Question is ⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?, Options are ⇒ (A) 0.001, (B) 0.005, (C) 0.01, (D) 0.02, (E) , Leave your comments or Download question paper.

Question is ⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?, Options are ⇒ (A) 0.001, (B) 0.005, (C) 0.01, (D) 0.02, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?
A.	0.001 [Wrong Answer]
B.	0.005 [Wrong Answer]
C.	0.01 [Wrong Answer]
D.	0.02 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of programmable 8 bit registers of 6800 are
2
3
4
5

⇒ The action of bellows is similar to that of
mass
viscous friction
spring
none of the above

⇒ The positive peak of an AM wave is 16 V and the minimum value is 4 V Assuming single tone modulation, the modulation index is
0.6
0.25
4
0.36

⇒

Assertion (A): Many times a radar cannot detect 'grounding hopping' military aircraft.

Reason (R): Ground interference limits the range of radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a bridge inverter with single pulse width modulation
the output frequency is equal to frequency of reference signal
the output frequency is equal to frequency of control signal
either (a) or (b)
neither (a) nor (b)

⇒ An antenna operates effectively when its dimensions are
of the order of magnitude of wavelength to be transmitted
very small than the magnitude of wavelength to be transmitted
very large than the magnitude of wavelength to be transmitted
either (a) or (b)

⇒ De Sauty bridge is very widely used due to
simplicity
perfect balance for imperfect capacitor
perfect balance for air capacitors
maximum sensitivity

⇒

Match the following:

	List I		List II
A.	Mu Metal	1.	very high magnetic permeability
B.	Samrium/cobalt	2.	very high magnetic remanence
C.	Sapphire	3.	very high thermal conductivity
D.	Ferrites	4.	very stable magnetic permeability

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒ Consider the following statements as regards IF in radio receivers

If IF is too high, poor selectivity and poor adjacent channel rejection could result
If IF is high, tracking difficulties increase
A very low IF makes selectivity too sharp
As IF is decreased, image frequency rejection becomes better

Which of the above are correct?
1, 2, 3, 4
1, 2, 3
2, 3, 4
1, 3, 4

⇒ The current wave shown in figure is applied by a 0.1 F capacitor at t = 0. At t = 0⁺, the voltage across capacito
0
4 V
10 V
20 V

⇒ A narrow band noise show
AM only
AM and FM
FM
PCM

⇒ If the gate of JFET is reverse biased, the width of depletion region
becomes zero
is uniform
is more near the source
is more near the drain

⇒

Assertion (A): If Z₁(s) and Z₂(s) are positive real then Z₁(s) + Z₂(s) as well as 1/Z₁(s) and 1/Z₂(s) are positive real.

Reason (R): The poles of a positive real function are real or occur in conjugate pairs.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Calculate the stability factor and change in I_C from 25°C to 100°C for, β = 50, R_B/ R_E = 250, ΔI_C0 = 19.9 nA for emitter bias configuration.
42.53, 0.85 μA
40.91, 0.58 μA
40.91, 0.58 μA
41.10, 0.39 μA

⇒ Energy = voltage x charge.
TRUE
FALSE

⇒ For the system in the given figure, the characteristic equation
s² + s(3 + 6a) + 6 = 0
s² + s(3 + 12a) + 12 = 0
s² + 3s = 0
s² + 6s = 0

⇒ For the logic circuit of the given figure,
A + BC
BC
AB
AB + C

⇒ The response of a function is decided by
the location of its zeros
the location of its poles
both (a) and (b)
none of the above

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V

⇒ A triangular Pulse of 10 V peak is applied to a capacitor of 0.4 F. The change of the capacitor and its wavefor
8 rectangular
8 triangular
4 triangular
4 rectangular

⇒ The critical frequency of 'F' layer is greater than 30 MHz.
TRUE
FALSE

⇒ Poynting vector is associated with
flux in magnetic field
power flow in electrostatic field
current in electrostatic field
charge in electrostatic field

⇒ In telephone systems, load is expressed in the unit of
erlangs
decibels
bells
watts

⇒ How many free electrons does a p type semiconductor has?
only those produced by thermal energy
only those produced by doping
those produced by doping as well as thermal energy
any of the above

⇒ The response of D'Arsonval galvanometer is over damped if
D² > 4CJ
D² > 2CJ
D² < 4CJ
D² < 2CJ

⇒ When UJT is used for thyristor gate signal, the output of UJT is
sine wave
square wave
saw tooth wave
either (a) or (c)

⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform

⇒ (11)₂ + (11)₃ = (11)_?
4
5
6
not possible

⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
250 V
252 V
248 V
210 V

⇒ Which of the following oscillator is generally not used at VHF?
Colpitts oscillator
Clapp oscillator
Armstrong oscillator
Ultra Audio oscillator