Question is ⇒ In a rectangular waveguide, Options are ⇒ (A) the broad width is generally labelled 'a' and height 'b', (B) the broad width is generally labelled 'b' and height 'a', (C) any one of the dimensions may be labelled 'a' and the other 'b', (D) the length is labelled as 'a', (E) , Leave your comments or Download question paper.

Question is ⇒ In a rectangular waveguide, Options are ⇒ (A) the broad width is generally labelled 'a' and height 'b', (B) the broad width is generally labelled 'b' and height 'a', (C) any one of the dimensions may be labelled 'a' and the other 'b', (D) the length is labelled as 'a', (E) , Leave your comments or Download question paper. a' and height 'b', (B) the broad width is generally labelled 'b' and height 'a', (C) any one of the dimensions may be labelled 'a' and the other 'b', (D) the length is labelled as 'a', (E) , Leave your comments or Download question paper. '/> a' and height 'b', (B) the broad width is generally labelled 'b' and height 'a', (C) any one of the dimensions may be labelled 'a' and the other 'b', (D) the length is labelled as 'a', (E) , Leave your comments or Download question paper. '/>Previous question Next question


Q1.	In a rectangular waveguide
A.	the broad width is generally labelled 'a' and height 'b' [Correct Answer]
B.	the broad width is generally labelled 'b' and height 'a' [Wrong Answer]
C.	any one of the dimensions may be labelled 'a' and the other 'b' [Wrong Answer]
D.	the length is labelled as 'a' [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Armstrong modulator generates
AM signals
FM signals
PM signals
both (b) and (c)

⇒ The output of a half adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ The relation between thermal conductivity K (W/m/°C), heat flow density Q (watt/m²) and dT/dx (°C per metre) is
Q = K(dT/dx)
Q = - K(dT/dx)
K = Q(dT/dx)
dT/dx = - QK

⇒ An electron for which l = 0 has zero orbital magnetic dipole moment.
TRUE
FALSE

⇒ The signal defined by the equations f(t) = 0 for t < 0, f(t) = E for 0 ≤ t ≤ a and f(t) = 0 for t > a is
a step function
a pulse function
a shifted step function originating at t = a
none of the above

⇒ In air friction damping
the air pressure opposes the motion of piston when it is moving inwards
the air pressure opposes the motion of piston when it is moving outwards
the air pressure opposes the motion of piston both when it is moving inwards as well as outwards
the air pressure may oppose or aid the motion of piston depending on the design

⇒ A single phase half wave converter is feeding a resistive load. Just before triggering, the voltage across thyristor is
zero
about 1 V
same as input voltage
twice the input voltage

⇒ At room temperature a semiconductor material is
perfect insulator
conductor
slightly conducting
any of the above

⇒

Assertion (A): Static RAMS are used where speed of operation is of primary concern.

Reason (R): Dynamic RAM has lower cost per bit than static RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which data transfer scheme is used when large block of data is to be transferred in a computer?
DMA
Programmed data transfer
Either (a) or (b)
Neither (a) nor (b)

⇒ While keeping the down-link frequency constant, the diameter of a satellite antenna is reduced by half. To offer the same EIRP over the increased coverage area, the RF output power has to be increases by a factor of
2
4
8
16

⇒

Match the following:

	List I (Devices)		List II (characteristic)
A.	BJT	1.	Voltage controlled negative resistance
B.	MOSFET	2.	High current gain
C.	Tunnel diode	3.	Voltage regulation
D.	Zener diode	4.	High input impedance

A-1, B-4, C-2, D-3
A-2, B-4, C-1, D-3
A-2, B-3, C-1, D-4
A-1, B-3, C-2, D-4

⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒ The numbers of accelerating anodes in a CRO is
1
2
3
4

⇒ The wave applied to X plates, for ohtaining trace of voltage wave, is
sawtooth wave
sinusoidal wave
rectangular wave
either (a) or (c)

⇒ In a microwave coaxial cable the inner conductor radius is a and inner radius of outside conductor is b. For TE₁₁ mode the cut off wavelength is about
a + b
p(a + b)
pa
pb

⇒ The conductivity of a semiconductor crystal due to any current carrier is not proportional to
mobility of the carrier
effective density of states in the conduction band
electronic charge
surface states in the semiconductor

⇒ In a series R-L circuit when excited by a 1 volt battery the current is 1 - e^-t. If it is excited by a source 2 sin t, the current will be
2 sin (t - 45°) + e^-t
2 sin (t + 45°) + e^-t
sin (t - 45°) + e^-t
sin (t + 45°) + e^-t

⇒ In a TWT the phase velocity of the axial component of the field on the slow wave structure is kept
equal to velocity of electron
slightly less than velocity of electron
slightly more than velocity of electron
equal to velocity of light in free space

⇒ Which of the following is used to obtain output position in a position control system?
Strain gauge
Load cell
Synchro
Thermistor

⇒ At night D layer of ionosphere is absent.
TRUE
FALSE

⇒

Assertion (A): A common collector amplifier is used for matching a high impedance source to a low impedance load

Reason (R): A common collector amplifier has a near unity voltage gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ De Sauty bridge is very widely used due to
simplicity
perfect balance for imperfect capacitor
perfect balance for air capacitors
maximum sensitivity

⇒ For measuring current at a high frequency we should use
moving iron instrument
electrostatic instrument
thermocouple instrument
moving coil instrument

⇒ Which of the following pulse communication system is inherently immune to noise?
PPM
PCM
PWM
PAM

⇒ In the graph shown in the figure, for the tree with branches b, d and f the fundamental loops would inclu
abf, def, bdea
bdc, def, fba
abde, def, cdb
cea, bdea, abbf

⇒ In figure, the switch is closed at t = 0. At t = 0⁺ The value of current supplied by batter
0.0416666666666667
0.0833333333333333
zero
infinity

⇒

Assertion (A): The conductivity of an n type semiconductor increases with increase in temperature and increase in density of donor atoms.

Reason (R): Diffusion of carriers occurs in semiconductors.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output, frequency for the carrier will be
26 MHz
26.1 MHz
10 kHz
160 kHz

⇒ The signal cos ω_ct + 0.5 cos ω_mt sin ω_ct is
FM only
AM only
both AM & FM
neither AM nor FM