Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Assertion (A): Tristate logic is used for bus oriented systems Reason (R): The outputs of a tristate logic are 0, 1 and indeterminant. | |
A. | Both A and R are correct and R is correct explanation of A [Wrong Answer] |
B. | Both A and R are correct but R is not correct explanation of A [Wrong Answer] |
C. | A is true, R is false [Correct Answer] |
D. | A is false, R is true [Wrong Answer] |
View Answer
Explanation:-
Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ If the ratio p(s)/q(s) represents a transfer function then
the degree of p(s) may be as small as zero, independent of degree of q(s)
the degree of p(s) and q(s) must be equal
the degrees of p(s) and q(s) must not be equal
the degrees p(s) and q(s) must differ by at least two
⇒ When a CE transistor is cut off
voltage across collector reduces to zero
voltage across collector is maximum
maximum collector current flows
maximum voltage appears across the load resistance
⇒ In a mechanical accelerometer, the steady state displacement is a measure of
constant input acceleration
constant input velocity
either (a) or (b)
neither (a) nor (b)
⇒ Consider the signal S(t) shown bel
8
12
16
18
⇒ A parabolic antenna produces a radiation pattern which is
circularly polarized
highly directional
omnidirectional
linearly polarized
⇒ In PAL system weighting of R - Y and B - Y signals is done to
prevent over modulation on saturated colours
prevent under modulation of saturated colours
allow over modulation of saturated colours
allow under modulation on saturated colours
⇒ A piece of iron is placed in a magnetic field
the magnetic field will not be affected
the magnetic lines of force will bend to pass through the piece
the magnetic lines of force will bend away from the piece
any of the above depending on type of iron
⇒ Consider the following statements about conditions that make a metal semiconductor contact rectifying
1 and 3 are correct
2 and 3 are correct
1 and 4 are correct
2 and 4 are correct
⇒
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true
⇒ Oscillator with best frequency stability is
Crystal oscillator
Phase shift oscillator
Clapp oscillator
Hartley oscillator
⇒ In a microwave resistor the wall thickness is made as small as possible to
have high value of R
have low value of R
minimize capacitive effect
reduce inductance
⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V
⇒ 74HCT00 series is
NAND IC
interface between TTL and CMOS
inverting IC
NOR IC
⇒ If the mantissa of a digital computer is 37 bit long then the accuracy of the digital computer will be of
37 decimal places
23 decimal places
11 decimal places
accuracy is independent of the length to mantissa
⇒ For a rectified sinusoidal wave clipped at 0.707 its peak value (figure), the average valu
70.7 V
63.7 V
54 V
15 V
⇒ The inputs A, B, C of the given figure are applied to a 3 input NOR gate. The outpu
HIGH from 4 to 0
LOW from 0 to 4
HIGH from 0 to 1 and LOW from 1 to 4
LOW from 0 to 2 and HIGH from 2 to 4
⇒ A multimeter can be used as ohmmeter.
TRUE
FALSE
⇒ A first-order system has a time constant t. For unit ramp input, the steady state error is
t^{2}
t
t
1/t
⇒ For a second order instrument, the optimum range of ξ (damping ratio), which gives good frequency response over a wide range of frequencies is
0.5 to 0.6
0.6 to 0.7
0.7 to 0.8
0.8 to 1.0
⇒ Substitution theorem applies to
Linear network
Non linear network
Linear time invariant network
Any network
⇒ For an N bit ADC, the percentage resolution is [1/2^{N} - 1)] 100.
TRUE
FALSE
⇒ The system matrix of continuous time system described in state variable for
x < 1/2, y < 1/2
x > 1/2, y > 0
x < 0, y < 0
x < 0, y < 1/2
⇒ Some features of advanced mobile phone service are
1 and 2 only
1, 2, 3
1 and 3 only
2 and 3 only
⇒ Signal flow graph is used to find :
stability of the system
controllability of the system
transfer function of the system
poles of the system
⇒ For a semiconductor, the conductivity is a function of the products of the number of charge carriers and their mobilites. As result, if the temperature of a slab of intrinsic silicon increases, how does its conductivity vary?
Decreases
Increases
Remains unaffected
Increases or decreases depending upon the rise in temperature
⇒ In the op-amp circuit of figure, V_{010 V-10 V5 V-5 V}
⇒ An inverting voltage feedback is a
voltage amplifier
current amplifier
current to voltage converter
voltage to current converter
⇒ A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is
8 W
7.5 W
7.1 W
6.8 W
⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^{-5} ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
114 kW
336 kW
384 kW
455 kW
⇒ The V-i relation for a varistor is
i = kv^{n}
v = ki^{n}
i = kv^{3}
v = ki^{3}
⇒ If the ratio p(s)/q(s) represents a transfer function then
the degree of p(s) may be as small as zero, independent of degree of q(s)
the degree of p(s) and q(s) must be equal
the degrees of p(s) and q(s) must not be equal
the degrees p(s) and q(s) must differ by at least two
⇒ When a CE transistor is cut off
voltage across collector reduces to zero
voltage across collector is maximum
maximum collector current flows
maximum voltage appears across the load resistance
⇒ In a mechanical accelerometer, the steady state displacement is a measure of
constant input acceleration
constant input velocity
either (a) or (b)
neither (a) nor (b)
⇒ Consider the signal S(t) shown bel
8
12
16
18
⇒ A parabolic antenna produces a radiation pattern which is
circularly polarized
highly directional
omnidirectional
linearly polarized
⇒ In PAL system weighting of R - Y and B - Y signals is done to
prevent over modulation on saturated colours
prevent under modulation of saturated colours
allow over modulation of saturated colours
allow under modulation on saturated colours
⇒ A piece of iron is placed in a magnetic field
the magnetic field will not be affected
the magnetic lines of force will bend to pass through the piece
the magnetic lines of force will bend away from the piece
any of the above depending on type of iron
⇒ Consider the following statements about conditions that make a metal semiconductor contact rectifying
- N type semiconductor with work function φ_{s} more than work function φ_{M} of metal
- N type semiconductor with work function φ_{s} less than work function φ_{M} of metal
- P type semiconductor with work function φ_{s} more than work function φ_{M} of metal
- P type semiconductor with work function φ_{s} less than work function φ_{M} of metal.
1 and 3 are correct
2 and 3 are correct
1 and 4 are correct
2 and 4 are correct
⇒
Assertion (A): If the reading of an instrument is low, the error is large.
Reason (R): The error of an instrument is certain percentage of its full scale deflection.
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true
⇒ Oscillator with best frequency stability is
Crystal oscillator
Phase shift oscillator
Clapp oscillator
Hartley oscillator
⇒ In a microwave resistor the wall thickness is made as small as possible to
have high value of R
have low value of R
minimize capacitive effect
reduce inductance
⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V
⇒ 74HCT00 series is
NAND IC
interface between TTL and CMOS
inverting IC
NOR IC
⇒ If the mantissa of a digital computer is 37 bit long then the accuracy of the digital computer will be of
37 decimal places
23 decimal places
11 decimal places
accuracy is independent of the length to mantissa
⇒ For a rectified sinusoidal wave clipped at 0.707 its peak value (figure), the average valu
70.7 V
63.7 V
54 V
15 V
⇒ The inputs A, B, C of the given figure are applied to a 3 input NOR gate. The outpu
HIGH from 4 to 0
LOW from 0 to 4
HIGH from 0 to 1 and LOW from 1 to 4
LOW from 0 to 2 and HIGH from 2 to 4
⇒ A multimeter can be used as ohmmeter.
TRUE
FALSE
⇒ A first-order system has a time constant t. For unit ramp input, the steady state error is
t^{2}
t
t
1/t
⇒ For a second order instrument, the optimum range of ξ (damping ratio), which gives good frequency response over a wide range of frequencies is
0.5 to 0.6
0.6 to 0.7
0.7 to 0.8
0.8 to 1.0
⇒ Substitution theorem applies to
Linear network
Non linear network
Linear time invariant network
Any network
⇒ For an N bit ADC, the percentage resolution is [1/2^{N} - 1)] 100.
TRUE
FALSE
⇒ The system matrix of continuous time system described in state variable for
x < 1/2, y < 1/2
x > 1/2, y > 0
x < 0, y < 0
x < 0, y < 1/2
⇒ Some features of advanced mobile phone service are
- To provide telephone communication to a large number of telephone users within the area of a metropolitan only
- To use minimum amount of frequency spectrum
- To permit hand held as well as vehicle operation of telephone
1 and 2 only
1, 2, 3
1 and 3 only
2 and 3 only
⇒ Signal flow graph is used to find :
stability of the system
controllability of the system
transfer function of the system
poles of the system
⇒ For a semiconductor, the conductivity is a function of the products of the number of charge carriers and their mobilites. As result, if the temperature of a slab of intrinsic silicon increases, how does its conductivity vary?
Decreases
Increases
Remains unaffected
Increases or decreases depending upon the rise in temperature
⇒ In the op-amp circuit of figure, V_{010 V-10 V5 V-5 V}
⇒ An inverting voltage feedback is a
voltage amplifier
current amplifier
current to voltage converter
voltage to current converter
⇒ A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is
8 W
7.5 W
7.1 W
6.8 W
⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^{-5} ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
114 kW
336 kW
384 kW
455 kW
⇒ The V-i relation for a varistor is
i = kv^{n}
v = ki^{n}
i = kv^{3}
v = ki^{3}