Question is ⇒ A loop antenna is a commonly used for, Options are ⇒ (A) radar, (B) direction finding, (C) satellite communication, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A loop antenna is a commonly used for, Options are ⇒ (A) radar, (B) direction finding, (C) satellite communication, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A loop antenna is a commonly used for
A.	radar [Wrong Answer]
B.	direction finding [Correct Answer]
C.	satellite communication [Wrong Answer]
D.	all of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Power transistors are invariably provided with
soldered connections
heat sink
metallic casing
none of the above

⇒ For an RC admittance function Y,
Y(∞) < Y(0)
Y(0) < Y(∞)
Y (∞) may be lesser or greater than Y(0)
Y(∞) = Y(0)

⇒ Find R_{TH200 Ω
0 Ω
400 Ω
None of these}

⇒ If sequence y(n) = x(-n) then it is
Causal
Non-Causal
Depends on x(-n)
None

⇒ Which of the following best represents the output impedance of an actual op-amp?
10 ohm
100 ohm
10 k ohm
100 k ohm

⇒ Three identical coils each having self inductance L are connected in series so that the fluxes of all the three are in the same direction. If mutual inductance between each pair of coils is M, the total inductance of the arrangement is
3 L + 9 M
1.5 L + 3 M
3 L + 3 M
3 L + 6 M

⇒ In the balanced bridge shown in figure. X should
a self inductance having resistance
a capacitance
a non-inductive resistance
an inductance and capacitance in parallel

⇒ In a bipolar transistor
the base is thick and highly doped
the base is thin and highly doped
the base is thick and lightly doped
the base is thin and lightly doped

⇒ If γ = (S₀/N₀)/(S_i/N_m) where S₀ and S₁ are signal power output and signal power input and N₀ and N_m are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are
1 and 1
1 and 2
2 and 1
0.5 and 0.5

⇒ In figure, the switch S is initially open and steady state conditions are reached. At t = 0 switch is closed. The initial current through 2C capacito
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ The relation between plate current and plate voltage of a vacuum diode is called
Richardson Dushman equation
Langmuir Child law
Ohm's law
Boltzmann's law

⇒ The saturation current in a semi-conductor diode
depends on forward voltage
depends on reverse voltage
is due to thermally generated minority carriers
none of the above

⇒ The Boolean expression for the sub-class (Q) of all electronic instruments which are measuring instruments or are non-digital instruments with battery supply is
Q = X(Y + Z)
Q = X + YZ
Q = XY + Z
Q = XY + Z

⇒ If it is desired to have low output impedance in an amplifier circuit then we should use
common collector circuit
common base circuit
common emitter circuit
either (b) or (c)

⇒ A single phase full bridge inverter for R-L loads needs
4 thyristors
4 thyristors and 4 diodes
4 thyristors and 2 diodes
8 thyristors

⇒ Noise temperature of Sun is more than __________ °K.
1000
5000
100000
500

⇒ If each branch of a Delta circuit has impedance 3 Z then each branch of the equivalent Y circuit has impedance.
Z/3
3 Z
3/3 Z
Z/3

⇒ In a CRO the Y plates are oriented
horizontally
vertically
at an angle of 20° of horizontal
at an angle of 70° of horizontal

⇒ In Vidicon camera tube, the resistance of photoconductive material on the target plate
is constant
is more in darkness and less in brightness
is more in brightness but less in darkness and brightness
may be more or less in darkness and brightness

⇒ Short-circuited stubs are preferred to open circuited stubs because the latter are
more difficult to make and connect
incapable of giving a full range of reactances
made of transmission line with a different characteristic impedance
liable to radiate

⇒ The communication satellite INSAT-IB had to take up the job of INSAT-IA because the latter collapsed within __________ months of its launch.
12
20
5
36

⇒ When measuring phase angle between two waves using a CRO, the time base generator is connected to
X plate
Y plate
both X and Y plate
neither X nor Y plates

⇒ A thermometer requires 1 minute to indicate 98% of its final response to a step input. If it is a first order system the time constant is
1 minute
0.5 minute
0.25 minute
0.1 minute

⇒ In n channel JFET, the gate voltage is made more negative
the channel width will increase
the channel width will decrease
the channel width and drain current will decrease
the channel width will decrease and drain current will increase

⇒ Which of the following amplifier circuits has highest input impedance?
Circuit using BJT
Circuit using JFET
Circuit using MOSFET
Either (a) or (b)

⇒ In an RC-coupled amplifier for improving the low frequency response
lower R_L is provided
more bias is used
less gain is provided
higher C_C is used

⇒ A two port network is reciprocal if and only if
Z₁₁ = Z₂₂
BC - AD = - 1
Y₁₂ = Y₂₁
h₁₂ = h₂₁

⇒ Given figure is the voltage transfer characteristi
an N MOS inverter with enhanced mode transistor as load
an N MOS inverter with depletion mode transistor as load
a CMOS inverter
BJT inverter

⇒ The D'Arsonval- movement can be converted into audio frequency ac ammeter by adding a
thermocouple
transducer
chopper
rectifier

⇒ Point out the false statement
impulse noise voltage does not depend on bandwidth
thermal noise is independent of frequency at which it is measured
industrial noise is mostly of impulse type
space noise is observable at frequencies in the range of 8 MHz and higher