Question is ⇒ In figure, which value of ZL will cause maximum power to be transferred to the l, Options are ⇒ (A) 2 + j2 Ω, (B) 2 - j2 Ω, (C) - 2 Ω, (D) 2 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, which value of ZL will cause maximum power to be transferred to the l, Options are ⇒ (A) 2 + j2 Ω, (B) 2 - j2 Ω, (C) - 2 Ω, (D) 2 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, which value of Z_L will cause maximum power to be transferred to the l
A.	2 + j2 Ω [Wrong Answer]
B.	2 - j2 Ω [Wrong Answer]
C.	- 2 Ω [Wrong Answer]
D.	2 Ω [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An FM transmitter delivers 80W to a load of 30 W when no modulation is present. The carrier is now frequency modulated by a single sinusoidal signal and the peak frequency deviation is so adjusted to make the amplitude of the second sideband is zero in the given out
5.12 W
21.78 W
2.56 W
16.81 W

⇒ If operator 'a' = 1 ∠120° then (1 - a) =
3
3 ∠ - 30°
3 ∠ + 30°
3 ∠60°

⇒ In control systems the output of sensor usually, is
analog electrical signal
digital electrical signal
mechanical signal
analog or digital electrical signal

⇒ In order to achieve good stabilization in potential divider method current I₁ through R₁ and R₂ should be
I₁ > 20 I_B
I₁ > 15 I_B
I₁ < 5 I_B
I₁ > 10 I_B

⇒ When microprocessor processes both positive and negative numbers, the representation used is
l's complement
2's complement
signed binary
any of the above

⇒ In FM, when the bandwidth is doubled, the signal to noise ratio improves by a factor of
2 dB
4 dB
6 dB
8 dB

⇒ What will happen to a bird sitting on a conductor?
It will die of shock
It will not die of shock because its claws are insulated
It will not die because it is insulated from earth and other conductors
None of the above

⇒ As compared to BJT, MOSFET has
lower switching losses and higher conduction losses
higher switching losses and higher conduction losses
higher switching losses and lower conduction losses
lower switching losses and lower conduction losses

⇒ The method of frequency compensation in moving iron voltmeter is
to use a capacitor in series with coil
to connect a capacitor in parallel with coil
to connect a capacitor in parallel with series resistance
none of the above

⇒ The binary number 0.10110111101 is equal to hexadecimal number
B3A
B5A
B7A
BA7

⇒ The circuit shown in figure, will act as an ideal current source with respect to terminals A and B, when frequenc
zero
1 rad/s
4 rad/s
16 rad/s

⇒ Consider the following strings

A
Z2
X3Y
P12R
BX

Which of the above strings are valid in Pascal?
All
1, 2, 3
1, 2, 4, 5
1, 2, 3, 5

⇒

Assertion (A): The modified ramp function of the given figure can be represented s sum of two ramp functions of the given fig
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which one of the following statements regarding DSI is wrong?
It is a digital form of TASI
Though it is more efficient than TASI, it is much slower
A speaker has to wait (it at all) for only a few milliseconds for reallocation of channel
It has increased the capacity of satellite channels by a factor of 2.2 or more with out degrading speech quality

⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V

⇒ Efficiency of class A power amplifier is very poor.
TRUE
FALSE

⇒ A discrete LTI system is non-casual if its impulse response is
aⁿ ∪(n - 2)
a^n-2 ∪(n)
aⁿ⁺² ∪(n)
aⁿ ∪(n + 2)

⇒ Accurate amplitude measurements can be made more easily than accurate phase shift measurements.
TRUE
FALSE

⇒ Which of the following expressions may be used to correctly describe the temperature (T) variation of the intrinsic carrier density (n_i) of a semiconductor?
n_i(T) = (A/T) exp (- E₈/kT²)
n_i(T) = A (- E₈/2kT)¹⁰
n_i(T) = A exp (- E₈/2kT²)
n_i(T) = AT^3/2 exp (-E₈/2kT)

⇒ Which materials find application in MASER?
Diamagnetic
Paramagnetic
Ferromagnetic
Ferrimagnetic

⇒ Electrons can be emitted from a metal surface due to high electric field.
TRUE
FALSE

⇒ Thyristors are suitable for dc circuit breakers but not for ac circuit breakers.
TRUE
FALSE

⇒ A quarter wave line short circuited at load end behaves as
an inductance
an inductance and capacitance in series
a capacitance
an inductance and capacitance in parallel

⇒

Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.

Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): The horizontal intercept of dc load line is the same as ideal cut off point

Reason (R): When a transistor is in cut off region, collector current is zero

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which of these has semi-conductor metal junction?
PIN diode
Photo diode
Tunnel diode
Schottky diode

⇒ The maximum theoretical efficiency for class A amplifier is
0.125
0.25
0.5
0.75

⇒ In a transistor operating in forward active mode
depletion layer between emitter and base is thin and that between base and collector is also thin
both depletion regions are thick
depletion layer between emitter and base is thin and that between base and collector is thick
depletion layer between emitter and base is thick and that between base and collector is thin

⇒ Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is
0.12 H
0.08 H
0.06 H
0.04 H

⇒ When two 16-input multiplexers drive a 2-input MUX, what is the result?
2-input MUX
4-input MUX
16-input MUX
32 input MUX