Question is ⇒ In a transistor operating in forward active mode, Options are ⇒ (A) depletion layer between emitter and base is thin and that between base and collector is also thin, (B) both depletion regions are thick, (C) depletion layer between emitter and base is thin and that between base and collector is thick, (D) depletion layer between emitter and base is thick and that between base and collector is thin, (E) , Leave your comments or Download question paper.

Question is ⇒ In a transistor operating in forward active mode, Options are ⇒ (A) depletion layer between emitter and base is thin and that between base and collector is also thin, (B) both depletion regions are thick, (C) depletion layer between emitter and base is thin and that between base and collector is thick, (D) depletion layer between emitter and base is thick and that between base and collector is thin, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a transistor operating in forward active mode
A.	depletion layer between emitter and base is thin and that between base and collector is also thin [Wrong Answer]
B.	both depletion regions are thick [Wrong Answer]
C.	depletion layer between emitter and base is thin and that between base and collector is thick [Correct Answer]
D.	depletion layer between emitter and base is thick and that between base and collector is thin [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following assert
Only S2 is true
SI and S2 are both true but S2 is not a reason for SI
SI and S2 are both true and S2 is a reason for SI
Both SI and S2 are false

⇒ Low gain-bandwidth product of a JFET is due to
reduced number of holes
junction capacitive effects
low degree of isolation between input and output
all of the above

⇒ As compared to an ordinary semiconductor diode, a Schottky diode
has higher reverse saturation current
has higher reverse saturation current and higher cut in voltage
has higher reverse saturation current and lower cut in voltage
has lower reverse saturation current and lower cut in voltage

⇒ The impulse response of the DT - LTI system is given be
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ In following circuit, steady state is reached with S open, S is closed at t = 0, the current I at t = 0⁺ is give
9 Ω
6 Ω
7 Ω
10 Ω

⇒ Which of the following statement about the amplitude limiter is not valid?
Leak type bias must be used
Output must be tuned
The circuit is always biased in class C, by virtue of the leak type bias
When the input increases past the threshold of limiting, the gain decreases to keep the output constant

⇒ In a flash type ADC, employing 15 comparators resolution with 10 volts reference; is expected to be :
0.625 V
0.656 V
0.525 V
insufficient data

⇒ Read the following statements:

A μP generally interfaced to several memory chips and I/O devices
Address space provided by μP is partitioned into sub sets of addresses
Address map and address partition refer to different terms in address space

Which of the above are correct?
All
1 and 2 only
2 and 3 only
1, 3 only

⇒ In a series RLC high Q circuit the current peaks at a frequency.
equal to the resonant frequency
greater than the resonant frequency
less than the resonant frequency
none

⇒ In the circuit of figure the current through 5 Ω resistance at t = &infin
0
0.416666666666667
6.67 A
5.1 A

⇒ High frequency waves are
absorbed by the F₂ layer
reflected by the D layer
affected by the solar cycle
none of the above

⇒ The function shown in the fig
impulse function
signum function
unit step function
none of the above

⇒ The question below consists of a pair of related words followed by four pairs of words. Select the pair that best expresses the relation in the original p
fallow : land
unaware : sleeper
wit : jester
renovated : house

⇒ A doped semi-conductor is called
impure semi-conductor
dipole semi-conductor
bipolar semi-conductor
extrinsic semi-conductor

⇒ Antenna commonly used for microwave links are
loop antennas
log periodic antennas
paraboloidal dishes
rhombic antennas

⇒ If F = 95.0 what will be the result of following FORTRAN 77 program? 35
35
25
25

⇒ Which of the following introduces mode partition noise?
Coaxial line
Waveguide
Fibre transmission line
Both coaxial line and waveguide

⇒ When the height of a vertical earthed antenna is less than λ/4
the base input impedance will be capacitive
the base input impedance will be purely resistive
the base input impedance will be inductive
the base input impedance will be negligibly small

⇒ Which of the following are the non-linear application of op-amp?

Current-to-voltage converter
Comparator
Peak detector
Limiter

Select the correct answer from the codes given below:
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4

⇒ Which of the following statement regarding the advantages of the phase discriminator over the slope detector is false?
Better linearity
Fewer tuned circuits
Much easier alignment
Greater limiting

⇒ A bridge rectifier circuit has input of 50 Hz frequency. The load resistance is R_L and filter capacitance is C. For good output wave shape, the time constant R_LC should be at least equal to
10 ms
20 ms
50 ms
100 ms

⇒ If the atomic number of germanium is 32, the number of electrons in the outer most shell will be
2
3
4
6

⇒ The most common method for biasing a JFET is
reverse bias
self bias
voltage divider bias
none of the above

⇒ Which of the following can provide a digital signal?
Slow change in the value of a resister
Sine wave
Square wave
Gradual turning of a potentiometer

⇒ The thermal resistance of a BJT is about
100° C/W
200° C/W
20° C/W
2° C/W

⇒

Assertion (A): Magnetic tape can be accessed only sequentially.

Reason (R): Magnetic tape consists of magnetised spots or tracks.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In standing wave pattern on a transmission line
voltage and current nodes coincide
voltage and current antinodes coincide
voltage nodes and current antinodes as well as current nodes and voltage antinodes coincide
both (a) and (b)

⇒ Compared to a p-n junction with N_A = N_D = 10¹⁴/cm³, which one of the following statements is TRUE for a p-n junction with N_A = N_D = 10²⁰/cm³?
Reverse breakdown voltage is lower and depletion capacitance is lower
Reverse breakdown voltage is higher and depletion capacitance is lower
Reverse breakdown voltage is lower and depletion capacitance is higher
Reverse breakdown voltage is higher and depletion capacitance is higher

⇒ In a practical oscillator, the magnitude of loop gain Aβ is kept slightly larger than unity and the amplitude of oscillations is limited by
the ratio of A to β
the on set of non-linearity of amplifying device
the linearity of amplifying device
all of the above

⇒ When a series RL circuit is switched on to a dc voltage, the rate of change of current is maximum at t = 0.
TRUE
FALSE