Question is ⇒ A medium is said to be isotropic when, Options are ⇒ (A) ∈ = 0, (B) ∈ = μ, (C) ∈ = σ, (D) ∈ is scalar constant, (E) , Leave your comments or Download question paper.

Question is ⇒ A medium is said to be isotropic when, Options are ⇒ (A) ∈ = 0, (B) ∈ = μ, (C) ∈ = σ, (D) ∈ is scalar constant, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A medium is said to be isotropic when
A.	∈ = 0 [Wrong Answer]
B.	∈ = μ [Wrong Answer]
C.	∈ = σ [Wrong Answer]
D.	∈ is scalar constant [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The equivalent circuit of an ideal diode is
a charging condenser
a discharging condenser
a switch
a resistor

⇒ In a material, the Fermi level is located between the centre of the forbidden band and the conduction band. Then what is that material?
A p-type semiconductor
An n-type semiconductor
An intrinsic semiconductor
An insulator

⇒ The intrinsic resistivity of silicon at 300 K is about
1 Ω-cm
400 Ω-cm
10000 Ω-cm
230000 Ω-cm

⇒ For 200V r.m.s. value triangular wave, the peak voltage will be
200 V
222 V
280 V
346 V

⇒ A 24 mm long conductor has a resistance of 128 Ω. The change in resistance is 13.3 Ω and change in length is 1.6 mm under tension. The gauge factor is
1.2
1.6
2.1
2.6

⇒ Primary advantage of a crystal oscillator is that
it can oscillate at any frequency
it gives a high O/P voltage
its frequency of oscillation remains almost constant
it operates on a very low dc supply voltage

⇒ The number of essential prime implicant for the logic express
3
5
4
6

⇒ The maximum theoretical efficiency for class A amplifier is
0.125
0.25
0.5
0.75

⇒ Triatics are
small height antenna directly mounted on jeeps, ships, etc.
the towers or masts which are used as radiators
the towers or masts which are not used as radiators
supports for antenna conductors.

⇒ Transfer function of a certain system
2 sec
4 sec
6 sec
8 sec

⇒ In which of the following 8085 instructions no condition flags are affected?
INX rp
INR r
SBI data
INR M

⇒ In a superheterodyne receiver
the IF stage has better selectivity than RF stage
the RF stage has better selectivity than IF stage
the RF stage has same selectivity than IF stage
none of the above

⇒ In a shift register the data is loaded in one operation but shifted out one bit at a time, The shift register is
serial in-serial out
parallel in-serial out
serial in-parallel out
parallel in-parallel out

⇒ When the light falling on a photodiode increases, the reverse minority current
increases
increases or decreases
decreases
remains the same

⇒ In Pascal if I = 45, I div 10 * 10 =
45
40
0.45
0.4

⇒ A differential amplifier consists of two CB amplifiers.
TRUE
FALSE

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒ Super high frequency means more than 3000 MHz.
TRUE
FALSE

⇒ In figure V_BE = 0.7 V. The base curren
above 97 μA
about 97 mA
about 75 μA
about 75 mA

⇒ In photoelectric emission the maximum kinetic energy of emitted electron is proportional to
f
f
f²
f³

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒ The VLF, LF and MF antennas are
horizontally polarized
vertically polarized
non linearly polarized
either (a) or (b)

⇒ If the number of atoms per unit volume of a monoatomic gas changes, the dielectric constant still remains constant.
TRUE
FALSE

⇒ When a semi-conductor is doped, its electrical conductivity
increases
decreases in the direct ratio of the doped material
decreases in the inverse ratio of the doped material
remains unaltered

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be
0.05 MHz
1 MHz
2 MHz
4 MHz

⇒ In microstrip line has dielectric material most commonly used is
silicon
rubber
plastic
bakelite

⇒ Parallel adder is
sequential circuit
combinational circuit
either sequential or combinational circuit
none of the above

⇒ Which of the following is unlikely to happen when quantising noise is decreased in PCM?
Increased bandwidth
Increased channel noise
Increased number of standard levels
All of the above

⇒ 300 to 3000 MHz frequency is categorized as
MF
HF
UHF
SHF