Question is ⇒ Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is correct but R is wrong, (D) R is correct but A is wrong, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is correct but R is wrong, (D) R is correct but A is wrong, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls. Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes.
A.	Both A and R are correct and R is correct explanation of A [Correct Answer]
B.	Both A and R are correct but R is not correct explanation of A [Wrong Answer]
C.	A is correct but R is wrong [Wrong Answer]
D.	R is correct but A is wrong [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A communication receiver is
TRF receiver
a superheterodyne receiver
either (a) or (b)
neither (a) nor (b)

⇒ A 0-200 V voltmeter has a sensitivity of 1 kΩ per volt. The resistance of voltmeter is
1 kΩ
200 kΩ
100 kΩ
50 kΩ

⇒ Which of the following is not a general purpose peripheral?
I/O port
Programmable interrupt controller
Programmable CRT controller
Programmable interval timer

⇒ In the following non-planar graph no.of independent loop equations
8
12
7
5

⇒ In terms of signum function sgn(t), unit step function u(t) =
1 + sgn(t)
1 - sgn(t)
0.5 + 0.5 sgn(t)
0.5 - 0.5 sgn(t)

⇒ In one of the codes for transfer of numbers the code for the succeeding number differs from that of the number only in the change of a single digit. The code is
ASCII
Excess 3 CODE
Gray CODE
none of these

⇒ In the circuit shown, all the transmission line sections are lossless. The Voltage Standing Wave Ration (VSWR) on the 60W lin
1
1.64
2.5
3

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and carry (CY) contain after ORA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ 'Rotate instruction' in microprocessor belongs to
data transfer group
arithmetic group
logic group
branch group

⇒ A receiver having poor IF selectivity will also have poor
sensitivity
double spotting
blocking
all of the above

⇒ A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be
0.6 Ω
0.06 Ω
0.1 Ω
0.004 Ω

⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above

⇒ The measurement of Hall coefficient of a semiconductor with one type of charge carriers gives the information about
sign of charge carrier
density of charge carrier
both sign and density of charge carrier
none of the above

⇒ The velocity factor of a transmission line
mainly depends on the skin effect
is always higher for a solid dielectric than for air
mainly depends on the dielectric constant of the material used
increases the velocity along the transmission line

⇒ Which of the following is not a classification of programmed data transfer?
Synchronous transfer
Hand shaking
Interrupt driver transfer
Direct transfer

⇒ A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to
matched load, antenna, receiver and CW transmitter
CW transmitter, antenna, receiver and matched load
CW transmitter, receiver, antenna and matched load
CW transmitter, matched load, receiver and antenna

⇒ The output impedance of an ideal op-amp is
zero
low
high
infinite

⇒ How many interrupts are there of 8085 μP?
4
5
6
8

⇒ The resistance of a dc galvanometer is 20 Ω. A current of 10 mA causes full scale deflection. To convert it into 0-300 V voltmeter, we have to use a series resistance of
30000 Ω
29980 Ω
6000 Ω
15 Ω

⇒ Which of the following is best excited from a waveguide?
Discone
Helical
Biconical
Horn

⇒ Consider the following

Generation of SSB signals
Design of minimum phase type filters
Representation of band pass signals

Which of the above applications is Hilbert transform used?
1 only
1, 2 and 3
1, 2 only
1 and 3

⇒ In a conductor the current flow is due to
holes
electrons
ions
electrons and ions

⇒ An antenna array pattern is to used for increasing
gain
directivity
directive gain
all

⇒ ECL can be used to high frequencies in the order of
500 kHz
1 MHz
100 MHz
500 MHz

⇒ Which TM mode in rectangular waveguide has lowest cutoff frequency?
TM₁₁
TM₀₁
TM₁₀
TM₂₁

⇒ Which of the following microphones has maximum distortion?
Ribbon
Condenser
Crystal
Carbon

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. The frequencies present in the output will be
998 kHz and 1002 kHz
998 kHz, 999.2 kHz, 1000.8 kHz, 1002.0 kHz
998 kHz, 999.2 kHz, 999.7 kHz, 1000.3 kHz, 1000.8 kHz and 1000.2 kHz
none of the above

⇒ The primary function of lag compensator is to provide sufficient
gain margin
phase margin
both gain margin and phase margin
either (a) or (b)

⇒ In a JK Master slave flip flop
both master and slave are positively clocked
both master and slave are negatively clocked
master is positively clocked and slave is negatively clocked
master is negatively clocked and slave is positively clocked

⇒ Bandwidth will be
a.b
a + b
a
b