Question is ⇒ If short-circuited and open circuited impedances are 5 ohms and 20 ohms, then characteristic impedance is, Options are ⇒ (A) 1 ohms, (B) 10 ohms, (C) 25 ohms, (D) 100 ohms, (E) , Leave your comments or Download question paper.

Question is ⇒ If short-circuited and open circuited impedances are 5 ohms and 20 ohms, then characteristic impedance is, Options are ⇒ (A) 1 ohms, (B) 10 ohms, (C) 25 ohms, (D) 100 ohms, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If short-circuited and open circuited impedances are 5 ohms and 20 ohms, then characteristic impedance is
A.	1 ohms [Wrong Answer]
B.	10 ohms [Correct Answer]
C.	25 ohms [Wrong Answer]
D.	100 ohms [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A Hartley oscillator is used for
very low frequencies
radio frequencies
micro wave frequencies
audio frequency

⇒ If interrupt service request have been received from all of the following interrupts, then which one will be serviced last?
RST 5.5
RST 6.5
RST 7.5
None of these

⇒ The depth of modulation is doubled in FM system then, the power transmitted
increase by factor of 2
increase by factor of 3
increase by factor of 2
none of the above

⇒ The data about p the pull required to lift a weight wby a pulley bloc
3.2 + 0.171 w
2.28 + 0.1879 w
1.2 + 0.25 w
0.6 + 0.3 w

⇒ The IF bandwidth of a radar receiver is inversely proportional to
pulse interval
pulse width
PRF
none of the above

⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.

⇒ Which of the following power amplifiers has highest efficiency?
Class A
Class AB
Class B
Class C

⇒ Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have
reduced losses
high bandwidth
reduced losses and low bandwidth
more losses and low bandwidth

⇒ As compared to MOS memories, bipolar memories have
slower access time but are cheaper
slower access time and are costly
faster access time and are cheaper
faster access time and are costly

⇒ The number of unused states in a 4 bit Johnson counter is
2
4
8
12

⇒ A sequence x(n) with the z transform X(z) = z⁴ + z² - 2z + 2 - 3z - 4 is applied as an input to a linear, time invariant system with the impulse response h(n) = 2δ(n - 3) wh
-6
zero
2
-4

⇒ The Table given below is the mark obtained by 2 students in 8 different subjec
y + 0.57x = 9.7558
y - 0.57x = 9.758
033y + x = 6.335
0.33y - x = 6.335

⇒ In 8085 microprocessor with memory mapped I/O which of the following is true?
I/O devices have 16 bit addresses
I/O devices are accessed during IN and OUT instructions
There can be a maximum of 256 input and 256 output devices
Logic operations can not be performed

⇒ An image uses 512 x 512 picture elements. Each of the picture elements can take any of the 8 distinguishable intensity levels. The maximum entropy in the above image will be
2097152 bits
786432 bits
648 bits
144 bits

⇒ The chemical properties of atoms are determined by all the electrons and their configuration.
TRUE
FALSE

⇒

Assertion (A): For elemental dielectrics, P = Na_eE_i where N is number of atoms/m³, P is polarization, a_e is electronic polarization and E_i is internal electric field.

Reason (R): In elemental dielectrics there are no permanent dipoles or ions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In 8085 the pins for + 5 V input and ground are
20 and 40 respectively
40 and 20 respectively
1 and 2 respectively
1 and 1 respectively

⇒ Which materials find application in MASER?
Diamagnetic
Paramagnetic
Ferromagnetic
Ferrimagnetic

⇒ As the reverse voltage is increased, the depletion layer
becomes narrow
widens
remains the same
reduce to zero

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ Which gives minimum probability of error?
ASK
FSK
PSK
DPSK

⇒ Minimum no. of 2 I/P NAND gate required to implement the Boolean function Z = ABC, assuming that A, B and C are available is
2
3
5
6

⇒ In figure, the power dissipated in 4 resistance is P₁ and power associated with 3 A source is P₂.
P₁ = P₂
P₁ < P₂
P₁ > P₂
P₁ may be equal or less than P₂

⇒ Which of the following subtraction operations do not result in F₁₆?

(BA)₁₆ - (AB)_{161 and 2
1 and 3
2 and 3
1, 2 and 3}

⇒ FM signal can be generated by
diode reactance modulator
saturable reactor modulator
reactance tube modulator
none of the above

⇒ The given figure shows log magnitude versus ω plots of a system for different values of gain. For this sy
curve 1 shows highest gain margin and curve 2 shows poorest gain margin
gain margins shown by the three curves are equal
curve 1 shows poorest gain margin and curve 3 shows highest gain margin
curve 3 shows poorest gain margin while curve 1 shows highest gain margin
⇒ Consider the following statements.
1. Etching
2. Exposure to UV radiation
3. Stripping
4. Developing
After a wafer has been coated with photo resist the correct sequence of these steps in photolithography is
2, 4, 3, 1
2, 4, 1, 3
4, 2, 1, 3
3, 2, 3, 1
⇒
Assertion (A): JFET is a voltage controlled device.
Reason (R): The drain current can be controlled by controlling V_GS.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ ADC 0804 is a
dual slope A/D converter
single slope A/D converter
successive approximation A/D converter
either (a) or (b)
⇒ Consider the following statements
1. The amplitude of an FM wave is constant
2. FM is more immune to noise than AM
3. FM broadcasts operate in upper VHF and UHF frequency ranges
4. FM transmitting and receiving equipments are simpler as compared to AM transmitting and receiving equipments
Which of the above are correct?
1, 2, 3, 4
1, 2, 3
2, 3, 4
1, 3, 4