Question is ⇒ For an RC admittance function, Options are ⇒ (A) the lowest critical frequency is a zero, (B) the highest critical frequency is a pole, (C) the lowest critical frequency is zero and the highest critical frequency is a pole, (D) the lowest critical frequency is a pole, (E) , Leave your comments or Download question paper.

Question is ⇒ For an RC admittance function, Options are ⇒ (A) the lowest critical frequency is a zero, (B) the highest critical frequency is a pole, (C) the lowest critical frequency is zero and the highest critical frequency is a pole, (D) the lowest critical frequency is a pole, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an RC admittance function
A.	the lowest critical frequency is a zero [Wrong Answer]
B.	the highest critical frequency is a pole [Wrong Answer]
C.	the lowest critical frequency is zero and the highest critical frequency is a pole [Correct Answer]
D.	the lowest critical frequency is a pole [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ SHF range is
30 - 300 MHz
300 - 3000 MHz
3000 - 30000 MHz
30000 - 300000 MHz

⇒ Bitter powder patterns prove the existence of domains.
TRUE
FALSE

⇒ Which of the following Boolean Expression correctly represents the relation between P, Q, R and M_{1M₁ = (P OR Q) XOR R
M₁ = (P AND Q) XOR R
M₁ = (P NOR Q) XOR R
M₁ = (P XOR Q) XOR R}

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If it is desired to tabulate number of students in a class in Fortran language, a proper variable name is
ST
STUD
NSTUD
STD

⇒ The memory segment registers in 8086 are denoted by
AS, BS, CS, DS
BS, CS, SS, ES
CS, DS, SS, ES
DS, ES, FS, SS

⇒

Assertion (A): A fixed bias BJT circuit exhibits better performance as compared to a self bias BJT circuit.

Reason (R): A fixed bias BJT circuit used less components as compared to a self bias BJT circuit.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The load circuit of a single phase full bridge inverter
must be underdamped
must be overdamped
may be underdamped or overdamped
may be any type of load

⇒ The relation between bandwidth B, modulating frequency f_m and frequency deviation Δf for a sinusoidally modulated FM signal is
B = Δf + f_m
B = 2(Δf + f_m)
B = f_m - Δf/
B = 2(f_m - Δf)

⇒ For stable network, the real part of poles and zeros of driving point function must be
negative
negative or zero
zero
positive

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
0.76, 0.24
0.95, 0.3
0.24, 0.76
0.3, 0.95

⇒ The Boolean expression Y = (A + B + AB) C then Y will be equal to
AC
BC
C
none

⇒ Which one of the following materials is used for making permanent magnets?
Steel
Carbon
Carbon-Steel
Graphite

⇒ The advantages of high density IC are
more circuits on chip
high operating speed
low power consumption
both (a) and (b)

⇒ It is best to use for coupling a coaxial line to a parallel wire transmission line.
directional Coupler
balun
slotted line
tee

⇒ The function δ'(t - b) is a unit doublet.
TRUE
FALSE

⇒ A colour monitor usign 16 bits at a resolution of 600 x 400 pixels needs a memory of
240000 B
9600 B
6400 B
480000 B

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A bipolar transistor is a __________ controlled devices whereas a FET is a __________ controlled devices.
current, voltage
current, current
voltage, current
voltage, voltage

⇒ The derivative of unit step function is
unit impulse
ramp with slope 1
impulse
either (a) or (b)

⇒ Lines of magnetic field attract each other.
TRUE
FALSE

⇒ The duration of sunspot cycle is
1 year
11 years
55 years
100 years

⇒ In an RC series circuit R = 100 Ω and X_C = 10 Ω. In this circuit
the current and voltage are in phase
the current leads the voltage by about 6°
the current leads the voltage by about 84°
the current lags the voltage by about 6°

⇒ The earliest uses of electromagnetic waves were
point to point communication
radar
both (a) and (b)
neither (a) nor (b)

⇒ RESET OUT signal when high indicates that
program counter etc. are being set
program counter etc. are being reset
either (a) or (b)
none of the above

⇒ A computer program is used to read N and compute N !. IF N = 6, the result will be
6
12
720
1040

⇒ The traffic-handling capacity of an Earth station on the uplink depends on
its EIRP
satellite antenna gain
noise associated with the satellite
all of the above

⇒ Cells are connected in series to increase
current-rating
both voltage and current rating
the life of cell
voltage rating

⇒ If E is energy level of electron and E_F is Fermi level, then
all quantum states with E less than E_F will be occupied at T = 0
all quantum states with E less than E_F will be empty at T = 0
some quantum states with E less than E_F will be occupied at T = 0
none of the above

⇒ A metal loses electrons at room temperature.
TRUE
FALSE