
5 V
4 V
8 V}

⇒ It is desired that transmission line and load should match for a range of frequencies. The best method is
to use a balun
to use a single stub of adjustable position
to use a double stub
to use a broad band amplifier

⇒ A 6 bit ladder A/D converter has input 101001. The output is (assume 0 = 0 V and 1 = 10 V)
4.23
6.41
5.52
9.23

⇒ As temperature increases, the temperature coefficient of a metal
decreases
increases
remains unchanged
any of the above

⇒ The voltage transfer functions of two port circuits connected in cascade can be easily found from
product of individual ABCD matrices
product of voltage transfer functions of two networks
sum of z matrices
sum of h matrices

⇒ High frequency inductors and capacitors are commonly plated with silver. The main purpose of this is to
reduce dc resistance
reduce ac resistance
increase dc resistance
increase ac resistance