Question is ⇒ If fs be the signal frequency and fi be the intermediate frequency then image frequency is given by, Options are ⇒ (A) fs + fi, (B) fs ± fi, (C) fs ± 2fi, (D) fs + 2fi, (E) , Leave your comments or Download question paper.

Question is ⇒ If fs be the signal frequency and fi be the intermediate frequency then image frequency is given by, Options are ⇒ (A) fs + fi, (B) fs ± fi, (C) fs ± 2fi, (D) fs + 2fi, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If f_s be the signal frequency and f_i be the intermediate frequency then image frequency is given by
A.	f_s + f_i [Wrong Answer]
B.	f_s ± f_i [Wrong Answer]
C.	f_s ± 2f_i [Wrong Answer]
D.	f_s + 2f_i [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the diode circuit shown in figure the diodes are ideal. The impedance seen by source is
1 k ohm
2 k ohm
0.5 k ohm
infinite

⇒ At high frequencies the output circuit of transistor amplifier reduces to
a lead network
a lag network
either (a) or (b)
neither (a) nor (b)

⇒

Assertion (A): In CE connection of n-p-n transistor. V_CE is positive.

Reason (R): In BJT, the base collector junction is reverse biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The circuit shown depic
voltage series negative feedback
voltage shunt negative feedback
current series negative feedback
current shunt negative feedback

⇒ When analysing two port networks in cascade, it is more convenient to use
z parameters
h parameters
T parameters
y parameters

⇒ The boolean expression for shaded area in the given figur
AB + AC
ABC + ABC
ABC + ABC
None of these

⇒ The static electric field in a conductor is
zero
unity
infinity
none of the above

⇒ V(t) across R₂ for t > 0 is given
2 - 2e^-2t
2 - e^-2t
2 - e^-t
1 - e^-t

⇒

Assertion (A): Integral control action is sometimes called reset control.

Reason (R): Reset rate is expressed as number of repeats per unit time.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A discrete zero memory information source has 40 symbols and each symbol is equally likely. The minimum number of bits required to code the source with uniform length code and entropy of the source are
5 and 5.03
6 and 5.83
5 and 6.64
6 and 5.32

⇒ In figure the collector to emitter breakdown voltage of the transistor (βV_CEO) shoul
more than V_CC
more than 0.5 V_CC
more than V_CC + E
more than 2 V_CC

⇒ Which of the following factors are responsible to design IC logic gates to operated at a fixed supply voltage of 5 volts?

Low heating of IC logic gates
Compatibility with other logic gates
Satisfactory and safe operation
Standardization from IC manufacturing point of view.

Select the correct answer from the codes given below:
1 only
2 only
2 and 3
3 and 4

⇒ A padder is basically a/an
insulator
variable resistor
capacitor
inductor

⇒ An SCR is triggered at 80° in the positive half cycle, only. The rms anode current is 25 A. If the firing angle is changed to 160°, the rms current is likely to be
25 A
12.5 A
less than 25 A
less than 12.5 A

⇒ For broadcasting purpose, full AM signal is preferred to SSB signal because
it requires large bandwidth
generation of full AM is easier
detection of full AM is simpler
none of the above

⇒ To convert JK flip flop to D flip flop
connect D to both J and K
connect D to J directly and D to K through inverter
connect D to K directly and D to J through inverter
connect D to K and leave J open

⇒ The resolution of a 4 bit counting ADC is 0.5 volts. For an analog input of 6.6 volts, the digital output of the ADC will be
1011
1101
1100
1110

⇒ A three stage telephone switching structure is to have 128 input and 128 output terminals. There are 16 first stage and 16 third stage matrices. To avoid blocking the number of intermediate paths required is
16
15
8
1

⇒ The system in the given figure,
good gain and phase margin
poor gain and phase margin
good gain margin but poor phase margin
poor gain margin but good phase margin

⇒ When duct propagation exists
the line of sight and diffraction. Zone concepts are payable
the line of sight and diffraction zone concepts are not applicable
line of sight concept is applicable but diffraction zone concept is applicable
diffraction zone concept is not applicable but line of sight concept is not applicable

⇒ Transistor are free from which type of noise?
Resistance noise
Partition noise
Flicker noise
Shot noise

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order
10^-3 amp
10^-6 amp
10^-9 amp
10^-12 amp

⇒ In an SSB transmitter one is most likely to find
class C audio amplifier
tuned modulator
class B RF amplifier
class AB power amplifier

⇒

Match the following:

	List I (Modulation )		List II (Modulation Index)
A.	DSBFC	1.	μ > 1
B.	DSBSC	2.	μ > 0
C.	SSB	3.	∞
		4.	μ, any value

A-2, B-2, C-3
A-1, B-3, C-3
A-4, B-2, C-1
A-2, B-3, C-1

⇒ In Bode analysis the correction at corner frequency is 3 dB.
TRUE
FALSE

⇒ For Q >> 1, the output frequency of LC oscillator is equal to resonant frequency.
TRUE
FALSE

⇒ Huffman code is also known as redundancy code
TRUE
FALSE
in some cases
depend upon efficiency

⇒ In an optional fiber the refractive index of cladding material should be
nearly 1
very low
less than that of core
more than that of core

⇒ For the DAC in the given figure V_{O10 V
5 V
4 V
8 V}

⇒ If V = 20 + j20, then log_e(A) A is
3.342 + j 45
28.28 ∠45°
400 ∠45°
3.342 + j 0.785