Question is ⇒ which of the following is not correct?, Options are ⇒ (A) P(A) = P(A) - 1, (B) 0 ≤ P ≤ 1, (C) If A and B are mitual exclusive then P(A + B) = P(A) + P(B), (D) P(A) = 1 - P(A), (E) , Leave your comments or Download question paper.

Question is ⇒ which of the following is not correct?, Options are ⇒ (A) P(A) = P(A) - 1, (B) 0 ≤ P ≤ 1, (C) If A and B are mitual exclusive then P(A + B) = P(A) + P(B), (D) P(A) = 1 - P(A), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	which of the following is not correct?
A.	P(A) = P(A) - 1 [Correct Answer]
B.	0 ≤ P ≤ 1 [Wrong Answer]
C.	If A and B are mitual exclusive then P(A + B) = P(A) + P(B) [Wrong Answer]
D.	P(A) = 1 - P(A) [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following materials has the highest electrical conductivity?
Steel
Silver
Aluminium
Zinc

⇒ Which of these are allowed in Basic?
Arithmetic operators +, -, *, / etc.
Logical operators AND, OR, NOT
Relational operators =, <, > etc.
All of the above

⇒ In using Nyquist stability criterion it is not necessary to determine closed loop poles.
TRUE
FALSE

⇒ If a piece of wood is placed in a magnetic field
the magnetic field will not be affected
the magnetic lines of force will bend towards the piece
the magnetic lines of force will bend away from the piece
the flux may increase or decrease

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	Reflex Klystron	1.	Wideband amplification
B.	TWT	2.	Very low power amplification
C.	Cavity Klystron	3.	Low power FM generation
D.	Maser	4.	Frequency multiplication

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-4, D-2

⇒ The expression Y = pM (0, 1, 3, 4) is
POS
SOP
Hybrid
none of the above

⇒ Which of the follow
Voltage series feedback and decrease I/P impedance.
Voltage shunt feedback and decrease I/P impedance.
Voltage series feedback and increase I/P impedance.
Voltage shunt feedback and increase I/P impedance.

⇒ In the given figure power meters at A and B indicate 1 mW and 110 μW respectively. VSWR of lin
1.5
2
2.5
3

⇒ The number of spectral component when two sine wave of same frequency multiplied is
2
3
∞
4

⇒ In FM reception, amplitude disturbances due to static change
reduce the signal frequencies
increase the signal frequencies
disturb the signal frequencies
do not affect the signal frequencies

⇒ How many different binary numbers can be stored in a register consisting of six switches?
16
32
64
128

⇒ The pole-zero configuration of the given figure can be
lag compensator
lead compensator
lead-lag compensator
series compensator

⇒ A digital clock uses __________ chip
SSI
LSI
VLSI
MSI

⇒ For the control system in the given figure, the value of K for critical dampin
1
5.125
6.831
10

⇒ The normal operation of JFET is
constant voltage region
constant current region
both constant voltage and constant current regions
either constant voltage or constant current region

⇒ A 10 μF capacitor is charged from a 5 volt source through a resistance of 10 kΩ. The charging current offer 35 m sec. If the initial voltage on C is - 3 V is
0.56 mA
5.6 mA
6 mA
5 μA

⇒ In Schering bridge, the potential of detector above earth potential is about
a few volts
10 kV
1000 V
either (a) or (b)

⇒ Decimal number 5436 when converted into 9's complement will become
4356
4653
4563
4655

⇒ Maxwell's divergence equation for the magnetic field is given as
∇ . B = 0
∇² . B = 0
∇ . B = constant
∇² . B = constant

⇒ Figure shows an 8-bit LED display. A light circle means that a LED is ON (binary 1) and a dark circle means a LED is OFF (binary 0). What is the decimal equivalent of the binary number displa
100
121
144
172

⇒ The value of the inductance of coil in which a current increases linearly from zero to 0.1A in 0.2 second producing a voltage of 5 volts is __________ .
2.5
5
10
20

⇒ In which frequency range is the noise figure in a transistor independent of frequency
intermediate frequencies
high frequency
low frequencies
both low and high frequencies

⇒ Which of the following statement about the photo electric emission is incorrect?
The maximum velocity of emission varies with the frequency of incident light
The maximum velocity of emission varies with the intensity of light
The amount of photoelectric emission is directly proportional to the intensity of light
The quantum yield depends on the frequency and not the intensity of incident light

⇒ Emitter follower is in which of following configuration.
common Base
common Emitter
common collector
common Base or common Emitter

⇒ The number of valence electrons in silicon atom is
4
2
1
zero

⇒ VSB modulation is preferred in TV because
it reduces the bandwidth requirement to half
it avoids phase distortion at low frequencies
it results in better reception
none of the above

⇒ For a 16 bit computer the range of integer constants in C is
-32768 to + 32767
-32767 to + 32768
-65536 to + 65535
-65535 to + 65536

⇒ Which one the following is an advantage of AM over FM?
FM has wide bandwidth
FM has better
FM is more immune to noise
Probability of noise spike generation is less in AM

⇒ Figure shows a Wheatstone bridge with RTD to one arm. If resistance of RTD = 1020 Ω, the voltage V₀
49 mV
51 mV
48 mV
45 mV

⇒ Which of the following array names in Fortran 77 is invalid?
A(6)
A(R)
A(I)
A(N)