Question is ⇒ Which of the following is not a characteristic of a flip flop?, Options are ⇒ (A) It is a bistable device, (B) It has two outputs, (C) It has two outputs are complement of each other, (D) It has one input terminal, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is not a characteristic of a flip flop?, Options are ⇒ (A) It is a bistable device, (B) It has two outputs, (C) It has two outputs are complement of each other, (D) It has one input terminal, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is not a characteristic of a flip flop?
A.	It is a bistable device [Wrong Answer]
B.	It has two outputs [Wrong Answer]
C.	It has two outputs are complement of each other [Wrong Answer]
D.	It has one input terminal [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The unit of magnetic flux density is
farad/metre
ohm/metre
tesla
ampere/metre

⇒ What is meant by "continuous collector current" in BJT?
Maximum collector current
Current at Quiescent condition
Leakage current
Junction Capacitance charging and discharging current

⇒ Binary number 101101 when converted to its 2's complement will become
101.01
100.1
100.1
101.1

⇒ For a MOS capacitor fabricated on a P-type semiconductor, strong inversion occurs when
surface potential is equal to Fermi potential
surface Potential is greater than Fermi potential
surface potential is - ve and equal to Fermi potential in magnitude
surface potential is + ve and equal to twice the Fermi potential

⇒ In a half wave diode rectifier circuit the current flows in the load circuit for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
9 kΩ
6 kΩ
3 kΩ
2 kΩ

⇒ For an insulating material, dielectric strength and dielectric loss should be respectively
high and high
low and high
high and low
low and low

⇒ In a 5 x 7 dot matrix, format, to store 64 alphanumeric characters we require
1120 bits
2240 bits
33 bits
64 bits

⇒ If the input to the ideal comparator shown in the figure is a sinusoidal signal of 8 V (peak to peak) without any DC component, then the output of the comparator has a duty cycl
42737
42738
42741
42747

⇒ Calculate the directivity of an antenna for θ_E = 30°, θ_H = 60
46
23
50
100

⇒ Paper capacitors are used in power supplies for filtering.
TRUE
FALSE

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz

⇒ Free electrons exist in
first band
second band
third band
conduction band

⇒ (sI - A)^-1 is equal to
adj (sI - A)/det (sI - A)
det (sI - A)/adj(sI - A )
[adj (sI - A)] [det(sI - A)]
none of the above

⇒ The rotation of direction of E field of a linearly polarized wave passing through a magnetised ferric medium is called
Lorentz rotation
Faraday rotation
Steinmitz rotation
Fleming's rotation

⇒ In a R-L-C circuit at resonance is
maximum in series resonance and minimum in parallel resonance.
maximum in parallel resonance and minimum in series resonance
minimum in both series and parallel resonances
maximum in both series and parallel resonances.

⇒ In figure the coordinates of Q point on the load line are (Neglect V_{BEI_C = 10 mA, V_CE = 15 V
I_C = 5 mA, V_CE = 22.5 V
I_C = 5 mA, V_CE = 15 V
I_C = 10 mA, V_CE = 22.5 V}

⇒ Full adder circuit can be implemented by
Multiplexers
Half adders
AND or OR gates
Decoders

⇒ The theoretical power of white noise is
zero
finite
depend upon frequency of signal
infninite

⇒ Almost all resistors are made in a monolithic integrated circuit
during the entire diffusion
while growing the epitaxial layer
during the base diffusion
during the collector diffusion

⇒ Consider the following statements regarding electro-dynamometer type indicating instrum
1 and 2 are corect
3 and 4 are correct
1 and 3 are correct
1, 2, 3, 4 are correct

⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I²/2 pr
I²/4 pr

⇒ Load Z_L for maximum power transfe
R
R + jωL
R - jωL
none

⇒ The current I flowing in the branc
-12 A
0
0.125
-3 A

⇒ Which of the following is unlikely to happen when quantising noise is decreased in PCM?
Increased bandwidth
Increased channel noise
Increased number of standard levels
All of the above

⇒

Assertion (A): In a parallel circuit with three branches having R, L and C respectively and fed by a step current I, the current through inductance is always zero.

Reason (R): The time constant of R-L circuit is L/R.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In CE configuration, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_E and V_CB
I_C and V_CE
I_E and V_CE

⇒ In a lag network the input frequency is 100 f_c where f_c is critical frequency. The voltage gain is
0 dB
-20 dB
-40 dB
-60 dB

⇒ The ideal op-amp has the following characteristics
R_i = ∞, A = ∞, R₀ = 0
R_i = 0, A = ∞, R₀ = 0
R_i = ∞, A = 0, R₀ = 0
R_i = 0, A = ∞, R₀ = ∞

⇒ Insulation resistance of a cable is directly proportional to its length.
TRUE
FALSE