Question is ⇒ In a full wave rectifier, the current in each of the diodes flows for, Options are ⇒ (A) the complete cycle of the input signal, (B) half cycle of the input signal, (C) less than half cycle of the input signal, (D) one-fourth cycle of the input signal, (E) , Leave your comments or Download question paper.

Question is ⇒ In a full wave rectifier, the current in each of the diodes flows for, Options are ⇒ (A) the complete cycle of the input signal, (B) half cycle of the input signal, (C) less than half cycle of the input signal, (D) one-fourth cycle of the input signal, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a full wave rectifier, the current in each of the diodes flows for
A.	the complete cycle of the input signal [Wrong Answer]
B.	half cycle of the input signal [Correct Answer]
C.	less than half cycle of the input signal [Wrong Answer]
D.	one-fourth cycle of the input signal [Wrong Answer]
View Answer 5 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a coupled coil the primary has 100 turns and secondary has 200 turns. The primary produces, a flux Φ = e^-t. The coefficient of coupling is 1. The voltages induced in secondary is
200 e^-t V
200 e^t V
200 V
none of the above

⇒ The voltage of single phase supply to residential consumers in India is
400 V
230 V
2.2 kV
11 kV

⇒ If f(t) is in volts, then F(jω) is in
volts
volt seconds
volts/sec
volt-sec²

⇒ The block diagram of AM transmitter in which high level modulation is used as shown in figure. The block X could
audio power amplifier
buffer RF amplifier
compressor amplifier
none of the above

⇒ Which of the following is not valid in case of bipolars?
It has a low input impedance
It has high voltage gain
It is a current controlled device
It is difficult to bias

⇒ In a Communication system, noise is most likely to affect the signal.
at the transmitter
In the channel
in Information source
at the destination

⇒ In a 3 phase full converter, the instantaneous output voltage can have negative part if
firing angle is less than 60°
firing angle is less than 90°
firing angle is more than 60°
firing angle is more than 90°

⇒

Assertion (A): The Laplace transform of a ramp is 1/s².

Reason (R): The integral of a unit step function gives an impulse function.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A clock signal coordinates the working of different flip flops.
TRUE
FALSE

⇒ For very low frequencies, log magnitude for the given figur
0 dB
-3 dB
3 dB
10 dB

⇒ As compared to full wave rectifier, a half wave rectifier
has higher ripple factor
has lower ripple factor
may have higher or lower ripple factor
has same ripple factor

⇒ Find current flowing through 1 H inductor at t = 0, at which switch 'S' is ope
0
2
3
5

⇒ When a trivalent impurity is added, the semiconductor becomes
p type
n type
intrinsic
neutral

⇒ The pole-zero plot given below corresponds
low pass filter
high pass filter
band pass filter
notch filter

⇒

Assertion (A): The part of root locus on the real axis is not dependent on the poles and zeros which are not on the real axis.

Reason (R): Poles and zeros which are not on the real axis occur in conjugate pairs

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ For the circuit of the given figure, the output equatio
Y = ABCD
Y = AB + CD
Y = A + BCD
Y = ABC + D

⇒ The time constant of an R.C. circuit increases if the value of resistance is
increased
decreased
either of the above
none of the above

⇒ Reflectors and lens antennas are commonly used
in LF communication systems
not beyond 100 kHz
in the range 10 MHz to 100 MHz
above 100 MHz

⇒ The forms of IF statements in FORTRAN 77 are called
logical IF and Block IF
logical IF, block IF and arithmetic IF
logic IF, block IF, arithmetic IF and negate IF
logical IF and arithmetic IF

⇒ In a CD, the depth and width of each pit is
0.5 μm each
0.5 μm and 1 mm respectively
1 μm and 0.5 mm respectively
1 μm each

⇒ A 20 Ω resistor, a 1H inductor and 1μF capacitor are connected in parallel the combination is driven by a unit step current. Under the steady state, source current flows through
inductor
capacitor
resistor
all

⇒ Highest value of Autocorrelation of a function 100 cos 50 pt is
50
100
zero
100/p

⇒ When a current flows through a coil of insulated wire, the coil shows the properties of a magnet.
TRUE
FALSE

⇒ A communication channel with AWGN operating at a signal to noise ratio SNR >> 1 and bandwidth B has capacity C₁. If the SNR is doubled keeping B constant, the resulting capacity C₂ is given by
C₂ ≈ 2C₁
C₂ ≈ C₁ + B
C₂ ≈ C₁ + 2B
C₂ ≈ C₁ + 0.3B

⇒ Consider the following statements regarding sources or error in a Q-meter:

If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.
If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.
The presence of distributed capacitance in a coil modifies the effective Q of the coil.

Which of the above statements are correct?
1, 2 and 3
1 and 2 only
2 and 3 only
1 and 3 only

⇒ Which characteristics of a memory chip is called dc characteristics?
Organisation
Timing characteristics
Physical dimensions
Power consumption and bus loading

⇒ The frame of electric motor is connected to three plates having earthing resistance of 10 Ω, 20 Ω and 30 Ω respectively. The materials of the three plates are copper, aluminium and iron respectively. The percentage of energy dissipated by 10 Ω earthing plate
is more than 50% of total energy
is less than 50% of total energy
depends on the materials of the three plates
may be more or less than 50% of total energy

⇒ A uniform plane magnetic wave incident normally on a plane surface of a dielectric material is reflected and the percentage of reflected power is 75% What is VSWR?
14
1.4
15
13

⇒

Assertion (A): Thyristors can be used in controlled heating, excitation systems of alternators, speed control of motors and HVDC

Reason (R): A static var system using thyristors is very commonly used in high voltage ac systems.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The total number of channels allotted for cellular telephone is
666
333
221
111