Question is ⇒ A stepper motor is, Options are ⇒ (A) a two phase induction motor, (B) is a kind of rotating amplifier, (C) is an electromagnetic transducer used to convert an angular position of shaft into electrical signal, (D) is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis, (E) , Leave your comments or Download question paper.

Question is ⇒ A stepper motor is, Options are ⇒ (A) a two phase induction motor, (B) is a kind of rotating amplifier, (C) is an electromagnetic transducer used to convert an angular position of shaft into electrical signal, (D) is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A stepper motor is
A.	a two phase induction motor [Wrong Answer]
B.	is a kind of rotating amplifier [Wrong Answer]
C.	is an electromagnetic transducer used to convert an angular position of shaft into electrical signal [Wrong Answer]
D.	is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis [Correct Answer]
View Answer 2 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When two ALU 1C 74181 are cascaded
the carry out of first stage is connected to carry in of second stage
the carry in of first stage connected to carry in of second stage
the carry in of first stage is connected to carry out of second stage
the carry out of first stage is connected to carry out of second stage

⇒ A p matching network for coupling the transmitter output of the antenna is shown in figu
minimum D.C. plate current
maximum D.C. plate current
maximum RF antenna current
specified value of the D.C. plate current

⇒ Consider the following expressions in J
42, 40, 42 respectively
42, 42, 42 respectively
40, 42, 42 respectively
40, 40, 42 respectively

⇒ If the ladder reference voltage is 2 V, then minimum comparator resolution required is
0.125 V
1.25 V
12.5 V
0

⇒ The typical squelch circuit
cuts off IF amplifier when AGC is minimum
cuts off IF amplifier when AGC is maximum
cuts off audio amplifier when carrier is absent
eliminates RF interference when signal is weak

⇒ In body centred cubic structure, comers and centre of the cube are occupied by identical atoms.
TRUE
FALSE

⇒ The angular location of poles depends on
undamped natural frequency
damping ratio
both (a) and (b)
neither (a) nor (b)

⇒ The response to sinusoidal excitation can be found by
settings s = jω in the network function
settings s = - jω in the network function
taking inverse transform of network function
none of the above

⇒ The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6
1.2 kΩ
80 Ω
50 W
0

⇒

Match the following:

	List I		List II
A.	Horn antenna	1.	High directivity
B.	Parabolic antenna	2.	Very high directivity
C.	Lens antenna	3.	Moderate directivity

A-1, B-2, C-3
A-3, B-2, C-1
A-3, B-1, C-2
A-1, B-3, C-2

⇒

Match the following:

	List I (Logic family)		List II (Characteristic of logic family)
A.	TTL	1.	Maximum power Consumption
B.	ECL	2.	Highest Packing Density
C.	NMOS	3.	Least Power Consumption
D.	CMOS	4.	Saturated Logic

A-1, B-4, C-2, D-3
A-1, B-4, C-3, D-2
A-4, B-1, C-2, D-3
A-4, B-1, C-3, D-2

⇒ Which power amplifier can deliver maximum load power?
Class A
Class AB
Class B
Class C

⇒ In figure V is ideal voltmeter having infinite resistance. It will read __________ v
40
60
0
100

⇒ A material for permanent magnet should have
High retentivity
High permeability
Low hysteresis loss
High hysteresis loss

⇒ The minimum value of h_fe of a transistor used in RC phase shift oscillator is
54.4
45.4
44.5
29

⇒ ICs are
analog
digital
both analog and digital
mostly analog

⇒ The ratio of impurity atoms to intrinsic semiconductor atoms in an extrinsic semiconductor is about.
0.0486111111111111
0.736111111111111
1 : 100000
1 : 10⁸

⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about
50 mV
60 mV
66 mV
80 mV

⇒

Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In INHIBIT operation
output is 1 when both inputs are 0
output is 0 when blocking input is 1
output is 0 when blocking input is 0
output is 1 when blocking input is either 0 or 1

⇒

Assertion (A): An op-amp amplifier can amplify dc signal

Reason (R): An op-amp amplifier is a direct coupled amplifier

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): In a power divider S_H = 0, S₂₁ = 0.707 = S₃,

Reason (R): In a power divider the input port (i.e., port 1) is matched and incident power is equally divided in output ports 2 and 3

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Astable multivibrator has
one stable state
two stable state
two quasi-stable states
one quasi stable state

⇒ In the fabrication of n-p-n transistor in an IC, the buried layer on the P-type substrate is
P⁺ -doped
n⁺ -doped
used to reduce the parasitic capacitance
located in the emitter region

⇒ The circuit of figur
clipper, sine wave clipped at - 2 V
clamper
clamper, sine wave clamped at zero V
clipper, sine wave clipped at + 2 V

⇒

Assertion (A): In drawing an electric circuit analogous to a mechanical circuit, spring is replaced by capacitance.

Reason (R): The behaviour of a spring and capacitor are similar.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The root locus branches
start from open loop poles and terminate at zeros
start from open loop zeros and terminate at poles
may start from pole or zero and terminate at another pole or zero
none of the above

⇒ A divide by 78 counters can be realized by using
six mod-13 counters
thirteen mod-6 counters
one mod 13 counter followed by one mod-6 counter
thirteen mod-13 counters

⇒

Assertion (A): Synchronous counter has higher speed of operation than ripple counter

Reason (R): Synchronous counter uses high speed flip flops.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In energy band diagram of p type semiconductor the acceptor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band