Question is ⇒ A boot strap generally incorporates, Options are ⇒ (A) CB configuration, (B) CE configuration, (C) emitter follower, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A boot strap generally incorporates, Options are ⇒ (A) CB configuration, (B) CE configuration, (C) emitter follower, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A boot strap generally incorporates
A.	CB configuration [Correct Answer]
B.	CE configuration [Wrong Answer]
C.	emitter follower [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Reciprocity theorem is applicable to
circuits with one source
circuits with only one independent source
circuits with any number of sources
circuits with any number of independent sources

⇒ Find value
1A
0A
0.45 A
None of these

⇒ In an AM transmitter after the modulation stage, class C amplifier
can be used
cannot be used
may be used, but it has no use
can't be determine to use

⇒ In a backward wave oscillator the efficiency
is much higher than in TWT
is much lower than in TWT
is almost the same as in TWT
either (a) or (b)

⇒ A class E chopper
can operate in second quadrant only
can operate in first or third quadrant
can operate in all the four quadrants
can operate in either second or third quadrant

⇒ The multiplication time for 10-bit numbers with 1 MHz clock will be
32 μ sec
20 μ sec
21 μ sec
22 μ sec

⇒ The effective height of a vertical radiator can be increased by
loading with lumped inductance
supporting on an insulator
capacitive loading
giving input more power

⇒

Assertion (A): When the phase margin of a control system is improved using a lead network, noise transmission increases.

Reason (R): Phase lead compensation increases bandwidth.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): PIN diode is used as a fast switch.

Reason (R): PIN diode has very high resistance when reverse biased and very low resistance when forward biased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The efficiency of a horn speaker is about
0.1
0.4
0.6
0.8

⇒ Consider the following statements: In a differential amplifier using JFET, the differential output offset is due to

mismatch between FET parameters
difference in values of resistances used in circuit
variation in supply voltage.

Of the statements, the correct statements are
1 and 2
1, 2, 3
2, 3
1, 3

⇒ Thu advantage of using a dual stop ADC in a digital voltmeter is that
its conversion time is small
its accuracy high
output is in BCD format
it does not require a comparator

⇒ A 4 bit binary adder has 4 full adders.
TRUE
FALSE

⇒ When an atom of polarizability a is placed in an electric field E, the energy stored in atom is 0.5 a E².
TRUE
FALSE

⇒ Due to the formation of Schottky defects the density of the crystal
increases slightly
increases appreciably
decreases slightly
decreases appreciably

⇒ Figure represen
LED
Varistor
SCR
Diac

⇒ The product kT (where k is Boltzmann's constant and T is absolute temperature) at room temperature is about
0.051 eV
0.026 eV
0.01 eV
0.001 eV

⇒ If A = 20 and B = - 7 in PASCAL, A mod B =
6
2
-1
3

⇒ Consider an input x(t) as sh
-2 < t < 6
0 < t < 11
-2 < t < 5
2 < t < 6

⇒ A short circuited stub is shunt connected to a transmission line as shown in the figure is, if z₀ = 500 ohms, the admittance y seen at the function of the stub and the transmission line
(0.01 - j 0.02) mho
(0.02 - j 0.01) mho
(0.04 - j 0.02) mho
(0.02 + j 0) mho

⇒ In an op-amp comparator, the positive or negative output is
saturated
amplifier
unsaturated
any of the above

⇒ In FDM systems used for telephone, which modulation scheme is adopted?
AM
DSB-SC
SSB-SC
FM

⇒ The device 'one shot' has
two stable states
one stable state
either 1 or 2 stable states
no stable state

⇒ Fastest memory cell
bubble memory
core memory
semiconductor memory
superconductor memory

⇒ Which one of the following is a passive device/Component?
Transformer
Oscillator
Generator
None

⇒ In the stabilized reactance modulators AFC system
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency the better the oscillator frequency stability
the discriminator frequency must not be too low, or the system will fail
phase modulation is converted into FM by the equalizer circuit

⇒ When UJT is used for thyristor gate signal, the output of UJT is
sine wave
square wave
saw tooth wave
either (a) or (c)

⇒ If the operating temperature increases by 10°C, the rate of deterioration of solid dielectric becomes
double
one and a half time
3 times
4 times

⇒ A carrier is simultaneously modulated by two sine waves having modulation indices of 0.4 and 0.3. The total modulation index will be
0.1
0.7
0.5
0.35

⇒ One of the following can be used to generate a pulse whenever triggered
flip-flop
monostable multivibrator
stable multivibrator
Schmitt trigger