Question is ⇒ In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about, Options are ⇒ (A) 1.9 k bits/sec, (B) 0.95 k bits/sec, (C) 3.8 k bits/sec, (D) 7.6 k bits/sec, (E) , Leave your comments or Download question paper.

Question is ⇒ In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about, Options are ⇒ (A) 1.9 k bits/sec, (B) 0.95 k bits/sec, (C) 3.8 k bits/sec, (D) 7.6 k bits/sec, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about
A.	1.9 k bits/sec [Correct Answer]
B.	0.95 k bits/sec [Wrong Answer]
C.	3.8 k bits/sec [Wrong Answer]
D.	7.6 k bits/sec [Wrong Answer]
View Answer 4 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
114 kW
336 kW
384 kW
455 kW

⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE

⇒ Double spotting in a receiver is due to
poor sensitivity of RF amplifier
high gain of IF amplifier
inadequate image frequency rejection
all of the above

⇒ The dc output voltage from a power supply
increases with higher values of filter capacitance and decreases with more load current
decreases with higher values of filter capacitance and increases with more load current
decreases with higher values of filter capacitance as well as with more load current
increases with higher values of filter capacitance as well as with more load current

⇒ In a sequential circuit the output at any instant depends on
present inputs only
past inputs only
past outputs only
past output and present input

⇒ A resistance and an inductance are connected in parallel and fed from 50 Hz ac mains. Each branch takes a current of 5 A. The current supplied by source is
0.416666666666667
7.07 A
0.208333333333333
zero

⇒

Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistors

Reason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A dipole antenna was radiating with some excitation in free space radiating a certain amount of the power. If this antenna is immersed in a lake where water is non-dissipative but has a dielectric constant of 81, the radiated power with the same excitation will
decrease to finite non-zero value
remain the same
increase
decrease to zero

⇒ The resistance of a superconductor is
low
very low
very very low
zero

⇒ Which of the following values represents the open loop gain of typical op-amp?
100
10000
100000
1000000

⇒

Assertion (A): A backward wave oscillator can be used as a sweep generator.

Reason (R): The frequency of oscillation of a backward wave oscillator can be changed by varying the voltage which controls the beam velocity.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If a shunt of 200 Ω resistance is used with a galvanometer of 1000 Ω resistance, the multiplying power is
6
5
42740
42741

⇒ Two similar mutually coupled coils have a total inductance of 900 mH and coefficient of coupling 0.5. The self inductance of each coils is
300 mH
150 mH
75 mH
50 mH

⇒ Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time.
TRUE
FALSE

⇒ If a zero is added to a second order underdamped system
the peak overshoot is increased
the peak overshoot is decreased
the peak overshoot remains unchanged
either (a) or (b)

⇒ If N bits are lumped together to get an N-bit symbol, the possible number of symbols is
2^N
2^{N - 1}
2^{N - 2}
2^{N - 4}

⇒ The portion of the atmosphere closest to ground is called ionosphere.
TRUE
FALSE

⇒ If f(t) is in volts, then F(jω) is in
volts
volt seconds
volts/sec
volt-sec²

⇒ In a bipolar junction transistor the base region is made very thin so that
recombination in base region is minimum
electric field gradient in base is high
base can be easily fabricated
base can be easily biased

⇒ An OR gate has 4 inputs. One input is high and the other three are low. The output
is low
is high
is alternately high and low
may be high or low depending on relative magnitude of inputs

⇒ In a colour TV receiver AFT stands for
Automatic Fine Tuning
Automatic Frequency Tuning
Automatic Field Tuning
Alignment Frequency Tuning

⇒ Decimal number 9 in gray code =
1100
1101
110
1111

⇒ A series resonant circuit is capacitive at f = 150 Hz. The circuit will be inductive somewhere at
f greater than 150 Hz
f less than 150 Hz
f equal to 150 Hz by increasing the value of the resistance
none of the above

⇒ Which of the following analog modulation scheme requires the minimum transmitted power and minimum channel bandwidth?
VSB
DSB-SC
SSB
AM

⇒ Magnetic effect of current is used in generators but not in motors.
TRUE
FALSE

⇒ A dynamometer wattmeter can be used for
dc only
ac only
dc and 50 Hz ac
dc and high frequency ac

⇒ In a JK flip-flop, J is connected to Q and K is connected to Q outputs. The JK FF converts into a
RS FF
D FF
T FF
Clocked RS FF

⇒ Which of the following does not apply to Yagi-Uda antenna
High gain
Reasonably good bandwidth
Folded dipole
Parasitic elements

⇒ Figure sho
bipolar transistor
JFET
p-channel MOSFET
n-channel enhancement MOSFET

⇒ An electromagnetic wave is incident normally on a dielectric boundary. It is
totally reflected
partially reflected and partially refracted
totally absorbed
none of the above