Question is ⇒ For a type 1 system and unit parabolic input, the steady state error is, Options are ⇒ (A) 0, (B) ∞, (C) 1, (D) 1/Kv, (E) , Leave your comments or Download question paper.

Question is ⇒ For a type 1 system and unit parabolic input, the steady state error is, Options are ⇒ (A) 0, (B) ∞, (C) 1, (D) 1/Kv, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a type 1 system and unit parabolic input, the steady state error is
A.	0 [Wrong Answer]
B.	∞ [Correct Answer]
C.	1 [Wrong Answer]
D.	1/K_v [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In n channel JFET, the gate voltage is made more negative
the channel width will increase
the channel width will decrease
the channel width and drain current will decrease
the channel width will decrease and drain current will increase

⇒ The property is not valid for basic singularity function is
it is even signal
convolution of any arbitary function x(t) and an impulse is the original function itself
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.

⇒ In a single phase semiconverter feeding a highly inductive load, the load current is
sinusoidal
nearly constant
absolutely constant
rectangular

⇒ Which of the following can be accessed only sequentially?
Floppy disk
Hard disk
Magnetic tape
ROM

⇒ Which one of the following is D/A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒ In a low level AM system, the amplifier which follows the modulated stage must be the
linear device
harmonic device
class C amplifier
non-linear device

⇒ An RLC series circuit has Q = 100 and ω₀ = 20 rad/sec. The bandwidth is
0.2 rad/sec
2 rad/sec
20 rad/sec
2000 rad/sec

⇒ In a CE amplifier the input impedance is equal to the ratio of
ac base voltage to ac base current
ac base voltage to ac emitter current
ac emitter voltage to ac collector current
ac collector voltage to ac collector current

⇒ For the signal flow graph of the given figure consider the following statements

It has three forward paths
It has three individual loops
It has two non touching loops

Out of above the correct statements
1, 2, 3
1, 2
2, 3
1, 3

⇒ For a superconductor, the relative permeability is
zero
high
low
either low or high

⇒ The function Z(s) has a pole at infinity if
the degree of numerator and denominator of Z(s) are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒

Assertion (A): CRT is the most important component of a CRO.

Reason (R): When an electron beam strikes the screen of CRT, a spot of light is produced.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The magnitude plot of a composite signal x(t) = e^2jt + e^3jt is
Half wave rectified sinusoid
Full wave rectified sinusoid
Exponentially increasing sinusoid
Exponentially decreasing sinusoid

⇒ Which memory has read operation, byte erase, byte write and chip erase?
RAM
UVEPROM
EEPROM
both (b) and (c)

⇒ D-layer extends approximately from
50 to 90 km
20 to 50 km
90 to 110 km
up to 50 km

⇒ The maximum effective aperture of λ/2 (half-wave) antenna is
0.013 λ²
0.13 λ²
1.3 λ²
13 λ²

⇒ As temperature increases the number of free electrons and holes in an intrinsic semiconductor
increases
decreases
remains the same
may increase or decrease

⇒ Find the number of loop equation and number of possible trees for the given gr
7, 2097152
7, 262144
7.5764801
6, 823543

⇒ For transistor 2 N 338 the manufacturer specifies P_max = 100 mW at 250°C free air temperature and maximum junction temperature of 125°C. Its thermal resistance is
10° C/W
100° C/W
1000° C/W
5000° C/W

⇒ A voltage of 9 V is applied in forward direction to a semiconductor diode in series with a load resistance of 1000 Ω. The voltage across the load resistance is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either o.c or s.c

⇒ L/C has the dimension of
time
capacitance
inductance
resistance

⇒ Which of the following algorithms design techniques is used in quick sort algorithm?
Dynamic programming
Backtracking
Divide and conquer
Greedy

⇒ VLF waves are used for communication system because
of low power requirement
they are least prone to distortion
they penetrate the ionosphere easily
the transmitting antennas are of convenient size

⇒

Assertion (A): Feedback control systems offer more accurate control than open loop systems.

Reason (R): The feedback path establishes a link for comparison of input and output and subsequent error correction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Generally the gain of a transistor amplifier falls at high frequencies due to the
internal capacitance of device
coupling capacitor at the I/P
skin effect
coupling capacitor at the O/P

⇒ The forbidden energy gap for germanium is
0.12 eV
0.32 eV
0.72 eV
0.92 eV

⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9

⇒ The common-drain amplifier, better known as the source follower, has a voltage gain __________ and the output signal is __________ with the input signal.
approaching unity, in phase
approaching unity, out of phase
is very high, in phase
is very high, in reverse phase

⇒ Which circuit is called emitter follower?
CC
CE
CB
Both (a) and (b)

⇒ Which is not a valid dimension statement?
DIMENSION KAT(10, 20)
DIMENSION BAT (30, 20)
DIMENSION KAT(K, 10)
DIMENSION BAT (10, 5)