Question is ⇒ If the inputs to a 2 input XOR gate are high then, the output is high., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ If the inputs to a 2 input XOR gate are high then, the output is high., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If the inputs to a 2 input XOR gate are high then, the output is high.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a 3 phase full converter feeding a highly inductive load, the average load current is 150 A. The peak current through thyristor is
150 A
75 A
50 A
300 A

⇒ Which of the following conditions must be satisfied for a transistor to remain under saturation?

Its collector to base junction should be under forward bias.
Its collector to base junction should be under reverse bias.
Its emitter to base junction should be under reverse bias.
Its emitter to base junction should be under forward bias.

Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
1 and 4

⇒ x = AX + Bu is a state equation.
TRUE
FALSE

⇒ The inverse Laplace transform of 1/(s - a)² is
e^at
t e^at
t² e^at
e^at/t

⇒ Insulation resistance of a cable is directly proportional to its length.
TRUE
FALSE

⇒ Which one of the following is used to change data from spatial code to temporal code?
Shift register
Counter
A/D converters
Combinational circuits

⇒ A hertzian dipole has a radiation pattern with
a null in the direction of the dipole
a null in the plane perpendicular to the dipole
a peak in the direction of the dipole
none of the above

⇒ The difference between resonant commutation and self commutation is
both these methods are based on entirely different principles
in resonant commutation, the commutating elements carry load current but in self commutation, the commutating elements do not carry load current
resonant commutation uses L and C but self commutation uses only capacitor
none of the above

⇒ In figure (A) and
A represents PCM and B represents AM
A represents FM and B represents AM
A represents AM and B represents FM
A represents PCM and B represents FM

⇒ For a low level AM system, the amplifiers modulated stage must be
linear devices
harmonic devices
class C amplifiers
non-linear devices

⇒

Assertion (A): When light falls at junction of p-n photodiode, its p side becomes positive and n side becomes negative.

Reason (R): When a photodiode is short circuited, the current in the external circuit flows from p side to n side.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A voltage wave containing 10% third harmonic is applied to a scries R-L circuit. The percentage third harmonic content in the current wave will be
more than 10%
10% or less than 10%
less than 10%
10% or more or less

⇒ Single parity check is not reliable in case of
paper tape
magnetic tape
magnetic drum
cores

⇒ A voltmeter using thermocouples measures
rms value
peak value
average value
peak to peak value

⇒ Consider the following applications

Switch
Attenuator
Phase shifter
Oscillator

In which of the above can a PIN diode be used?
1 2 3 and 4
1 2 and 3 only
1 and 2 only
2, 3 and 4 only

⇒ The four types of integers in Java are called
byte, short, int and long
bit, byte, short and long
nibble, byte, short and long
nibble, byte, int and long

⇒ The effect of lead resistance is important in measurement of
resistance of shunt
resistance of shunt winding
resistance of ammeter
both (a) and (c)

⇒ If φ_sh is flux of shunt magnet, φ_se is flux of series magnet, i_sh is eddy current due to φ_se, the torque in an induction wattmeter is proportional to
φ_se i_se + φ_sh i_sh
φ_sh i_se - φ_se i_sh
φ_sh i_sh - φ_se i_se
φ_sh i_sh + φ_se i_se

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in backward direction. A moving coil ammeter is also connected in the circuit. The reading of ammeter will be
0.416666666666667
0.208333333333333
3.185 A
14.14 A

⇒ If the open-loop transfer function is a ratio of a numerator polynomial of degree 'm' and a denominator polynomial of degree 'n', then the integer (n - m) represents the number of:
breakaway points
unstable poles
separate root loci
asymptotes

⇒ In case of photo conductor for germanium when forbidden energy gap is 0.72 eV, the critical wavelength for intrinsic excitation will be
1.43 m
1.43 mm
1.73 mm
1.73 x 10¹² m

⇒ The function Y = AC + BD + EF is
POS
SOP
Hybrid
none of the above

⇒ The derating factor for a BJT transistor is about
0.5 mW/°C
2.5 mW/°C
10 mW/°C
25 mW/°C

⇒ Reflex klystron oscillator is essentially a low power device
TRUE
FALSE

⇒ An antenna has a gain of 44 dB. Assuming that the main beam of the antenna is circular in cross-section the beamwidth will be
0.4456°
1.4456°
2.4456°
3.4456°

⇒ The duration of sunspot cycle is
1 year
11 years
55 years
100 years

⇒ Which of the following uses a capacitor in the feedback path?
Active low pass filter
Active high pass filter
Both (a) or (b)
Neither (a) nor (b)

⇒ A transistor has

collector
emitter
base

In a N-P-N transistor the electron flow into the transistor at
I only
II only
II and III only
I and II only

⇒ A radio station works at 800 kHz and uses AM. If this is a public broadcast system, it should transmit using
parabolic reflector to transmit all round
turnstile antenna for the required land
half wave long horizontal wave
a vertical antenna less than quarter for practical reasons

⇒ Intrinsic concentration of charge carriers in a semiconductor varies as
T
T²
T³
T^-2