Question is ⇒ The semiconductor diode which can be used in switching circuit in microwave range is, Options are ⇒ (A) PIN diode, (B) Varactor diode, (C) Tunnel diode, (D) Gunn diode, (E) , Leave your comments or Download question paper.

Question is ⇒ The semiconductor diode which can be used in switching circuit in microwave range is, Options are ⇒ (A) PIN diode, (B) Varactor diode, (C) Tunnel diode, (D) Gunn diode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The semiconductor diode which can be used in switching circuit in microwave range is
A.	PIN diode [Correct Answer]
B.	Varactor diode [Wrong Answer]
C.	Tunnel diode [Wrong Answer]
D.	Gunn diode [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The wavelength of light emitted by GaAs laser is 8670 x 10^-10 m. If h = 6.626 x 10^-34 Js, velocity of light = 3 x 10⁸ m/s and eV = 1.602 x 10^-19 J, the energy gap in GaAs is
0.18 eV
0.7 eV
1.43 eV
2.39 eV

⇒ In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
635 mA
735 mA
835 mA
935 mA

⇒ In thermal ohm's law, temperature and power loss are analogous to
V and I respectively of ohm's law
I and V respectively of ohm's law
R and V respectively of ohm's law
I and R respectively of ohm's law

⇒ Which of the following conversion is incorrect?
2048.0625 = 100000000000.0001₂
100000011.1001₂ = 131.5625₁₀
101101₂ = 45₈
Hexadecimal B6C₇ = 46791₁₀

⇒

Assertion (A): The maximum efficiency of a class B push pull amplifier is 78.5%

Reason (R): A current mirror uses a compensating diode in parallel with the emitter diode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The three sides of an admittance triangle denote
G, B, Y
R, X, Y
G, B, Z
(R, Y, Z) or (R, X, Z)

⇒ The function δ' (t-b) is
a step function originating at t = b
an impulse function originating at t = b
a unit doublet originating at = t - b
none of the above

⇒ The circuit shown in figure conv
BCD to binary code
binary to excess-3 code
excess-3 to Gray code
gray to binary code

⇒ If a short line is terminated in characteristic impedance it behaves as an infinite line.
TRUE
FALSE

⇒ Silicon is not suitable for fabrication of light emitting diodes because it is
an indirect band gap semiconductor
direct band gap semiconductor
wideband gap semiconductor
narrowband gap semiconductor

⇒ If the voltage across the last resistor is V, and all the resistor is unity. Then V_s is give
8 V
4 V
13 V
0

⇒ Which one of the following is transferred locking electron device C antenna?
BARITT diode
IMPATT diode
Gunn diode
Step recovery diode

⇒ Addition of a small amount of antimony to germanium will result in
formation of P-type semiconductor
more free electrons than holes in the semiconductor
antimony concentrating on the edges of the crystals
increased resistance

⇒ In radio receivers, the value of IF is
100 kHz
225 kHz
455 kHz
850 kHz

⇒ Bit is
smallest piece of electronic hardware
a drilling tool
an abbreviation for binary digit
the smallest number

⇒ Given a power supply filter circuit, what measurements must be made of determine percentage regulation
current through and voltage across the capacitor
d.c. load voltage and r.m.s. load voltage
current through load and voltage across load resistance
number of turns and gauge of secondary winding of transformer

⇒

Assertion (A): In high Q circuits poles of Y(s) lie close to ω axis in complex frequency plane.

Reason (R): Q is inversely proportional to damping factor.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output, frequency for the carrier will be
26 MHz
26.1 MHz
10 kHz
160 kHz

⇒ A permanent magnet moving coil measures
true rms value
dc value
peak value
rms plus dc value

⇒ In a JFET
drain current is very nearly equal to source current
drain current is much less than source current
drain current may be equal to or less than source current
drain current may be even more than source current

⇒ The most important set of specifications of transformer oil includes
dielectric strength and viscosity
dielectric strength and flash point
flash point and viscosity
dielectric strength, flash point and viscosity

⇒ If f(t) is in volts, then F(jω) is in
volts
volt seconds
volts/sec
volt-sec²

⇒ The power to the base unit of a cordless telephone is supplied by
battery
AC mains
both battery and AC mains
either battery or AC mains

⇒ The derating factor for a BJT transistor is about
0.5 mW/°C
2.5 mW/°C
10 mW/°C
25 mW/°C

⇒ A line has a phase constant of 29.8 rad/m. At 1000 MHz the wavelength is
29.8 m
2.98 m
2.1 m
0.21 m

⇒ A communication channel with additive white Gaussian noise, has a bandwidth of 4 kHz and an SNR of 15. Its channel capacity is
1.6 kbps
16 kbps
32 kbps
256 kbps

⇒ The resistance in the circuit of the moving coil of a dynamometer wattmeter should be
very low
low
high
almost zero

⇒ The timing difference between a slow memory and fast processor can be resolved if
processor is capable of waiting
external buffer is used
either (a) or (b)
neither (a) nor (b)

⇒ In a crystal
the frequencies of series and parallel resonance are equal
the frequency of series resonance is more than frequency of parallel resonance
the frequency of parallel resonance is more than frequency of series resonance
None of the above

⇒ The function f(x - v_ot) represent which of the following?
A stationary wave
A wave motion in forward direction
A wave motion in reverse direction
None of the above