Question is ⇒ In force voltage analogy, displacement is analogous to, Options are ⇒ (A) current, (B) voltage, (C) charge, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In force voltage analogy, displacement is analogous to, Options are ⇒ (A) current, (B) voltage, (C) charge, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In force voltage analogy, displacement is analogous to
A.	current [Wrong Answer]
B.	voltage [Wrong Answer]
C.	charge [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 4 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ LET JCOKE = 11 and LPEPSI = 19. Consider the statement 13
16
9
14

⇒ The encapsulation of transistor is necessary for
preventing radio interference
preventing photo-emission effects
avoiding loss of free electrons
mechanical ruggedness

⇒ Consider the following statements

Dissipative attenuator has a fixed value of attenuation.
Reflective attenuator has a fixed value of attenuation.
Both dissipative and reflective attenuators are available only with fixed attenuation.
Both dissipative and reflective attenuators are available with either fixed or variable attenuation.

Which of the above are correct?
1 only
1 and 2
1, 2 and 3
4 only

⇒ A differential amplifier consists of two CB amplifiers.
TRUE
FALSE

⇒ (11)₂ + (11)₃ = (11)_?
4
5
6
none

⇒

Assertion (A): 1C 74181 is an ALU in TTL 7400 series.

Reason (R): 1C 74181 can accept two 4 bit words and can perform any one of possible 16 arithmetic or logic operations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller

⇒ In the circuit of fi
V_a would always lag V_b
V_a would always lead V_b
V_a and V_b can be in phase
phase angle between V_a and V_b would always be 90°

⇒ A vertical loop antenna, like a horizontal dipole, is vertically polarised.
TRUE
FALSE

⇒ The most commonly used microphone for public address systems is
carbon
crystal
moving coil
condenser

⇒ A series RC circuit has fixed R and C and variable f. The current locus will lie in the first quadrant.
TRUE
FALSE

⇒ If u is input, y is output and a, b are constants, the system y = au + b
is linear
is nonlinear
may be linear or nonlinear dependig on values of a and b
may be linear or nonlinear depending on value of u

⇒ The integral of k δ(t) is
a step function of magnitude k
a step function 'of magnitude 1/k
a ramp of slope k
a ramp of slope 1/k

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒

Assertion (A): In a CRT, grid is kept at negative potential with respect to cathode.

Reason (R): The function of grid in an electronic tube is to control the number of electrons.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If (10) x x(10)_x = (100)_x; (100)_x x (100)_x = (10000)_x then x can take value
2
5
10
All

⇒ In phase modulation, the phase deviation is
proportional to the amplitude of the signal and varies with frequency
remains constant while amplitude and frequency of signal varies
proportional to the amplitude of the signal and independent of the frequency
none of the above

⇒ If V = 4 in the figure, the value of I_s is give
0.25
5/2 A
0
none

⇒ As compared to an ordinary semiconductor diode, a Schottky diode
has lower cut in voltage
has higher cut in voltage
lower reverse saturation current
both (b) and (c)

⇒ The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6
1.2 kΩ
80 Ω
50 W
0

⇒ A class C amplifier uses
high Q tuned circuit
low Q tuned circuit
untuned circuit
either (b) or (c)

⇒

Assertion (A): Logical group of instructions contains instructions for logic operations.

Reason (R): Data transfer group instruction is basically a copying instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a 3 phase full converter feeding a highly inductive load, the average load current is 150 A. The peak current through thyristor is
150 A
75 A
50 A
300 A

⇒ The magnitude plot of a composite signal x(t) = e^2jt + e^3jt is
Half wave rectified sinusoid
Full wave rectified sinusoid
Exponentially increasing sinusoid
Exponentially decreasing sinusoid

⇒ In pulse width modulation of chopper
T is kept constant and T_on is varied
T_on is kept constant T is varied
both T and T_on are varied
either T or T_on is varied

⇒ Which of the following array names is invalid in Fortran 77?
B(2, 4)
B(M, 3)
B(M, R)
B(3, 6)

⇒ The input to a coherent detector is DSB - SC signal plus noise. The noise at the detector output is
in phase component
quadrature component
zero
the envelope

⇒ If a function has only cosine terms, it must satisfy the equation
f(t) = -f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ In ferromagnetic materials, the orientation between neighbouring permanent dipoles is parallel.
TRUE
FALSE

⇒ The expression given is F(A, B, C, D, E, F, G, H) = Σ(33, 48, 102, 158, 222, 229, 233, 243, 255); then the __________ and __________ minterms are grouped together into dual and variable __________ is reduced using the dual
243, 233, D
222, 158, B
243, 255, A
229, 243, E