Question is ⇒ An RC series circuit is charged by a voltage E. After a long time the battery is removed and a short circuit is placed across R-C. Then, Options are ⇒ (A) the polarity of voltage across R is same during discharge and during charge, (B) the polarity of voltage across R during discharging is opposite to that during charging, (C) the polarity of voltage across R depends on time constant RC, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ An RC series circuit is charged by a voltage E. After a long time the battery is removed and a short circuit is placed across R-C. Then, Options are ⇒ (A) the polarity of voltage across R is same during discharge and during charge, (B) the polarity of voltage across R during discharging is opposite to that during charging, (C) the polarity of voltage across R depends on time constant RC, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An RC series circuit is charged by a voltage E. After a long time the battery is removed and a short circuit is placed across R-C. Then
A.	the polarity of voltage across R is same during discharge and during charge [Wrong Answer]
B.	the polarity of voltage across R during discharging is opposite to that during charging [Correct Answer]
C.	the polarity of voltage across R depends on time constant RC [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which is the dominant mode in rectangular waveguides?
TE₁₀
TE₁₁
TE₀₁
TM₁₁

⇒ Gold is often diffused into silicon PN junction devices to
increase the recombination rate
reduce the recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ Phase modulation is commonly-used for data transmission mainly because
phase can be varied from + 180° to 180°
it is resistant to the effects of noise
demodulation is very easy
it gives highest data rates that can be transmitted over a given channel

⇒ If a and b are the dimensions of waveguide then
a = 3b
a = 2b
a = b
a = b/4

⇒ For the circuit of the following figure, with an ideal op-amp, the maximum phase shift of the output with reference to the input
0°
90°
-90°
± 180°

⇒ Mesh analysis is applicable __________ only.
planar network
non planar network
a circuit which contains only current sources
none

⇒

Match the following:

	List I		List II
A.	Poles and zeros of lie an real axis driving point LC network	1.	lie an real axis
B.	Canonic LC network has	2.	a zero
C.	The number of Canonic networks for the given driving point function	3.	minimum number of elements
D.	The first critical frequency nearest the origin for RL driving point impedance	4.	four
		5.	minimum number of elements
		6.	alternate
		7.	either a pole or zero
		8.	three

A-1, B-5, C-8, D-7
A-6, B-5, C-3, D-2
A-1, B-5, C-4, D-2
A-1, B-3, C-4, D-7

⇒ A Darlington pair has β = 300. If R_E = 1 kΩ and R_L = 100 Ω, the input impedance at the base is approximately
300 k ohm
3 k ohm
100 k ohm
30 k ohm

⇒ If a small amount of Cu is added to Ni conductor, then
resistivity of Ni will decrease at all temperatures because Cu is a better conductor than Ni
residual resistivity of Ni at low temperature will increase as Cu atoms act as defect centres
resistivity of Ni will increase at all temperatures as Cu destroys the periodicity of Ni and acts as defects
resistivity of Ni remains the same

⇒ Strip lines are used at
microwave frequency
low frequency
High frequency
at any frequency

⇒ A string of series connected thyristors needs equalising circuit to
ensure proper firing
ensure proper current division
ensure proper voltage division
none of the above

⇒

Assertion (A): An impulse has very high magnitude but very small duration.

Reason (R): A pulse function is always rectangular.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following can provide two or more voice circuits with the same carrier?
SSB
Carrier reinsertion
Lincompex
Independent side band system

⇒ If e = 10 cos (2p x 10⁸t + 20 cos 2p 10³t). The bandwidth is
10⁸ Hz
42 kHz
21 kHz
10⁸ ± 10³ Hz

⇒ Typical switching time for ECL is
5 nano seconds
5 micro seconds
5 milli seconds
5 seconds

⇒ In C the keywords are also called
special words
reserved words
class words
character words

⇒ A 3 phase series inverter has
12 thyristors
6 thyristors
3 thyristors
3 or 6 thyristors

⇒ Hydrogen is used in
large size transformers
MCB
large size generators
circuit breakers

⇒ A mode-10 counter can divide the clock frequency by a factor of
10
100
1000
10000

⇒ If f(t) = - f(- t) satisfies Drichlet conditions, then f(t) can be expanded in Fourier series containing
only sine terms
only cosine terms
cosine terms and constant
sine terms and constant

⇒ In ionosphere incidence angle is 60°. The maximum usable frequency f_m is equal to
2f_c
f_c
0.5 f_c
3 f_c

⇒ In the design of a single mode step index optical fiber close to upper cut-off, the single mode operations is NOT preserved if
radius as well as operating wavelength are halved
radius as well as operating wavelength are doubled
radius is halved and operating wavelength is doubled
radius is doubled and operating wavelength is halved

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒ In a CRO, the frequency of output of time base generator
is only one constant value
is adjustable
varies automatically
either (a) or (c)

⇒ A depletion type NMOS is operated in enhancement mode. V_p = - 4 volts. For V_GS = + 3 volts as V_DS is increased, I_D becomes nearly constant when V_ps equals
1 volt
3 volts
4 volt
7 volts

⇒ As compared to a BJT amplifier circuit, a JFET amplifier circuit
has low input impedance
has high input impedance
has very low input impedance
may have either low or high input impedance

⇒

Assertion (A): The phase angle plot in Bode diagram is not affected by change in system gain.

Reason (R): The variation in gain has no effect on phase margin of the system.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In the forward blocking region of a silicon, controlled rectifier, the SCR is
in the off-state
in the ON state
reverse biased
at the point of breakdown

⇒ Orbital disturbances of a geosynchronous satellite are caused by the
moon
sun
earth
all of the above

⇒ In a BCD to 7 segment decoder the minimum and maximum number of outputs active at any time is
2 and 7
3 and 7
1 and 6
3 and 6