Question is ⇒ For an insulating material, dielectric strength and dielectric losses should be, Options are ⇒ (A) high and high, (B) low and high, (C) high and low, (D) low and low, (E) , Leave your comments or Download question paper.

Question is ⇒ For an insulating material, dielectric strength and dielectric losses should be, Options are ⇒ (A) high and high, (B) low and high, (C) high and low, (D) low and low, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an insulating material, dielectric strength and dielectric losses should be
A.	high and high [Wrong Answer]
B.	low and high [Wrong Answer]
C.	high and low [Correct Answer]
D.	low and low [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The reduced form of the func
A(C D + E F + D E) + D E
(A + C + D + E)(D + E + F)
(C + D + E + A)(A + D + E + F)
A C D + A E F + A(D ⊕ E)

⇒ Kelvin's double bridge is used to measure low resistances because
it has high sensitivity
there is no thermoelectric emf
resistance variation due to temperature
effect of contact and lead resistances is eliminated

⇒ The poles and zeros of a positive real function
may lie any where in s plane
may have positive or negative real part
must occur in conjugate pair
must have either negative or zero real part

⇒ In a digital measuring device the input electrical signal is in the frequency range of dc to ac (50) Hz. It must be sampled at a rate of
f times/sec
0.5 f times/sec
0.25 f times/sec
2 f times/sec

⇒ The electrochemical equivalent of a material
depends on its valency
depends on its atomic weight
depends on its valency and atomic weight
depends on the degree of hardness of the material

⇒ In a multicavity klystron amplifier the electron velocity of the order of
10 m/s
10³ m/s
10⁶ m/s
10¹² m/s

⇒ Which one is correct option?

A pure capacitor never dissipates energy, but only stores.
Capacitor can store finite amount of energy even cunent is zero.
The current through a capacitor is zero if voltage across it d.c.
Voltage across a capacitor cannot change instantaneously since it would require an infinite current.
q_c(0^-) = q_c(0⁺)

5, 4, 3, 2
3, 4, 1, 2
2, 4, 3, 1
1, 2, 3, 4, 5

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The noise factor is
1
1.5
2
15

⇒ In floating point representation, the accuracy is
10 bit
9 bit
8 bit
6 bit

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ In a 3 phase semiconverter, the output voltage becomes discontinuous for
firing angle > 30°
firing angle > 60°
firing angle > 90°
firing angle > 120°

⇒ Consider the following statements about instrument landing system of aircraft

It ensures correct landing under conditions of low visibility.
It consists of runaway localizer, glide path equipment and marker beacons.
It is basically a blind landing system.

Which of above statements are correct?
All
1 and 2 only
1 and 3 only
2 only

⇒ The op-amp circuit shown in the figure is a filter. The type of filter and its cut off type of filter and its cut off frequency are respectiv
high Pass, 1000 rad/sec
low Pass, 100 rad/sec
high Pass, 10000 rad/sec
low pass, 10000 rad/sec

⇒

Assertion (A): Most PCs use static RAM for main memory.

Reason (R): Static RAM is faster than dynamic RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following is the abnormal phenomena observed in the ionosphere?
Communication link interference
Sun spot cycle
Fading and whistlers
Tides and winds

⇒ Consider the following statements about constants in 8085

The assembler treats 64 H as hexadecimal constant.
The assembler treats 154 as binary constant.
The assembler treats 540 as octal constant.
The assembler treats 138 as decimal constant.

Which of the above are correct?
1, 2 and 3 only
1, 3 and 4 only
1 and 3 only
2 and 4 only

⇒ In microwave communication links, when fading due to rain attenuation occurs then technique adopted for solving the problem would include
antenna replacement and feed correction
amplitude timing and phase correction
polarization shifting and code diversity
path diversity and frequency diversity

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
42.2 V
19.098 V
38.2 V
none of these

⇒ The accuracy of an instrument is determined by
closeness of indicated value to the actual value
repeatability of measured value
speed with which the reading approaches final value
least value which can be measured

⇒ Millman's theorem is the best to find
equivalent voltage or current source
equivalent voltage source
equivalent voltage and resistance of a circuit
none of the above

⇒ In the circuit of figure both diodes are ideal. If v₁ = 10 V and v₂ = 10 V which diode will cond
D₁ only
D₂ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ The number of select lines in ALU 1C 74181 is
2
4
8
16

⇒ Data are recorded on a 2, 400 ft reel of magnetic tape at a density of 556 characters per inch. If the record length is of 100 characters and 0.75 inch of record gap, the tape utilization factor is
0.85
0.67
0.19
0.08

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC
the faster the time constant of AGC, more accurate the output

⇒ The Boolean function A + BC is reduced form of
AB + BC
AB + ABC
(A + B) (A + C)
(A + C)B

⇒

Assertion (A): The frequency of light used for photoelectric emission is high.

Reason (R): As per Einstein's equation 0.5 mv² < hf - U_w.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watts
1 watt
0.1 watt
0.01 watt

⇒ Consider the following: Energy storage capability of basic passive elements is due to the fact that

resistance dissipates energy
capacitance stores energy
inductance dissipates energy

Which of the above is/are correct?
1, 2, and 3
1 and 3
3 only
1 and 2

⇒ Choose the correct option, if b (branch), n (nodes), l (links)
b = n + l - 1
no. of twig = n - 1
b = n - l + 1
b, a

⇒

Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement

Reason (R): Large value capacitor can also be fabricated on a chip

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct