Question is ⇒ Dielectric strength of polythene is around, Options are ⇒ (A) 10 kV/mm, (B) 40 kV/mm, (C) 100 kV/mm, (D) 140 kV/mm, (E) , Leave your comments or Download question paper.

Question is ⇒ Dielectric strength of polythene is around, Options are ⇒ (A) 10 kV/mm, (B) 40 kV/mm, (C) 100 kV/mm, (D) 140 kV/mm, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Dielectric strength of polythene is around
A.	10 kV/mm [Wrong Answer]
B.	40 kV/mm [Correct Answer]
C.	100 kV/mm [Wrong Answer]
D.	140 kV/mm [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the modulation index is
1
2
3
4

⇒ The number of comparator circuits required to build a three-bit simultaneous A/D converter is
7
8
15
16

⇒ Consider the following statements about constants in 8085

The assembler treats 64 H as hexadecimal constant.
The assembler treats 154 as binary constant.
The assembler treats 540 as octal constant.
The assembler treats 138 as decimal constant.

Which of the above are correct?
1, 2 and 3 only
1, 3 and 4 only
1 and 3 only
2 and 4 only

⇒ A seven bit (even parity) code 0010001 may have error. The correct code is
10001
1110001
11001
1111110

⇒

Match the following:

	List I		List II
A.	Multiplexer	1.	Sequential memory
B.	De-multiplexer	2.	Converts decimal number to binary
C.	Shift register	3.	Data selector
D.	Encoder	4.	Routes single input to many outputs

A-3, B-4, C-1, D-2
A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-1, B-2, C-3, D-4

⇒

Assertion (A): At a temperature of 1000 K, thermionic emission current is about 0.1 A/cm² of surface.

Reason (R): Thermionic emission current is given by I_th = SA₀ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the circuit of figure the current through 5 Ω resistance at t = &infin
0
0.416666666666667
6.67 A
5.1 A

⇒ PAM stands for
Phase Angle Modulation
Phase Amplitude Modulation
Pulse Amplitude Modulation
Pulse Angle Modulation

⇒

Assertion (A): In AM carrier component remains constant in amplitude and frequency.

Reason (R): In AM the two side bands are images of each other.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ SSB can be generated by
filter method
phase cancellation method
good attenuation characteristics
all of the above

⇒ The modulation index of an AM wave is changed from 0 to 1. The transmitted power is
unchanged
halved
increased by 50%
quadrupled

⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors

⇒ The superposition theorem is applicable to
linear, non-linear and time variant responses
linear and non-linear resistors only
linear responses only
none of the above

⇒ In a fascimile reproduction time to scan one line is 2 ms. If it has 4% blanking, the visible trace time is
1.92 ms
2.08 ms
50 ms
0.08 ms

⇒ If the characteristic equation of a closed loop system is s² + 2s + 2, then the system is :
over damped
critically damped
under damped
undamped

⇒ If A = 7 ∠15, A² is
49 ∠225°
49 ∠30°
49 ∠15°
49 ∠7.5°

⇒ The function Z(s) has a pole at infinity if
the degree of numerator and denominator of Z(s) are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ In the op-amp circuit of figure, V_{03 V₁ - 4 V₂
-3 V₁ + 4 V₂
3(V₁ - V₂)
-3(V₁ - V₂)}

⇒ Transit time is considered as significant at
HF
MF
LF
all of the above

⇒ Four capacitors are in parallel. Their values are 36.3 μF, 3.85 μF, 34.002 μF and 850 μF with an uncertainty of digit in the last place. The total capacitance in significant figures is
75.0 μF
75.0 ± 0.1 μF
75.1 ± 0.1 μF
75.002 ± 0.1 μF

⇒ A meter with a resistance of 100 Ω and a full scale deflection of current of 1 mA is to be converted into voltmeter of 0 - 5 V range. The multiplier resistance should be
490 Ω
5000 Ω
4900 Ω
5100 Ω

⇒ In Fortran 77 negation is a unary operation.
TRUE
FALSE

⇒ The resistance in the circuit of the moving coil of a dynamometer wattmeter should be
very low
low
high
almost zero

⇒ If poles lie in first quadrant, damping ratio is
1
more than 1
less than 1
zero

⇒ If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is
23 dB
25 dB
46 dB
50 dB

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases

⇒ The series element of a band stop filter is
capacitive
inductive
parallel combination of L and C
series combination of L and C

⇒ The resistivity of a semiconductor
increases as the temperature increases
decreases as the temperature increases
remains constant even when temperature varies
none of the above

⇒ HVDC systems are preferable for only long distances.
TRUE
FALSE

⇒ The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
70
67
100
150