Question is ⇒ For 200V r.m.s. value triangular wave, the peak voltage will be, Options are ⇒ (A) 200 V, (B) 222 V, (C) 280 V, (D) 346 V, (E) , Leave your comments or Download question paper.

Question is ⇒ For 200V r.m.s. value triangular wave, the peak voltage will be, Options are ⇒ (A) 200 V, (B) 222 V, (C) 280 V, (D) 346 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For 200V r.m.s. value triangular wave, the peak voltage will be
A.	200 V [Wrong Answer]
B.	222 V [Wrong Answer]
C.	280 V [Wrong Answer]
D.	346 V [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a bipolar transistor the barrier potential
0
a total of 0.7 V
0.7 V across each depletion layer
0.35 V

⇒ Two infinitely long wires carrying current are as shown in the figure below. One wire is in the y-z plane and parallel to the y-axis. The other wise is in the x-y plane and parallel to the x-axis. Which components of the resulting magnetic field are non-zero at the ori
x, y, z components
x, y components
y, z components
x, z components

⇒ Which of the following is error correcting code?
EBCDIC
Gray
Hamming
ASCII

⇒ Which connection is rarely used?
CE
CB
CC
Both (a) and (b)

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒ In the circuit shown in given figure, the values of i(0⁺) and I(∞), will be respecti
zero and 1.5 A
1.5 A and 3 A
3 A and zero
3 A and 1.5 A

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10

⇒ Energy = voltage x charge.
TRUE
FALSE

⇒ In PAL system
phase of U signal is reversed on alternating lines
phase of V signal is reversed on alternating lines
phases of both U and V signals are reversed on alternating lines
none of the above

⇒ In a certain network not containing any dependent sources, number of nodes = 4 and number of branches is equal to 6.
4
2
3
5

⇒ In 8085, which instructions are useful for writing and using subroutines?
CALL
RET
CALL and RET
none of the above

⇒ The number of channels in a stereophonic system is
8
4
2
1

⇒ An 8 bit binary number is to be entered into an 8 bit serial shift register. The number of clock pulses required is
1
2
4
8

⇒ In a colour TV receiver the bandwidth of RF amplifier is
exactly equal to channel width
a little less than channel width
a little more than channel width
either (a) or (b)

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3

⇒ Long distance short-wave radio broadcasting uses
ground wave
ionospheric wave
direct wave
any of the above

⇒ Which of the following is true?
The poisson distribution is limiting case of binomial distribution.
In symmetrical distribution, the mean, median and mode coincide.
Regression is the estimation or production of unknown values of one variables from known values of another variable.
All are true.

⇒ Generally the wall thickness of rectangular waveguide is
about 1-5 mils
about 40-100 mils
about 0.1 to 0.5 mils
about 500 mils

⇒ Consider the following digital circu
1 and 2
3 and 4
1, 2 and 3
1, 2, 3 and 4

⇒ If the temperature of on extrinsic semiconductor is increased so that the intrinsic carrier concentration is doubled, then
the majority carrier density doubles
the minority carrier density doubles
the minority carrier density becomes 4 times the original value
both majority and minority carrier densities double

⇒ In windows the middle button of mouse is not used.
TRUE
FALSE

⇒ A seven bit (even parity) code 0010001 may have error. The correct code is
10001
1110001
11001
1111110

⇒ Binary number 11001 is equivalent to decimal number
35
15
105
25

⇒ A system is said to be marginal stable if
poles lies on Real axis
zero lies on Real axis
poles lies on Imaginary axis
zeros lies on origin

⇒ For determining the network functions of a two-port network, it is required to consider that
all initial conditions remain same
all initial conditions are zero
part of initial conditions are equal to zero
initial conditions vary depending on nature of network

⇒ Consider the circuit shown below of 2 : 1 MUX is given by the function g = ac + bc
X ⊕ Y
XY + EXY
XE + XY
none of these

⇒ The number of valence electrons in germanium atom is
4
2
1
zero

⇒ An RF carrier of 12 kV at 1 MHz is amplitude modulated by 1 kHz signal having peak value of 6 kV. The modulation pattern is seen on CRO screen. The voltage indicated will be
18 kV
1.001 kV
6 kV
36 kV

⇒ What is the purpose of DMA facility in microprocessor based system?
To increase the speed of data transfer between the mP and the I/O devices
To increase the speed of data transfer between the mP and the memory
To increase the speed of data transfer between the memory and the I/O devices
To improve the reliability of the system

⇒ The open loop gain of an ideal op-amp is
infinite
very high
neither high nor low
low

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math