Question is ⇒ The MOS symbols shown indica, Options are ⇒ (A) 1, 3, 6, (B) 2, 4, 6, (C) 1, 3, 5, (D) 2, 3, 6, (E) , Leave your comments or Download question paper.

Question is ⇒ The MOS symbols shown indica, Options are ⇒ (A) 1, 3, 6, (B) 2, 4, 6, (C) 1, 3, 5, (D) 2, 3, 6, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The MOS symbols shown indica
A.	1, 3, 6 [Correct Answer]
B.	2, 4, 6 [Wrong Answer]
C.	1, 3, 5 [Wrong Answer]
D.	2, 3, 6 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ To study electromagnetic radiations from astronomical objects, radio astronomers use
low frequencies
medium frequencies
microwaves
either (a) or (b)

⇒ The threshold voltage of an n-channel enhancement mode MOSFET is 0.5 when the device is biased at a gate voltage of 3V. Pinch off would occur at a drain voltage of
1.5 V
2.5 V
3.5 V
4.5 V

⇒ In FM, as bandwidth increases
distortion increases
distortion decreases
distortion remains unaffected
all

⇒ For checking the parity of a digital word, it is preferable to use
AND gates
NAND gates
EX-OR gates
NOR gates

⇒ An amplitude modulated wave
0.5
0.3
0.7
0.4

⇒ The frequency deviation of a FM signal produced from PM is
identical to that of FM signal produced by direct method
larger than that of a FM signal produced by direct method
directly proportional to the peak amplitude and the frequency of modulating signal
directly proportional to the peak amplitude of the modulating signal

⇒ A Discone antenna is
a combination of disk and cone in close approximity
a combination of disk and cone at λ/4 spacing
a combination of disk and cone far apart
a combination of disk and cone at λ/2 spacing

⇒ A speech signal, band limited to 4kHz and peak voltage varying between + 5V and - 5V is sampled at the Nyquist rate. Each sample is quantized and represented by 8 bits. Assuming the signal to be uniformly distributed between its peak values, the signal to noise ratio at the quantizer output is
156 dB
32 dB
48 dB
64 dB

⇒ What is the correct sequence of the following step in the fabrication of a monolithic, Bipolar junction transistor?

Emitter diffusion
Base diffusion
Buried layer formation
E pi-layer formation

Select the correct answer using the codes given below:
3, 4, 1, 2
4, 3, 1, 2
3, 4, 2, 1
4, 3, 2, 1

⇒

Assertion (A): Magnetic susceptibility of copper is -0.5 x 10^-5.

Reason (R): Copper is diamagnetic material.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the given figure A = 1, B = 1. B is now changed to a sequence 101010................The outputs X and Y wil
fixed at 0 and 1 respectively
X = 1010.......and Y = 0101........
X = 1010..........and Y = 1010
fixed at 1 and 0 respectively.

⇒ For a paramagnetic material, susceptiblity increases with increasing temperature.
TRUE
FALSE

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_E
1 mA
1.2 mA
1.3 mA
1.4 mA

⇒ Dynamic range of hi-fi system is at least
150 dB
120 dB
80 dB
40 dB

⇒ Which of the following pairs of octal and binary numbers are not equal?
111 11011₂ = 767₈
110110101₂ = 665₈
11010₂ = 3₈
10101.11₂ = 25.6₈

⇒ For maximum transfer of power, internal resistance of the source should be
equal to load resistance
less than the load resistance
greater than the load resistance
none of the above

⇒ Antenna used for T.V. broadcasting is
long dipole
metal horn
crossed dipole
log periodic

⇒ The colour code on a carbon resistor is red-red-black-silver. The value of resistor is
22000 Ω
2200 Ω
22 ± 5% Ω
22 ± 10% Ω

⇒ When the i-v curve of a photodiode passes through origin the illumination is
maximum
minimum
zero
equal to rated value

⇒ Find the output voltage for 011100 in a 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V.
6.4 V
2.84 V
0.1 V
8 V

⇒ In which of the following circuits is op-amp used in open loop configuration?
Comparator
Summing amplifier
Integrating amplifier
Logarithmic amplifier

⇒ 0.1011₂ = __________ .
0.6875₁₀
0.6800₁₀
0.0100₁₀
0.5000₁₀

⇒ The pole of a reactive function
lie on jω axis only
lie on negative real axis only
may lie anywhere on s plane
lie on jω axis or on negative real axis

⇒

Assertion (A): The main use of positive feedback is in oscillator circuits.

Reason (R): In an oscillator the loop gain Aβ is kept slightly more than unity

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In flip flops the duration of clock pulse is about
3 ns
10 ns
25 ns
50 ns

⇒ An electron for which l = 0 has zero orbital magnetic dipole moment.
TRUE
FALSE

⇒ The main function of a balanced modulator is to
produce balanced modulation of a carrier wave
produce 100% modulation
suppress carrier signal in order to create a single-sideband or double sideband
limit noise picked by a receiver

⇒

Assertion (A): The trigger circuit of a CRO is excited by the same signal as Y plates.

Reason (R): The time base generator develops a saw tooth voltage.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Voltage V_L in the circuit when V_s < 0 where D is an ideal diode. (Take R₁ = R_s = R_L = 1 &o
0
1
1.5
cannot find

⇒ If we connect two silicon unilateral switches in anti- parallel we get
SCR
SBS
SCS
UJT