Question is ⇒ The number of repeaters in a coaxial cable link depends on, Options are ⇒ (A) system bandwidth, (B) separation of equalizers, (C) the number of coaxial cables in the tube, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The number of repeaters in a coaxial cable link depends on, Options are ⇒ (A) system bandwidth, (B) separation of equalizers, (C) the number of coaxial cables in the tube, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The number of repeaters in a coaxial cable link depends on
A.	system bandwidth [Correct Answer]
B.	separation of equalizers [Wrong Answer]
C.	the number of coaxial cables in the tube [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 3 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a delayed half wave rectified wave, the average and rms values are lower than those for half wave.
TRUE
FALSE

⇒ AECF1₁₆ + 15ACD₁₆ = __________ .
C47BB₁₆
C47BE₁₆
A234F₁₆
A1111₁₆

⇒ The stud in a stud mounted SCR acts as
anode
cathode
gate
anode or cathode

⇒ The correct relation between joules and calories is
calories = joules/4.156
joules = calories/4.156
calories = joules x 10⁷/4.156
joules = calories x 10⁷/4.156

⇒ The Truth Table shown is f
CMO
counter
flip-flop
half adder

⇒ The microprograms provided by a manufacturer to be used on his microprogrammed computer are generally called
software
network
firmware
hardware

⇒ According to maximum power transfer theorem, if the load is inductive, the source should be
inductive
capacitive
resistive
any of the above

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the base current will be
35 μA
25 μA
15 μA
5 μA

⇒ The function f = A ⊕ B ⊕ A ⊕ D ⊕ E ⊕ C ⊕ D ⊕ E ⊕ F ⊕ G ⊕ F ⊕ G ⊕ C ⊕ E ⊕ A ⊕ D ⊕ B ⊕ E ⊕ E ⊕ B ⊕ B ⊕ B ⊕ B ⊕ D can be written as
A ⊕ B ⊕ D
A ⊕ B ⊕ E
A ⊕ E
A ⊕ E

⇒ The noise generated by a resistor depends upon
its resistance value
its operating temperature
both its resistance value and operating temperature
none of the above

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒ Hall coefficient is reciprocal of charge density.
TRUE
FALSE

⇒ If transmitted power is 75 kW, the field strength at 30 km distance will be about
10 V/m
1 V/m
50 mV/m
2 mV/m

⇒ In one of the codes for transfer of numbers the code for the succeeding number differs from that of the number only in the change of a single digit. The code is
ASCII
Excess 3 CODE
Gray CODE
none of these

⇒ Which of the following is not valid integer variable in FORTRAN 77?
MBR
LOTS
JAMMU
BRG

⇒ In a PCM system, if the code word length is increased from 6 to 8 bits, the signal to quantization noise ratio improves by the factor.
42953
12
16
8

⇒ A Charge Couple Device (CCD) is a
RAM
sequential accessed memory
content addressable memory
read only memory

⇒ When a p-n-p transistor is properly biased to operate in active region the holes from emitter.
diffuse through base into collector region
recombine with electrons in base
recombine with electrons in emitter
none of the above

⇒ The circuit of figure is ca
diode bias
current mirror
complementary mirror
none of the above

⇒

Assertion (A): Dielectric constant is independent of temperature unless the temperature is extremely high.

Reason (R): For normal temperatures the number of atoms per unit volume is constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Figure shows the feedback network of one of the very popular types of sinusoidal oscillators. Which one is t
Weinbridge oscillator
Hartley oscillator
Colpitt's oscillator
R-C phase shift oscillator

⇒ In the circuit of figure both diodes are ideal. If v₁ = 10 V and v₂ = 10 V which diode will cond
D₁ only
D₂ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ Find equivalent capacitance if each capacitance is
56 F
6/5 F
6/10 F
5/12 F

⇒ If the transfer function has zeros only on jω axis or in left half plane, it is a minimum phase function.
TRUE
FALSE

⇒ The mechanical system shown below has its pole(s)
- K/D
- D/K
- DK
0, - K/D

⇒ A Shockley diode can be used
in place of SCR
as a trigger switch for SCR
in place of UJT
both in place of SCR and as a trigger switch for SCR

⇒ In the case of the circuit shown in the figure V_io = 10 mV dc maximum, the maximum possible output offset voltage V_oo caused by the input offset voltage V_io with respect to groun
60 mV dc
110 mV dc
130 mV dc
150 mV dc

⇒ Start and stop bit do not contain any information but are used in serial communication for
error correction
error detection
synchronization
slowing down the communication

⇒ Hydrogen is used in
large size transformers
MCB
large size generators
circuit breakers

⇒ A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either short circuited or open circuited