Question is ⇒ In 8085, the instruction CMA is an example of, Options are ⇒ (A) Implict addressing, (B) Direct addressing, (C) Register addressing, (D) Immediate addressing, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8085, the instruction CMA is an example of, Options are ⇒ (A) Implict addressing, (B) Direct addressing, (C) Register addressing, (D) Immediate addressing, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8085, the instruction CMA is an example of
A.	Implict addressing [Correct Answer]
B.	Direct addressing [Wrong Answer]
C.	Register addressing [Wrong Answer]
D.	Immediate addressing [Wrong Answer]
View Answer 1 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Circuit switching, Message switching and Packet Switching Network belong to which of the following systems?
Computer communication system
Electromechanical communication system
PBX system
EPBX system

⇒ Which of the following is known as insulated gate FET?
JFET
MOSFET
Both JFET and MOSFET
None of the above

⇒ The frequency at which phase angle is 180° is called
phase crossover frequency
stability limit frequency
frequency of limited stability
gain margin frequency

⇒ A retriggerable one shot is one which
can be triggered only once
has two quasi stable states
can not be retriggered till the complete pulse appears at output
can be retriggered while the output is being generated

⇒ A high level language is less efficient than machine language.
TRUE
FALSE

⇒ The input voltage for starting oscillations in an oscillator is caused by
negative feedback
positive feedback
noise voltage in resistors
a special generator

⇒

Assertion (A): The steady state response, of a stable, linear, time invariant system, to sinusoidal input depends on initial conditions.

Reason (R): Frequency response, in steady state, is obtained by replacing s in the transfer function by jω

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The capacitors C₁, C₃, C₄ and C₅ have a capacitance of 4 μF each and the capacitor C₂ has a capacitance of 10 μF. The effective capacitance (in μF) between the points X and Y will
4 μF
6 μF
3 μF
8 μF

⇒ SSB stands for
Single Side Band
Suppressed Side Band
Single Sound Band
Single Sky Band

⇒ In integral cycle control of ac regulator, the input power factor is equal to
duty cycle a
a²
a
(a)^1/3

⇒ A JFET is a
unipolar device
bipolar device
tripolar device
none of the above

⇒ A loop antenna is a commonly used for
radar
direction finding
satellite communication
all of the above

⇒ As per Euler's identity e^jωt = cos ωt + j sin ωt
TRUE
FALSE

⇒ Which of the following is used in lightning arresters?
Thermistor
Photoconductor
Transistor
Varistor

⇒ The low pass filter characteristic shown in figure realiza
TRUE
FALSE

⇒ An oscilloscope has an input impedance consisting of 1 MΩ and 20 pF is parallel. A high impedance probe connected to input of this oscilloscope has a 10 MΩ series resistance. This 10 MΩ series resistance
may not be shunted
should be shunted by 2 pF capacitor
should be shunted by 20 pF capacitor
should be shunted by 200 pF capacitor

⇒ Two coupled coils have self inductance L₁ and L₂. The coefficients of coupling is k. The mutual inductance is
k L₁L₂
k²L₁L₂
kL₁L₂
kL₁L₂

⇒ An OR gate has 4 inputs. One input is high and the other three are low. The output
is low
is high
is alternately high and low
may be high or low depending on relative magnitude of inputs

⇒ In 8085 microprocessor, a RIM instruction is used to
disable the interrupts 7.5, 6.5, 5.5
enable the interrupts 7.5, 6.5, 5.5
read in the serial input data
none of the above

⇒ For the time domain response shown in figure the
lies in left half plane
lies on imaginary axis
lies along the positive real axis
may be complex or imaginary

⇒ A potential difference is developed across a current carrying metal strip when the strip is placed in a transverse magnetic field. The above effect is known as
Fermi's effect
Photo electric effect
Joule's effect
Hall's effect

⇒ The number of p-n junctions in a semiconductor diode are
0
1
2
1 or 2

⇒ The ratio of diffusion constant for hole D_P to the mobility for holes is proportional to
T²
T
1/T
T³

⇒ The open loop frequency response of a unity feed back system is as u
20 dB and 15°
20 dB and 25°
6 dB and 15°
6 dB and 25°

⇒ The duty cycle of a radar transmitter is equal to
(PRF) (pulse width)
(PRF)/(pulse width)
(pulse width)/(PRF)
(pulse width) + (PRF)

⇒ In a second order undamped system, the poles are on
positive real axis
imaginary axis
negative real axis
either (a) or (c)

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ One of the major applications of JFET is in
switching
constant current-source
constant voltage-source
electron flow regulation

⇒ A constant k low pass filter has f_c = 1000 Hz. At f = 500 Hz, the phase shift is
p
zero
more than p
less than p

⇒ Which distortion is least objectionable in case of audio amplifiers?
Phase distortion
Frequency distortion
Harmonic distortion
Inter-modulation distortion