Question is ⇒ The most effective anti jamming technique is, Options are ⇒ (A) frequency hopping, (B) spread-spectrum modulation, (C) key leverage, (D) once-only key, (E) , Leave your comments or Download question paper.

Question is ⇒ The most effective anti jamming technique is, Options are ⇒ (A) frequency hopping, (B) spread-spectrum modulation, (C) key leverage, (D) once-only key, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The most effective anti jamming technique is
A.	frequency hopping [Wrong Answer]
B.	spread-spectrum modulation [Correct Answer]
C.	key leverage [Wrong Answer]
D.	once-only key [Wrong Answer]
View Answer 2 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Silicon is the most favoured semiconductor material.

Reason (R): PIV for silicon diode is more than that for germanium diode.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of flip flops required to construct a register to store number 102₁₀ in binary form is
2
4
8
10

⇒

Assertion (A): The speed of a shaft can be measured by using a dc tacho generator.

Reason (R): A two phase servometer can also be used as a speed transducer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis
will be a capacitor
may be R or C
will be R
will depend on the behaviour of function at s = ∞

⇒ A parity check usually can detect
one-bit error
double-bit error
three-bit error
any-bit error

⇒ If we manage to __________ our natural resources, we would leave a better planet for our children.
uphold
restrain
Cherish
conserve

⇒ Mechanical impedance is the ratio of
rms force to rms velocity
rms force to rms displacement
rms velocity to rms displacement
none of the above

⇒ In solid insulator materials having only one kind of atom, the types of polarization which exist are
electronic only
electronic and ionic
electronic, ionic and permanent
electronic and permanent

⇒

Assertion (A): The resolution of a DAC depends on the number of bits

Reason (R): Low resolution leads to fine control.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a voltage regulator circuit using zener diode the load voltage is nearly constant only if
zener current is very small
zener current is very large
zener current is neither small nor large
None of the above

⇒ In grid bias modulation system the power required for modulating amplifier
is negligibly low since grid is negative
is large as compared to that for plate modulation
is almost the same as compared with plate modulation
is small as compared to that for plate modulation

⇒ The nodal method of circuit analysis is based on
KVLs, ohm law
KCLs, ohm law
KCLs, KVL
KCL, KVL, ohms law

⇒ Parallel adder is
sequential circuit
combinational circuit
either sequential or combinational circuit
none of the above

⇒ Which one of the following is valid integer variable in FORTRAN 77?
BRG
IBRG
VS
PEC

⇒ The frequency of oscillation in a backward wave oscillator can be changed by
varying the voltage which controls beam velocity
varying the beam current
both by varying the beam current and by light varying the voltage which controls beam velocity
changing the rate of thermionic emission

⇒ The magnitude of transport lag factor is always zero.
TRUE
FALSE

⇒ When a p-n junction is forward biased
the width of depletion layer increases
the width of depletion layer decreases
the majority carriers move away from the junction
the current is very small

⇒ Dielectric strength of polythene is around
10 kV/mm
40 kV/mm
100 kV/mm
140 kV/mm

⇒ In Modulation, "carrier" is
resultant wave
speech voltage to be transmitted
voltage with constant frequency, phase or amplitude
voltage for which frequency, phase or amplitude is varied

⇒ A dipole antenna was radiating with some excitation in free space radiating a certain amount of the power. If this antenna is immersed in a lake where water is non-dissipative but has a dielectric constant of 81, the radiated power with the same excitation will
decrease to finite non-zero value
remain the same
increase
decrease to zero

⇒ When p-n junction is reverse biased the holes in p material move towards the junction and electrons in n material move away from the junction.
TRUE
FALSE

⇒ When the mains supply is switched off the contents of primary computer memory are lost.
TRUE
FALSE

⇒ Indicate the false statement: To combat noise
reduce signalling rate
increase transmitted power
use redundancy
increase channel bandwidth

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ Zero suppression is not used in actual practice.
TRUE
FALSE

⇒ A good ohmic contact on a P-type semiconductor chip is formed by introducing
gold as an impurity below the contact
high concentration of donors below the contact
high concentration of acceptors below the contact
thin insulator layer between the metal and semiconductor

⇒ The load circuit of a single phase full bridge inverter
must be underdamped
must be overdamped
may be underdamped or overdamped
may be any type of load

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ If a microstrip is enclosed in a metal enclosure
the radiation losses are increased
the radiation losses are reduced RL
the capacitance becomes zero
the inductance becomes zero