Question is ⇒ Find E at P(1, 1, 1) caused by four identical 3 nC point charges located at P1(1, 1, 0), P2(- 1, 1, 0), P3(- 1, - 1, 0) P4(1, - 1, 0), Options are ⇒ (A) 21.58ax + 21.58ay + 12az V/m, (B) 6.82ax + 6.82ay + 32.89az V/m, (C) -6.82ax - 6.82ay - 32.89az V/m, (D) -21.58ax - 21.58ay - 12az V/m, (E) , Leave your comments or Download question paper.

Question is ⇒ Find E at P(1, 1, 1) caused by four identical 3 nC point charges located at P1(1, 1, 0), P2(- 1, 1, 0), P3(- 1, - 1, 0) P4(1, - 1, 0), Options are ⇒ (A) 21.58ax + 21.58ay + 12az V/m, (B) 6.82ax + 6.82ay + 32.89az V/m, (C) -6.82ax - 6.82ay - 32.89az V/m, (D) -21.58ax - 21.58ay - 12az V/m, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Find E at P(1, 1, 1) caused by four identical 3 nC point charges located at P₁(1, 1, 0), P₂(- 1, 1, 0), P₃(- 1, - 1, 0) P₄(1, - 1, 0)
A.	21.58a_x + 21.58a_y + 12a_z V/m [Wrong Answer]
B.	6.82a_x + 6.82a_y + 32.89a_z V/m [Correct Answer]
C.	-6.82a_x - 6.82a_y - 32.89a_z V/m [Wrong Answer]
D.	-21.58a_x - 21.58a_y - 12az V/m [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 37 bit mantissa has an accuracy of
6 decimal places
8 decimal places
10 decimal places
11 decimal places

⇒ An A/D converter uses for reference purposes
DC voltage
a saw tooth generator
set of keys
a flip-flop

⇒ In the given figure the time taken by the wave to make one round tri
10 ns
20 ns
30 ns
40 ns

⇒

Match the following:

	List I		List II
A.	Multiplexer	1.	Sequential memory
B.	De-multiplexer	2.	Converts decimal number to binary
C.	Shift register	3.	Data selector
D.	Encoder	4.	Routes single input to many outputs

A-3, B-4, C-1, D-2
A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-1, B-2, C-3, D-4

⇒ The internal resistance of a current source used in the model of a BJT while analyzing a circuit using BJT is :
very high
very low
zero
of the order of a few mega ohms

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected.Ignoring shadows, the port addresses
80 H
85 H
82 H, 83 H
80 H to 85 H

⇒ The sensitivity of electromagnetic digital flow meter can be increased by increasing
circumferential width of rotor teeth
radial depth of rotor teeth
thickness of rotor teeth
number of teeth

⇒ As compared to operating current, the current drawn by a memory chip in stand by mode is
about the same
about one-eighth
about 1 / 64
about 1 / 500

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac

⇒ The bandwidth of FM for Commercial Purpose is
88 - 108 MHz
85 - 110 MHz
90 - 110 MHz
infinite Range

⇒ Pick the odd one
variance
standard deviation
expectation
chebyshev inequality

⇒ Three phase four wire induction energy meter is used to measure
energy in 3 phase balanced star load
energy in 3 phase balanced delta load
energy in 3 phase unbalanced load
either (a) or (b)

⇒ CMOS is widely used in
digital wrist watches
analog circuits
high power circuits
all of the above

⇒ How many distinct binary trees can be constructed with three nodes?
1
2
3
5

⇒ Dolby system of noise reduction divides the total audio spectrum into
8 frequency bands
4 frequency bands
2 frequency bands
none of the above

⇒ The efficiency of using a binary system for selection of 1 out of 13 equally probable events is
1
about 92%
about 83%
about 71%

⇒ The total number of pins in 8085 are
20
30
40
50

⇒ In tape recorders the hissing noise is due to irregularities in magnetic coating on tape.
TRUE
FALSE

⇒ In a semiconductor material. The hole concentration is found to be 2 x 2.5 x 10¹⁵ cm^-3. If mobility of carriers is 0.13 m²/ v-s. Then find the current density if electric field intensity is 3.62 x 10^-19
7.6237 x 10^-4 A/cm²
7.6237 x 10^-5 A/cm²
7.6237 x 10^-3 A/cm²
none of these

⇒ In figure V_i may vary from 15 to 20 V and load current may vary from 20 mA to 100 mA. Suitable maximum value of
20 Ω
50 Ω
100 Ω
200 Ω

⇒ The inconsistency of Ampere's law can be removed by adding __________ to it.
displacement current density alone.
conduction current density alone.
displacement and conduction current densities.
none of these

⇒ Consider the following statements

A 33 MHz 486 has higher MIPS than 33 MHz 386.
A 33 MHz 486 has higher MFLOPS than 33 MHz 386 of these statements.

Both are true
Both are false
1 is true and 2 is false
1 is false and 2 is true

⇒ If a capacitor is charged by a square wave current source the voltage across the capacitor is
triangular wave
step function
zero
square wave

⇒ In a half bridge inverter the gate pulses of the two thyristors have a phase displacement of
60°
90°
120°
180°

⇒ MS Access is a DBMS software.
TRUE
FALSE

⇒ The input impedance of short-circuited line of length l where l < λ/4
inductive
capacitive
resistive
none of the above

⇒ In an LC immittance H (s)
the slope of dH (jω)/dω is always negative
the slope of dH (jω)/dω is always positive
the slope of dH (jω)/dω may be positive or negative
the slope of dH (jω)/dω is constant

⇒

Assertion (A): Electron concentration n, hole concentration p and charge concentration n_i are related by n_i² = np.

Reason (R): p type semiconductor is obtained by adding trivalent impurity to intrinsic semiconductor.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In graphical analysis of BJT amplifier the slope of ac line is more than that of dc load line.
TRUE
FALSE

⇒ If a small amount of Cu is added to Ni conductor, then
resistivity of Ni will decrease at all temperatures because Cu is a better conductor than Ni
residual resistivity of Ni at low temperature will increase as Cu atoms act as defect centres
resistivity of Ni will increase at all temperatures as Cu destroys the periodicity of Ni and acts as defects
resistivity of Ni remains the same