Question is ⇒ Bridge circuits using RTD in temperature measurement usually employ 3 lead system so as to obtain, Options are ⇒ (A) higher sensitivity, (B) better impedance matching, (C) compensation for signal wire resistance, (D) reduction in power consumption, (E) , Leave your comments or Download question paper.

Question is ⇒ Bridge circuits using RTD in temperature measurement usually employ 3 lead system so as to obtain, Options are ⇒ (A) higher sensitivity, (B) better impedance matching, (C) compensation for signal wire resistance, (D) reduction in power consumption, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Bridge circuits using RTD in temperature measurement usually employ 3 lead system so as to obtain
A.	higher sensitivity [Wrong Answer]
B.	better impedance matching [Wrong Answer]
C.	compensation for signal wire resistance [Correct Answer]
D.	reduction in power consumption [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The decimal equivalent of the hexadecimal number E 5 is
279
229
327
0

⇒ The amount of time between the creation and disappearance of a hole in an intrinsic semiconductor material is called
life cycle
recombination time
life time
half life

⇒ An impulse train is
a number of pulses
a number of pulses spaced from each other
a number of pulses all originating together
none of the above

⇒ UHF range is
3 to 30 MHz
30 to 300 MHz
300 to 3000 MHz
3000 to 30000 MHz

⇒

Assertion (A): In reverse biased p-n junction, the reverse saturation current is nearly constant if the reverse voltage is less than critical value.

Reason (R): The total reverse current is sum of reverse saturation current and surface leakage current.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ How many input-output ports can be accessed by direct method of 8085 μp?
8
256
32 K
64 K

⇒ The direction in a Yagi Uda antenna
is longer than the radiating element
is shorter than the radiating element
can be longer or shorter than the radiating element
does not exist

⇒ For the transmission of normal speech, the PCM channel needs a bandwidth of __________ kHz.
2
4
16
32

⇒ Which of the following devices is used in the microprocessors?
JFET
BJT
MOSFET
CMOS

⇒ Which of the following binary numbers is equivalent to decimal 10?
1000
1100
1010
1001

⇒ In which group of 8085 instructions condition flags are not affected?
Data transfer group
Arithmetic group
Logical group
Both (a) and (c)

⇒ In order to obtain triangular pulses at the output of the circuit in the figure, the input should
grounded
a square wave
Triangular wave
Trigger

⇒ Which one of the following statement is correct?
Satellite spacing is not affected by the bandwidth of the transmitting earth station
Beamwidth is independent of antenna size and frequency band used
The width of a beam in space is inversely proportional to the width of the transmitting antenna
Use of high-frequency bands permits less number of satellites to share the orbit

⇒ Decimal number 9 in gray code =
1100
1101
110
1111

⇒ A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is
0.768 V
48 x 10^-6 V
12 x 10^-6 V
3.072 Volt

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ MTSO stands for
Metropolitan Telecommunication Subscribers Office
Metropolitan Telecommunication Switching Office
Mobile Telecommunication Switching Office
Mobile Telecommunication Subscriber Office

⇒ For an antenna of height h_t metres, the radio horizon is equal to
4h_t metres
4h_t km
2.5h_t km
2.5h_t metres

⇒ For stable network, the real part of poles and zeros of driving point function must be
negative
negative or zero
zero
positive

⇒

Match the following:

	List I (Functional headings of instruction set of 8085)		List II (Functions performed)
A.	Branch group	1.	Compares, rotates etc.
B.	Logic group	2.	Moves, loads, stores etc.
C.	Data transfer group	3.	Initiates conditional or unconditional jumps, calls etc.

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-1, C-2
A-1, B-3, C-2

⇒ Which of the following memories normally has highest storage capacity?
Magnetic disc
Magnetic tape
Semiconductor memory
Core memory

⇒ Which antenna is frequently used for local area transmission at UHF/VHF?
Ground monopole
Turnstile antenna
Slot antenna
Loop antenna

⇒ Which of these is used in seven segment display?
PIN diode
LED
Photo diode
Tunnel diode

⇒ The relation between plate current and plate voltage of a vacuum diode is called
Richardson Dushman equation
Langmuir Child law
Ohm's law
Boltzmann's law

⇒ If r_e is ac resistance of diode, the Thevenin input impedance of a differential amplifier is
r_e
br_e
2 br_e
0.5 br_e

⇒ The modulation index of wideband FM signal is
less than unity
unity
greater than unity
nearly 0.67

⇒ A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge amplifier and overall gain of transducer and amplifier is 50 mV/N. The gain of amplifier is
1 mV/pC
1.5 mV/pC
2.5 mV/pC
4 mV/pC

⇒ The power input and output in a device are 3650 W and 3385 W with each reading in doubt by ± 10 W. The percentage uncertainty in losses is
± 7.55%
± 3.77%
± 11.32%
± 15.09%

⇒ The root locus branches
start from open loop poles and terminate at zeros
start from open loop zeros and terminate at poles
may start from pole or zero and terminate at another pole or zero
none of the above

⇒ When the i-v curve of a photodiode passes through origin the illumination is
maximum
minimum
zero
equal to rated value