Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | The minority carrier life time and diffusion constant in a semiconducting material are 100 μs and 100 cm^{2}/s respectively. The diffusion length of carriers is |

A. | 0.1 cm [Correct Answer] |

B. | 0.01 cm [Wrong Answer] |

C. | 0.0141 cm [Wrong Answer] |

D. | 1 cm [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒

**Assertion (A):** A high *dv*/*dt* may cause triggering of a thyristor.

**Reason (R):** A high *dv*/*dt* results in charging current in the thyristor.

Both A and R are correct and R is correct explanation of A

Both A and R correct but R is not correct explanation of A

A is correct but R is wrong

A is wrong but R is correct

⇒ In figure The minimum and maximum load currents

0 and 60 mA

0 and 120 mA

10 mA and 60 mA

10 mA and 120 mA

⇒ In VHS format each video head is tilted from azimuth by

20°

10°

6°

1°

⇒ In a four variable Karnaugh map, eight adjacent cells give a

two variable term

single variable term

three variable term

four variable term

⇒ Which statement out of the following statement is wrong?

Attenuation of satellite signals by rain and fog varies almost inversely with the angle of elevation

At 12/4, GHz link frequencies, signal power loss due to rain and fog is much greater than at 4/6 GHz frequencies

The distance between satellite and Earth station varies slightly with angle of elevation

At present 4/6 GHz geostationary satellites are being parked in geosynchronous, orbits at least 10° apart

⇒ The impulse response

*h*(

*t*) of a linear time-invariant continuous time system is described by

*h*(

*t*) = exp (a

*t*)

*u*(

*t*) + exp (β

*t*)

*u*(-

*t*), where

*u*(

*t*) denotes the unit step function, and a and β are constants. This system is stable if

a is positive and β is positive

a is negative and β is negative

a is positive and β is negative

a is negative and β is positive

⇒ Whenever a JFET operates above pinch-off voltage

depletion regions become smaller

drain current increase steeply

drain current starts decreasing

drain current remains nearly constant

⇒ The direction of vectors gives the direction of propagation of electromagnetic waves

Vector (E x H)

Vector (F x H)

Vector E

Vector H

⇒ What will be maximum input that can be converted for a 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).

9 V

9.45

10 V

8 V

⇒ In the FM wave described by equation

*v*= 15 sin (4 x 10

^{8}

*t*+ 3 sin 1100

*t*), the maximum frequency deviation is

175 Hz

525 Hz

3 Hz

58.33 Hz

⇒ Impedance level of Impatt diodes is generally lower than that of Gunn diodes

TRUE

FALSE

⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.

55.56 and 44.44 A respectively

44.44 A and 55.56 A respectively

60 A and 40 A respectively

40 A and 60 A respectively

⇒ Antenna beamwidth is

measure of directivity

measure of angle

measure of radiation pattern

measure of power pattern

⇒ In FORTRAN 77 IFIX (-73.2) gives the value

73

-73

-7

-73.2

⇒ A network is causal if impulse response is zero for

*t*< 0.

TRUE

FALSE

⇒ In figure readings of the two voltmeters shoul

100 V on each meter

200 V on each meter

150 V on V

_{1}and 50 V on V

_{2}

50 V on V

_{1}and 150 V on V

_{2}

⇒ A pulse stretcher is same as a

free running multivibrator

bistable multivibrator

monostable multivibrator

latch

⇒ A full adder is to be implemented using half adders and OR gates. A 4 bit parallel adder without any initial carry requires

8 half adders and 4 OR gates

8 half adders and 3 OR gates

7 half adders and 3 OR gates

7 half adders and 4 OR gates

⇒ The dynamic equalising circuit consists of a series combination of capacitor C and resistor R

_{C}across each thyristor. This resistance R

_{C}(along with parallel connected diode)

limits charging current

limits discharging current

limits both charging and discharging currents

none of the above

⇒ 1101

_{2}- 1001

_{2}=

1000

100

10

1

⇒ Almost all resistors are made in a monolithic integrated circuit

during the entire diffusion

while growing the epitaxial layer

during the base diffusion

during the collector diffusion

⇒ What is the purpose of a start in RS232 serial communication protocol?

To synchronise receiver for receiving every byte

To synchronise receiver for receiving a sequence of byte

Acts as a parity bit

To synchronise receiver for receiving the last byte

⇒ Secondary emission results

when temperature of metals is raised to a level above the crystallization temperature

when metals are subjected to strong magnetic fields

when light rays fall on the metal surface

when a high velocity beam of electrons strikes as metal surface

⇒ Which of the following directives in 8085 causes one byte to be reserved in the memory?

D S

D B

D W

E Q U

⇒ The contents of stack location after the call operation wil

111

1110

1010

1111

⇒ If a signal

*g*(

*t*) has energy E, then the energy of the signal

*g*(2

*t*) is equal to ...

E/2

E/4

*E*

2E

⇒ A buffer amplifier should have

high output impedance and high input impedance

high output impedance and low input impedance

low output impedance an low input impedance

low output impedance and high input impedance

⇒ In the figure shows the circuits symbo

FET

PMOSFET

CMOSFET

NMOSFET

⇒ A coil has resistance R and inductance L. At ω = ∞ the phase angle between voltage and current is

0°

180°

45°

90°

⇒ As the frequency is increased, the charging MVAR in a cable

decreases

increases

remain the same

decreases or remains the scheme