Question is ⇒ Mesh analysis is applicable __________ only., Options are ⇒ (A) planar network, (B) non planar network, (C) a circuit which contains only current sources, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ Mesh analysis is applicable __________ only., Options are ⇒ (A) planar network, (B) non planar network, (C) a circuit which contains only current sources, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Mesh analysis is applicable __________ only.
A.	planar network [Correct Answer]
B.	non planar network [Wrong Answer]
C.	a circuit which contains only current sources [Wrong Answer]
D.	none [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A flip flop is a
combinational circuit
memory element
arithmetic element
memory or arithmetic element

⇒ The admittance parameter Y₁₂ in the 2 port network in the fi
-0.2 mho
0.1 mho
-0.05 mho
0.05 mho

⇒ In a full bridge inverter, the waveshape of load current depends on
relative values of load parameters R, L and C
relative values of load parameters R and L
relative values of load parameters L and C
gating frequency

⇒ Which of the following types of noise assumes greater importance at high frequencies?
Transit time noise
Shot noise
Impulse noise
Random noise

⇒ A string of series connected thyristors needs equalising circuit to
ensure proper firing
ensure proper current division
ensure proper voltage division
none of the above

⇒ For an unstable system the gain margin is indicative of how much the gain should be decreased to make the system stable.
TRUE
FALSE

⇒ The discone antenna is
used in UHF range
circularly polarized
used in radar
used as a direction finding antenna

⇒ The autocorrelation function of the white noise is
impulse function
step function
constant
none of the above

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒ A Schottky diode clamp is used along with switching BJT for
reducing the power dissipation
reducing the switching time
increasing the value of β
reducing the base current

⇒ Which of the following statement about JFET is correct?
In an N-channel JFET, the channel is the narrowest under zero gate bias condition
In a JFET the gates are always forward biased
In a JFET, gate-source cut off voltage is numerically equal to the pinch off voltage
It is a voltage controlled device

⇒

Assertion (A): Nyquist stability criterion uses the number of encirclements around (-1 + j0) point in GH plane to determine stability

Reason (R): The (-1 + j0) point in the s plane lies in the Nyquist path.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A FET is a better clapper than a BJT because it has
lower off-set voltage
higher series ON resistance
lower input current
higher input impedance

⇒ A proportional controller is basically
an amplifier with adjustable gain
an integrating amplifier
an amplifier with infinite gain
an amplifier with almost zero gain

⇒ In 8085 the instruction MOV A, B is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ Incompatibility between memory and I/O device may be due to
timing according to which data transfer is to take place
electrical characteristics of the two devices
format of data transfer
all of the above

⇒ In single tone AM modulation, the transmission efficiency for m = 1 is
0.333
0.5
1
0.1665

⇒ In flip flops the duration of clock pulse is about
3 ns
10 ns
25 ns
50 ns

⇒ Both X and Y plates of a CRO are excited by ac signals. The display is an ellipse which makes one rotation in 5 seconds. This means that
the frequency of one input is 5 times that of other
the difference between the frequencies of the two signals is one fifth of hertz
the difference between the frequencies of the two signals is 5 Hz
either (a) or (c)

⇒

Assertion (A): The conditions under which it is possible to write Fourier series of a periodic function are called Drichlet conditions.

Reason (R): If f(t) = - f(- t), it is refereed to as odd symmetry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): In p-n-p transistor collector current is termed negative.

Reason (R): In p-n-p transistor holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ An AM wave is given by s(t)_AM = 20 (1 + 0.5 cos 10³t + 0.3 cos 10⁴ t cos 10⁶ t) the modulation index of the envelope is
0.5
0.58
0.3
0.8

⇒ Examine the following truth table. The product of sum from this truth tabl
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)

⇒ The stage marked X in the architecture shown below of a two stage op-amp
Direct coupled amplifier
Buffer amplifier
Level shifter
Blocking oscillator

⇒ Resistivity of electrical conductors is most affected by
Pressure
temperature
composition
ageing

⇒ If J = 12 and X = 24.4 the result of the following FORTRAN 77 program will be 12, 144, 73.2
15.0, 144.0, 73.2
15.0, 144.0, 73
15. 144. 73

⇒ If f(t) = 1, F(jω) = 2p δ(ω).
TRUE
FALSE

⇒ If the secondary burden of a CT 15 VA and secondary current is 5 A, the load impedance of CT is
0.6 Ω
5 Ω
6 Ω
10 Ω

⇒ Which of the following is not a valid character constant in C?
A'
2'
='
2

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3