Question is ⇒ The signal in 8086 are in minimum mode when, Options are ⇒ (A) MN / Mx pin is tied to Vcc, (B) MN / Mx pin is grounded, (C) MN / MX pin is left open, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The signal in 8086 are in minimum mode when, Options are ⇒ (A) MN / Mx pin is tied to Vcc, (B) MN / Mx pin is grounded, (C) MN / MX pin is left open, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The signal in 8086 are in minimum mode when
A.	MN / Mx pin is tied to V_cc [Correct Answer]
B.	MN / Mx pin is grounded [Wrong Answer]
C.	MN / MX pin is left open [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a 2 port network, the O/P short circuit current was measured with a 1 volt source at the I/P then value of the current gives
h₁₂
y₁₂
h₂₁
y₂₁

⇒ Which device uses Pneumatic fluid?
LED
LCD
VF display
None of these

⇒ Which of the following is not correct?
P(A) = P(A) - 1
0 ≤ P ≤ 1
If A and B are mitual exclusive then P(A + B) = P(A) + P(B)
P(A) = 1 - P(A)

⇒ Eddy current loss is
proportional to frequency
independent of frequency
proportional to (frequency)²
proportional to (frequency)³

⇒ In a clocked NAND latch, race condition occur when
R and S are high CLK is low
R and CLK are high and S is low
R, S, CLK are high
R, S, CLK are low

⇒ From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier
gain bandwidth product
slew rate
upper 3 dB frequency
lower 3 dB frequency

⇒ Roughly the time required for microwave cooking as compared to conventional cooking is
about twice
about half
about 10 times
about one-tenth

⇒ A 4 line to 16 line decoder has
16 inputs and 4 outputs
4 inputs and 16 outputs
either (a) or (b)
neither (a) nor (b)

⇒ If σ standard deviation, probable error
σ
± 1.19 σ
± 0.6745 σ
± 0.4125 σ

⇒ In a 100 turn coil, if the flux through each turn is (t³ - 2t)mW_b, the magnitude of the induced emf in the coil at a time of 4 sec is
46 mV
56 mV
4.6 V
5.6 V

⇒ The heat sink disposes off heat mainly by
radiation
natural convection
forced convection
conduction

⇒ In the following limiter circuit, an input voltage V₁ = 10 sin 100pt applied. Assume that the diode drop is 0.7 V when it is forward biased. The zener breakdown voltage is 6
6.1 V, -0.7 V
0.7 V, -7.5 V
7.5 V, -0.7 V
7.5 V, -7.5 V

⇒ High IF in a superheat receiver
improves selectivity
increases tracking problems
decreases tracking problems
reduces adjacent channel rejection

⇒

Assertion (A): The carry look ahead adder is very fast

Reason (R): The carry look ahead adder generates the carry and sum digits directly.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ It f(t) is an odd function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ A parallel RLC circuit has ω₀ = 10⁶ and Q = 30, Given C = 30 pF, the value of R is
0
1 μΩ
2 MΩ
1 MΩ

⇒ Consider the following statements

Tellegen's theorem is applicable to any lumped network.
Reciprocity theorem is applicable to linear bilateral network.
Thevenin theorem is applicable to two terminal linear active network.
Norton's theorem is applicable to linear active network.

Which of the above statements are correct?
1, 2 and 3
1, 2, 3 and 4
1, 2 and 4
3 and 4

⇒ At 0 K, silicon and germanium behave like monoatomic crystals.
TRUE
FALSE

⇒ In 8085, to disable the whole interrupt system (except TRAP)
the DI instruction may be used
the DO instruction may be used
the INTERRUPT instruction may be used
the El instruction may be used

⇒ Which of the following is not a DTP program?
Page maker
Coral draw
Coral ventura
Coral key

⇒ While obtaining minimal SOP expression
all do not care terms are ignored
all do not care terms are treated as 1
all do not care terms are treated as 0
only such do not care terms which aid minimization are treated as 1

⇒ The voltage across the secondary of the transformer in a half wave rectifier with a shunt capacitor filter is 50 volts. The maximum voltage that will occur on the reverse biased diode will be
100 V
88 V
50 V
25 V

⇒ Which is the displacement transducer with excellent sensitivity, linearity and resolution?
Incremental encoder
Absolute encoder
LVDT
Strain gauge

⇒ Which of the following is not between F₂ layer and D layer?
E layer
F₁ layer
G region
All of the above

⇒ Inverse Fourier transform of '1' is
U(t)
δ(t)
0'
infinite

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88W
7.3 W
73 W

⇒ The function δ (t - b) is a
unit impulse
unit step
unit doublet
none of the above

⇒ The given figure shows a hybrid servosystem. The components 1, 2, 3, 4 are respecti
amplifier, demodulator, dc servomotor and load
demodulator, amplifier, dc servomotor and load
demodulator, dc servomotor, amplifier and load
amplifier, dc servomotor, demodulator and load

⇒ The 2732 is 4096 x 8 EPROM. How many address lines does it have?
12
24
50
100

⇒ In figure V_BE = 0.7 V. The base curren
above 97 μA
about 97 mA
about 75 μA
about 75 mA