Question is ⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it, Options are ⇒ (A) gives a narrow beam shining into space, (B) results in lesser signal attenuation, (C) gives better beam-shaping, (D) is easier to polarize a high frequency beam, (E) , Leave your comments or Download question paper.

Question is ⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it, Options are ⇒ (A) gives a narrow beam shining into space, (B) results in lesser signal attenuation, (C) gives better beam-shaping, (D) is easier to polarize a high frequency beam, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
A.	gives a narrow beam shining into space [Correct Answer]
B.	results in lesser signal attenuation [Wrong Answer]
C.	gives better beam-shaping [Wrong Answer]
D.	is easier to polarize a high frequency beam [Wrong Answer]
View Answer 5 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): When a wattmeter is used for low impedance loads, the pressure coil is connected across the load.

Reason (R): A wattmeter measures apparent power.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ When a current flows through a coil of insulated wire, the coil shows the properties of a magnet.
TRUE
FALSE

⇒ The decimal equivalent of the binary number 10110.0101011101 is
22.24082165
22.340821675
22.3408213125
22.3408203125

⇒ For measuring mutual inductance we can use
Anderson bridge
Maxwell's bridge
Heaviside bridge
Either (a) or (b)

⇒ In a CE amplifier circuit the ac voltage between emitter and ground
is very high
may be high or low
is zero
depends on circuit configuration

⇒ In the circuit of figure the current through 5 Ω resistance at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ In the integer expression - A * B div C + D which operation is done first in Pascal
-
*
div
+

⇒ A FM signal with modulation index M_f is passed through a frequency doubler. The wave in the output of the doubler will have modulation index of
M_f
M_f/2
2M_f
UM_f

⇒ At a frequency equal to cutoff frequency in a rectangular wave guide
the flow of electromagnetic energy is zero
the flow of electromagnetic energy is infinite
the flow of electromagnetic energy is 50% of maximum
the flow of electromagnetic energy is 10% of maximum

⇒

Assertion (A): Ideal current sources and ideal voltage sources do not exist in reality.

Reason (R): All sources have finite internal impedances.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I		List II
A.	Firm ware	1.	Converts program in high level language to machine language
B.	Compiler	2.	Converts assembly language program into machine language
C.	Assembler	3.	Software embedded in hardware
D.	Virtual addressing	4.	Grouping information between various memories

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-2, D-4

⇒

Match the following:

	List I (Amplifier coupling)		List II (Feature)
A.	RC	1.	High voltage gain and impedance matching
B.	Inductive	2.	Ability to amplify dc and low frequency signals
C.	Transformer	3.	Minimum non-linear distortion
D.	Direct	4.	Low collector supply voltage can be used

A-4, B-1, C-3, D-2
A-3, B-4, C-1, D-2
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1

⇒ Tuned voltage amplifiers are not used
radio receivers
public address system
T.V. Receivers
band of freq. selected and amplified

⇒ For the two port of figure, z_{2226/7 Ω
6/7 Ω
2/3 Ω
1 Ω}

⇒ Ripple factor RF and form factor FF are related as
RF = FF² - 1
RF = (FF² - 1)^0.5
RF = FF - 1
RF = (FF - 1)^0.5

⇒ If a electromagnetic signal is incident at 0° in a waveguide then at other port of waveguide we will get
zero power
∞ power
depend upon input signal strength
depend on frequency

⇒ The attenuation in waveguide above to cut off frequency
very high
very low
zero
infinite

⇒ For representing two sinusoidal voltages on a phasor diagram
Both voltages must be of the same frequency
Both voltages must be sinusoidal but may be of different frequencies
One of the voltages must be of 50 Hz
The frequency of one must be integral of that of other

⇒ A conductor is said to be perfect if it has __________ conductivity
finite
infinite
unity
zero

⇒ In figure, I = 2A, then
5 V
3 V
2 V
1 V

⇒ In a varistor the v-i graph is linear.
TRUE
FALSE

⇒ The impurity added to extrinsic semiconductor is of the order of
1 in 100
1 in 1000
1 in 100, 0000
1 in 100, 000, 000

⇒ Which memory does not require programming equipment?
RAM
EPROM
EEPROM
UVPROM

⇒ The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5V. The value of the resistance R_s for a drain current I_DS = 6.4 m
156 Ω
470 Ω
560 Ω
1 kΩ

⇒

Assertion (A): A hot wire ammeter has a cramped scale.

Reason (R): The heat is proportional to square of current.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Match the following:

	List I (VCR system)		List II (Azimuth angle)
A.	VHS	1.	7°
B.	Video 2000	2.	15°
C.	Betamax	3.	6°

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-1, C-2
A-3, B-2, C-1

⇒ Load Z_L for maximum power transfe
R
R + jωL
R - jωL
none

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ In figure, the current through R is 1 A when V_A = 0 and V_B = 15V. If both V_A and V_B are increased by 15V each, current through R wil
0.0416666666666667
0.5 A
0.125
0.33 A

⇒

Match the following:

	List I		List II
A.	Electro-encephalograph	1.	Diagnostic tool for heart ailment
B.	Electro-cardiograph	2.	Diagnostic tool for brain ailment
C.	Sphygmomanometer	3.	used for measuring BP
D.	Stethoscope	4.	used to heart pulse/ heart beat

A-2, B-1, C-3, D-4
A-3, B-1, C-2, D-4
A-2, B-1, C-4, D-3
A-1, B-2, C-3, D-4