Question is ⇒ In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 4, (E) , Leave your comments or Download question paper.

Question is ⇒ In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are
A.	1 [Wrong Answer]
B.	2 [Correct Answer]
C.	3 [Wrong Answer]
D.	4 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The minimum sampling rate is :
62831.9 V/sec
125663.8 V/sec
31415.95 V/sec
None

⇒ Consider the following in C 4.2 and 300
4 and 300 respectively
4.2 and 300.00 respectively
4 and 300.00 respectively

⇒ The factors which govern fan out of CMOS gates are
maximum permissible propagation delay
input capacitance of each load
both (a) and (b)
neither (a) nor (b)

⇒ When a voltage is applied to a semiconductor crystal then the free electrons will flow.
towards positive terminal
towards negative terminal
either towards positive terminal or negative terminal
towards positive terminal for 1 μs and towards negative terminal for next 1 μs

⇒ A cycloconverter can be
step down
step up
step down or step up
none of the above

⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111

⇒ In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be
at the centre of ac load line
at the centre of dc load line
at the centre of collector voltage
at the centre of collector current

⇒

Assertion (A): The turn on time of SCR is about 1 to 4 ms.

Reason (R): The turn off time of SCR is about 10 to 300 ms.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a coaxial line
the characteristic impedance is less than that of two wire line
the wave velocity is less than that of two wire line
both (a) and (b)
neither (a) nor (b)

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒ Read cycle is always followed by (during instructions execution)
read cycle
write cycle
delete signal
none of these

⇒ The method used to transfer data from I/O units to memory by suspending the memory-CPU data transfer for one memory cycle is called
I/O spooling
Cycle stealing
Line conditioning
Demand paging

⇒ Figure repres
Integrator
Differentiator
High Pass Filter
Band Pass Filter

⇒ In a 4 bit full adder how many half adders and OR gates are required
8 and 4
7 and 4
7 and 3
8 and 3

⇒ If A = 7 ∠15, A² is
49 ∠225°
49 ∠30°
49 ∠15°
49 ∠7.5°

⇒ If low pressure of 10^-6 mm of Hg is required to be measured, we should use
compound pressure gauge
thermocouple vacuum gauge
Pirani gauge
ionization type vacuum gauge

⇒ A first order element yields almost exact duplication only for constant or slowly varying phenomenon.
TRUE
FALSE

⇒ What does the operator ( ) mean in C?
Function expression
Array expression
Structure operator
Increment / Decrement

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ In a vacuum tube, the transit time of electron between cathode and anode is important at
low frequencies
high frequencies
both (a) and (b)
frequencies which are neither very low nor very high

⇒ The function of blend control in stereo system is
to dilute left channel
to dilute right channel
to dilute any of the channels
none of the above

⇒ Which of them has 10 inputs and 4 outputs?
Decimal to BCD encoder
BCD to decimal decoder
Octal to binary encoder
All encoders

⇒ In CE amplifier
input and output are in phase
phase difference between input and output is 30° to 90°
phase difference between input and output is 60° to 120°
output is inverted with respect to its input voltage

⇒ As regards BCH code, Hamming code and Reed-Solomon code
BCH and Hamming code are special cases of Reed-Solomon code
Reed-Solomon and Hamming code are special cases of BCH code
BCH and Reed-Solomon code are special case of Hamming code
none of the above

⇒ Consider the following expressions which indicate the step or impulse response of an initially relaxed system

[5 - 4 e^-2t] u(t)
[e^-2t + 5] u(t)
d(t) + 8 e^-2t u(t)
d(t) + 4 e^-2t u(t)

Those which correspond to the step and impulse response of the same system include
1 and 3
1 and 4
2 and 4
2 and 3

⇒ Under low level injection assumption, the infected minority carrier current for an extrinsic semiconductor is essentially the
diffusion current
drift current
recombination current
induced current

⇒ Consider the following stateme
1 and 2
1 and 3
2 and 3
3 only

⇒ Two resistance R₁ and R₂ are connected in series R₁ = 528 ± 5 Ω and R₂ = 325 ± 3Ω. The total resistance will be
853 ± 2 Ω
853 ± 5 Ω
853 ± 3 Ω
853 ± 8 Ω

⇒ A series resonant circuit has inductance L. If L is increased, the resonant frequency
increases
decreases
remains constant
may increases or decreases

⇒

Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.

Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong