Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In the expression A + BC, the total number of minterms will be |

A. | 2 [Wrong Answer] |

B. | 3 [Wrong Answer] |

C. | 4 [Wrong Answer] |

D. | 5 [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :Yashi Chaturvedi Said on 2019-09-05 10:16:41Let Y = A+BC i.e. Y = A.1 + 1.BC i.e. Y = A(B+B) + (A+A)BC i.e. Y = AB(C+C) + ABC + ABC i.e. Y = ABC + ABC + ABC + ABC + ABC + ABC i.e. Y = ABC + ABC + AB C + ABC + ABC. !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ A high pulse repetition frequency in a radar

increases the maximum range

decreases the maximum range

has no effect on the maximum range

either (a) or (b) depending on other factors

⇒ The hot resistance of a tungsten lame is about 12 times its cold resistance. Accordingly, the cold resistance of a 60 Ω, 120 V lamp is about __________ ohm.

5

240

2

2880

⇒ The name modem is a contraction of terms modulator demodulator.

TRUE

FALSE

⇒ When a line short circuited at far end, the minimum voltage occurs at

far end

source end

midway between source and far end

none of the above

⇒ Probability density function of thermal noise is

Poisson

Binomial

Gaussian

None of the above

⇒ Two voltmeters 0-250 V each having resistances of 5 kΩ and 10 kΩ respectively and are connected in series. To ensure that neither of them goes beyond scale the total voltage which can be applied should be less than

500 V

400 V

375 V

250 V

⇒ Consider the following

`ON GO TO`

statement in Ba10, 20, 30, 20 respectively

10, 20, 20, 30 respectively

20, 30, 20, 10 respectively

10, 30, 20, 20 respectively

⇒ In a synchro transmitter-control transformer, the voltage induced in rotor winding of control transformer is zero when the angular displacement between rotors of transmitter and transformer is

0°

90°

180°

either (a) or (c)

⇒ At a frequency less than the resonant frequency

series circuit is inductive and parallel circuit is capacitive

series circuit is capacitive and parallel circuit is inductive

both circuits are capacitive

both circuits are inductive

⇒ The theoretical power of white noise is

zero

finite

depend upon frequency of signal

infninite

⇒

**Assertion (A):** Drift velocity of electrons is proportional to the applied electric field E.

**Reason (R):** The average drift velocity per unit field is called mobility.

Both A and R are true and R is correct explanation of A

Both A and R are true but R is not correct explanation of A

A is true but R is false

A is false but R is true

⇒ A thyristor circuit is feeding an R-L load. The turn on time can be reduced by

decreasing R

decreasing L

increasing L

decreasing R and L together

⇒ The op-amp used in nonlinear mode is

integrators

active filters

Schmitt triggers

instrumentation amplifiers

⇒ Which of the following is a better propagation mode to propagate television frequency modulation and radar signals?

Satellite communication

Ground propagation

Polarized communication

None of the above

⇒ A single phase half wave controlled rectifier circuit has a free wheeling diode. The load is a combination of R and L. The firing angle is a. The period of conduction of SCR and free wheeling diode respectively are

a < ω

*t*< p and p < ω

*t*< (2p + a)

a < ω

*t*< p and p < ω

*t*< 2p

a < ω

*t*< (p + a) and (p + a) < ω

*t*< 2p

a < ω

*t*< p and p < ω

*t*< (2p - a)

⇒ Given below impulse response of two sys

*h*

_{1}(

*n*) non causal and stable

*h*

_{1}(

*n*) non causal and stable

*h*

_{1}(

*n*) causal and not stable

*h*

_{1}(

*n*) causal and stable

⇒

Match the following:

List I (Instrument) | List II (Parameters) | ||
---|---|---|---|

A. | Moving coil galvanometer | 1. | High inertia, soft spring control |

B. | Ballistic galvanometer | 2. | No control, high damping |

C. | Vibration galvanometer | 3. | Soft spring control, critical damping |

D. | Moving coil flux meter | 4. | Low inertia, tuned spring control |

A-4, B-2, C-3, D-1

A-1, B-3, C-2, D-4

A-2, B-1, C-4, D-3

A-3, B-1, C-4, D-2

⇒ In a sine wave, maximum rate of change of voltage occurs at

ascent of the waveform

+ ve maximum

- ve maximum

between maximum and minimum

⇒ The efficiency of a chopper circuit is about

80% or more

around 50%

around 20%

around 5%

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?

1 wavelength long

0.5 wavelength long

0.6 wavelength long

0.25 wavelength long

⇒ A matched generator (Z

_{g}= Z

_{0}) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are

0.5 W, 0.5 W, 0 W

0 W, 0 W, 1 W

0.33 W each

0 W, 0.25 W, 0.25 W

⇒ Ferromagnetic materials show hysteresis in B - H characteristic. As the magnetic field in increased slowly from zero value, what is the first process which sets the material to give net magnetization?

Growth of favourably oriented domains at the cost of other domains by reversible boundary displacements

Growth of favourably oriented domains at the cost of other domains by irreversible boundary displacements

Domain wall orientation

A combination of processes (a) and (c) above

⇒ For a short dipole having an effective length less than half the wavelength the radiation resistance is

proportional to length

proportional to square root of length

proportional to square of length

none of the above

⇒ Which of the following can be accessed only sequentially?

Floppy disk

Hard disk

Magnetic tape

ROM

⇒ System

causal

stable

non causal

anticausal

⇒ In using mesh current method it is necessary that at least one mesh current links every element.

TRUE

FALSE

⇒ Transfer function of a certain system

2 sec

4 sec

6 sec

8 sec

⇒ Bipolar signalling uses the following bits

-1, +1

-1, 0, +1

0, 1

-1, 0

⇒ The load impedance Z

_{L}of a CE amplifier has R and L in series. The phase difference between output and input will be

180°

0

more than 90° but less than 180°

more than 180° but less than 270°

⇒ A source of angular frequency 1 rad sec has a source impedance consisting of 1 Ω resistance in series with 1 H inductance. The load that will obtained the maximum power transfer is

1 Ω resistance

1 Ω resistance in parallel with 1 H inductance

1 Ω resistance in series with 1 F capacitor

1 Ω resistance in parallel with 1 F capacitor