Question is ⇒ In a BCD to 7 segment decoder the minimum and maximum number of outputs active at any time is, Options are ⇒ (A) 2 and 7, (B) 3 and 7, (C) 1 and 6, (D) 3 and 6, (E) , Leave your comments or Download question paper.

Question is ⇒ In a BCD to 7 segment decoder the minimum and maximum number of outputs active at any time is, Options are ⇒ (A) 2 and 7, (B) 3 and 7, (C) 1 and 6, (D) 3 and 6, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a BCD to 7 segment decoder the minimum and maximum number of outputs active at any time is
A.	2 and 7 [Correct Answer]
B.	3 and 7 [Wrong Answer]
C.	1 and 6 [Wrong Answer]
D.	3 and 6 [Wrong Answer]
View Answer 4 -6 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A microprocessor can understand instruction written in
machine language only
mnemonics operation codes only
high language only
both machine language and mnemonics operation codes

⇒ The conductivity of intrinsic semiconductor is given by
en_i(μ_p - μ_n)
en_i(μ_p + μ_n)
n_i(μ_p + μ_n)
n_i(μ_pμ_n)

⇒ Neutralization is used in RF amplifiers to
stop oscillation
increase bandwidth
improve selectivity
all of the above

⇒ L/C has the dimension of
time
capacitance
inductance
resistance

⇒ Current density has the dimensions
IL
IL^-2
IL^-3
I²L^-2

⇒ A padder is basically a/an
insulator
variable resistor
capacitor
inductor

⇒ Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)
39 - 28 μsec
2.28 μsec
0.228 μsec
39.28 μsec

⇒ Light dependent resistors are
highly doped semiconductor
intrinsic semiconductor
lightly doped semiconductor
either (a) or (c)

⇒ A duplexer is a device used to
feed more than one receiver from a single antenna
connect two transmitters to the same antenna
connect a receiver and a transmitter to the same antenna
none of these

⇒

Assertion (A): Light triggering is very suitable for HVDC transmission.

Reason (R): Light triggering has the advantage of complete electrical isolation of gate circuit.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The relation between thermionic emission current and temperature is known as
Richardson Dushman equation
Langmuir child law
Ohm's law
Boltzmann's law

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ The log magnitude curve of factor jω is a straight line having a slope of 20 dB/decade.
TRUE
FALSE

⇒ A clamper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ In a perfect conductor the incident and reflected wave combine to produce
a stronger incident wave
a stronger reflected wave
a standing wave which is not progressing
none of the above

⇒ A separately excited dc motor is run from a dc source through a chopper. At 600 rpm and rated torque, the duty cycle of chopper is 0.8. At 600 rpm and half the rated torque, the duty cycle is likely to be
0.9
0.8
0.75
0.6

⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days

⇒ A FET is a better clapper than a BJT because it has
lower off-set voltage
higher series ON resistance
lower input current
higher input impedance

⇒ A hertzian dipole has a radiation pattern with
a null in the direction of the dipole
a null in the plane perpendicular to the dipole
a peak in the direction of the dipole
none of the above

⇒ Most of the amplification of the received signal is obtained in a superheterodyne receiver from the
IF stage
RF stage
power amplification stage
none of the above

⇒ The PAM Signal can be detected by
Band pass filter
Band stop filter
High pass filter
Low pass filter

⇒ In forward active region, the operation of a BJT
both junctions are forward biased
both junctions are reverse biased
emitter base junction is forward biased and base collector junction is reverse biased
emitter base junction is reverse biased and base collector junction is reverse biased

⇒ For high frequency response of a transistor amplifier, suitable model to use is
Kelvin network
Lattice network
Hybrid p
T-network

⇒ An intrinsic silicon sample has 1 million free electrons at room temperature. As the temperature is increased
the number of free electrons increases
the number of free electrons increases but the number of holes decreases
the number of free electrons and holes increase by the same amount
the number of free electrons and holes increase but not by the same amount

⇒ A device that converts from decimal to binary numbered is called
decoder
encoder
CPU
converter

⇒ If reflection coefficient is 1/5, then corresponding VSWR is given by
1
2
3
42796

⇒ A series circuit has R = 5 Ω and C = 10 μF. It is switched on to a 12 V dc battery at t = 0. The current in the circuit will be maximum
at t = RC
at t = ∞
at t = 0⁺
none of the above

⇒

Assertion (A): If source and destination addresses are made implicit the length of instruction is reduced.

Reason (R): 8085 has only 3 addressing modes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following radio waves are not reflected by ionosphere?
Waves above 1 kHz
Waves above 1 MHz
Waves above 10 MHz
Waves above 30 MHz

⇒ While obtaining minimal SOP expression
all do not care terms are ignored
all do not care terms are treated as 1
all do not care terms are treated as 0
only such do not care terms which aid minimization are treated as 1