Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | A moving coil meter has 10 Ω resistance and requires 40 mA for full scale deflection. The shunt resistance required to convert it into 0-2 A ammeter is |

A. | 0.1021 Ω [Wrong Answer] |

B. | 0.2041 Ω [Correct Answer] |

C. | 0.256 Ω [Wrong Answer] |

D. | 0.4210 Ω [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ If transmission path, in PCM, is very long then

repeater stations are used

pulse width may be increased

pulse amplitude is increased

pulse spacing is reduced

⇒ A dynamometer wattmeter is suitable for both dc and ac.

TRUE

FALSE

⇒ A D.C. amplifier amplify

D.C. only

A.C. only

both A.C. and D.C.

none of the above.

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5

*k ohms*resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 H

*z*and 10 kH

*z*is

0.76, 0.24

0.95, 0.3

0.24, 0.76

0.3, 0.95

⇒ In a klystron amplifier the force on all electrons

causes acceleration of all electrons

causes retardation of all electrons

causes acceleration of some electrons and retardation of others

none of the above

⇒ The units of resistivity are ohm-metre.

TRUE

FALSE

⇒ A 400 W carrier is modulated to a depth of 75 percent. The total power in modulated wave will be

38.5 W

400 W

512.5 W

615.5 W

⇒ In a simple on-off controller with differential gap, the magnitude of differential gap determines

the level of accuracy

the life of controller

both (a) and (b)

neither (a) nor (b)

⇒ A parallel resonant circuit can be used

as a high impedance

to reject a small band of frequencies

both (a) and (b)

to amplify certain frequencies

⇒ In a microwave resistor the wall thickness is made as small as possible to

have high value of R

have low value of R

minimize capacitive effect

reduce inductance

⇒ Consider the following state

1 only

1 and 2

2 only

3 only

⇒ In which of the following does a negative resistance region exist in the

*v*-

*i*characteristics?

PIN diode

Schottky diode

Tunnel diode

Zener diode

⇒ In a loss less line the propagation constant is equal to

*j*ωLC

LC

*j*ωLC

LC

⇒ Consider the following statements about conditions that make a metal semiconductor contact rectifying

- N type semiconductor with work function φ
_{s}more than work function φ_{M}of metal - N type semiconductor with work function φ
_{s}less than work function φ_{M}of metal - P type semiconductor with work function φ
_{s}more than work function φ_{M}of metal - P type semiconductor with work function φ
_{s}less than work function φ_{M}of metal.

1 and 3 are correct

2 and 3 are correct

1 and 4 are correct

2 and 4 are correct

⇒ Consider the following library functions

- EXP (
*i.e., e*^{x}) - ARCTAN (
*i.e.* tan^{-1} *x*) - SQRT (
*i.e., x*) - AES (
*i.e. *|*x*|) <

All

1 and 3 only

1, 3, 4 only

1, 2 and 3 only

⇒ 39.12_{10} = __________ _{10}

10111.0001111

100011.0001111

100001.0001111

1111.0001111

⇒ A square in which each (*i*, *j*)^{th} element of matrix is equal to the negative of the conjugate complex of (*j*, *i*)^{th} element, is called

Hermitian matrix

Skew symmetric matrix

Conjugate anti-symmetric matrix

Skew-Hermitian matrix

⇒ Which of the following terms are equivalent? - A ⊕ B ⊕ C
- A ⊕ B ⊙ C
- A ⊙ B ⊕ C
- A ⊙ B ⊙ C

1 and 4; 2 and 3

1 and 3

2 and 3

1, 2 and 4

⇒ As compared to tuned radio frequency receivers which of the following is the advantage of using superheterodyne receivers?

High gain and better sensitivity

Better selectivity at high frequencies

Stability

Noise suppression

⇒ The Table given below is the mark obtained by 2 students in 8 different subjec

-0.4748

0.4748

-0.0338

0.0338

⇒ A quarter wave line short circuited at load end behaves as

an inductance

an inductance and capacitance in series

a capacitance

an inductance and capacitance in parallel

⇒ The light output of LED varies as (current)^{n}. The value of *n* is about

0.5

1

1.3

2.1

⇒ For an ac sinusoidal wave, the rms value is 10 A. For the same wave delayed by 60° in each half cycle, the rms value is likely to be

0.416666666666667

7.07 A

6.35 A

3.5 A

⇒ Presently, the worlds's largest and most advanced multi-purpose communication satellite is

INSAT-2

Intelsat-V

INSAT-ID

Olympus-I

⇒ An *m* derived low pass filter has *f*_{c} = 1000 Hz, *f*_{∞} = 1250 Hz and *m* = 0.6. If *m* is increased, then

both *f*_{c} and *f*_{∞} will increase

both *f*_{c} and *f*_{∞} will decrease

*f*_{c} will remain constant but *f*_{∞} will decrease

*f*_{c} will remain constant but *f*_{∞} will increase

⇒ In a low level AM system, the amplifier which follows the modulated stage must be the

linear device

harmonic device

class C amplifier

non-linear device

⇒ The manufacturing technique used to manufacture strip type transmission line is

photoetching technique

oxidation technique

cladding

epitaxial

⇒ The counter in the given figur

Mod 3

Mod 6

Mod 8

Mod 7

⇒ According to maximum power transfer theorem, the maximum power is absorbed by one network from another network when

the impedance of one of the networks is half that of the other

the impedance of one is the complex conjugate of the other

the impedance of one is equal to that of the other

none of the above

⇒ The gain of collinear arrays is maximum when the spacing between the elements is

0.1 λ to 0.3 λ

0.3 λ to 0.9 λ

0.5 λ to 0.7 λ

0.7 λ to 0.9 λ

```
```

```
```

```
```

```
```