Question is ⇒ The force required to initiate motion between two contacting surfaces is called, Options are ⇒ (A) coulomb friction, (B) viscous friction, (C) static friction, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The force required to initiate motion between two contacting surfaces is called, Options are ⇒ (A) coulomb friction, (B) viscous friction, (C) static friction, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The force required to initiate motion between two contacting surfaces is called
A.	coulomb friction [Wrong Answer]
B.	viscous friction [Wrong Answer]
C.	static friction [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When a CE transistor is cut off
voltage across collector reduces to zero
voltage across collector is maximum
maximum collector current flows
maximum voltage appears across the load resistance

⇒ The theoretical power of white noise is
zero
finite
depend upon frequency of signal
infninite

⇒ A choke coil has a resistance to reactance ratio of 0.2. The power factor of the choke coil is
less than 0.2 lagging
less than 0.2 leading
about 1
about 0

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal.
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal.

⇒ As compared to MOS memories, bipolar memories have
slower access time but are cheaper
slower access time and are costly
faster access time and are cheaper
faster access time and are costly

⇒ The resistance values of a PIN diode under positive bias and negative bias respectively are about
a few ohms and a kilo ohms
about 100 ohms and 1000 ohms
about 0.1 ohm and 100 ohms
about 1000 ohms and 10000 ohms

⇒ A transmitter power of 5 W is increased by 20 dB. The effective radiated power is
5 W
100 W
25 W
500 W

⇒ Which of the following is a digital modulation technique?
PCM
PSK
DM
All

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ Which of the following is a valid logical expression in Pascal?
2.5 : = A
(A + B) < < (C + D)
A = < B
A > = B

⇒ A directional coupler is used to determine
r_v
r_v and VSWR
L and C
wave velocity

⇒ Which of the following is basically a voltage controlled capacitance?
Zener diode
Diode
Varactor diode
LED

⇒ Which of the following photodetector does not provide gain?
Phototransistor
Photoconductor
Avalanche photodiode
p-i-n photodiode

⇒ A helical antenna is used for satellite tracking due to its
good front to back ratio
broad bandwidth
circular polarization
both (a) and (b)

⇒ In an AM transmitter after the modulation stage, class C amplifier
can be used
cannot be used
may be used, but it has no use
can't be determine to use

⇒ Consider the follo
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ A zener diode is used in
voltage regulator circuit
amplifier circuits
both voltage regulator and amplifier circuit
none of the above

⇒ Two thyristors of the same rating and specifications
will have equal on state voltage drops
will have equal forward blocking voltage for the same current
will have different on state voltage drops
may have equal or different on state voltage drops and equal or different forward blocking voltage's for the same current

⇒

Assertion (A): Absolute instruments are used in standard laboratories.

Reason (R): Absolute instruments do not require calibration.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ An electromagnetic wave incident on a perfect conductor is
fully transmitted
partially transmitted
entirely reflected
none of the above

⇒ A colour television signal having bandwidth of 4.6 MHz is digitised using 10 bits sample. The digital bit rate used for its transmission with PCM would be __________ kilobits/second.
92000
920
23000
230

⇒ The oscillator shown in figure
Colpitt's oscillator
Hartley oscillator
Tuned emitter oscillator
Clapp oscillator

⇒ A unity feedback system has the following open loop frequency resp
0 dB, -17°
3.86 dB, -180°
0 dB, 10°
3.86 dB, 10°

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The input signal-to noise ratio is
2
10
20
100

⇒ Fourier transform pair are
autocorrelation and power spectral density
autocorrelation and convoloution
convolution and power spectral density
autocorrelation and energy

⇒ The wave propagation occurs without attenuation in case of a
conductor
semiconductor
perfect dielectric
none of the above

⇒ A second-order band-pass active filter can be obtained by cascading a low pass second order section having cut off frequency f_OH with a high pass second order section having cut-off frequency f_OL provided
f_OH > f_OL
f_OH < f_OL
f_OH = f_OL
f_OH ≤ 1/2f_OL

⇒ If eddy current damping is to be used, the disc of instrument should be
non-conducting and non-magnetic
conducting and magnetic
conducting and non-magnetic
non-conducting and magnetic

⇒ A meter has a square law scale. For 2 A current the deflection in 90°. For a deflection of 45°, the current is
0.0416666666666667
1.5 A
1.414 A
1.61 A

⇒ An SUS is
exactly similar to SCR but with higher rating
similar to UJT
PUT and avalanche diode connected in anti parallel
SCR and avalanche diode connected in parallel