Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | For the system of the given figure, the undamped natural frequency of closed loop pole |

A. | 2 rad/sec [Correct Answer] |

B. | 1 rad/sec [Wrong Answer] |

C. | 0.5 rad/sec [Wrong Answer] |

D. | 0.25 rad/sec [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ A Darlington pair has β = 300. If R

_{E}= 1 kΩ and R

_{L}= 100 Ω, the input impedance at the base is approximately

300 k ohm

3 k ohm

100 k ohm

30 k ohm

⇒ For parallel RLC circuit, which one of the following statements is NOT correct?

The bandwidth of the circuit deceases if R is increased

The bandwidth of the circuit remains same if L is increased

At resonance, input impedance is a real quantity

At resonance, the magnitude of input impedance attains its minimum value

⇒ The relation between thermal conductivity K (W/m/°C), heat flow density Q (watt/m

^{2}) and

*d*T/

*dx*(°C per metre) is

Q = K(

*d*T/

*dx*)

Q = - K(

*d*T/

*dx*)

K = Q(

*d*T/

*dx*)

*d*T/

*dx*= - QK

⇒ In which of the following devices can the operation be visualised in terms of a series feedback loops?

TWT

Reflex klystron

Klystron amplifier

Backward wave oscillator

⇒

Match the following:

List I (Instrument) | List II (Parameters) | ||
---|---|---|---|

A. | Moving coil galvanometer | 1. | High inertia, soft spring control |

B. | Ballistic galvanometer | 2. | No control, high damping |

C. | Vibration galvanometer | 3. | Soft spring control, critical damping |

D. | Moving coil flux meter | 4. | Low inertia, tuned spring control |

A-4, B-2, C-3, D-1

A-1, B-3, C-2, D-4

A-2, B-1, C-4, D-3

A-3, B-1, C-4, D-2

⇒ For a Hertz dipole antenna, the Half Power Beam Width (HPBW) in the E-plane is

360°

180°

90°

45°

⇒ When a wave is incident from the more dense into a less dense medium at an angle equal to or exceeding the critical angle, the wave suffers total internal __________ .

reflection

refraction

transmission

none of the above

⇒ A transmitted using AM has in modulated carrier output power of 10 KW and can be modulated to a maximum depth of 90% by a sinusoidal modulating voltage without causing overloading. Find the value to which an modulated carrier power can be increased without resulting in overloading if the maximum permitted modulating index is 40%

14 KW

12.96 KW

26.96 KW

2.96 KW

⇒ If D is diagonal and F is focal length, lens angle θ is

θ = tan

^{-1}(D/F)

θ = 2 tan

^{-1}(D/F)

θ = tan

^{-1}(D/2F)

θ = 2 tan

^{-1}(D/2F)

⇒ In FORTRAN 77 FLOAT (-28) gives the value

28

-28

-28

none of the above

⇒ The most commonly used microphone for public address systems is

carbon

crystal

moving coil

condenser

⇒ Java variables are called

instance variables, class variables and global variables

instance variables, class variables and local variables

instance variables, class variables and sector variables

global variables, class variables and local variables

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will accumulator (A) and carry (CY) contain after ANA A?

A 6 H, 1

A 6 H, 0

00 H, 0

00 H, 1

⇒ Consider the following rules in Fortran

- A signed or unsigned real variable name or a real constant is a real expression.
- Two real expressions connected by an arithmetic operator is a real expression.
- A real variable or constant exponential by an integer constant or integer variable is not valid

All

1 and 2 only

1 and 3 only

2 and 3 only

⇒ In 8 cavity magnetron the p mode corresponds to a total phase shift equal to

± 8 p radians around the periphery

± 4 p radians around the periphery

± 2 p radians around the periphery

± 16 p radians around the periphery

⇒

Match the following:

List I | List II | ||
---|---|---|---|

A. | bit | 1. | 10 |

B. | nat | 2. | e |

C. | decit | 3. | 2 |

A-1, B-2, C-3

A-1, B-3, C-2

A-3, B-2, C-1

A-2, B-3, C-1

⇒ Calculate the wave number in waveguide having dimensions 4 x 2 cm at 3 GHz

6.28

62.8

8

0

⇒ Maximum undistorted power output of a transmitter is obtained when its modulation is __________ percent.

more than 100

100

less than 100

50

⇒ Which of the following noise becomes of great importance at high frequencies?

Transit-time noise

Shot noise

Flicker noise

Agitation noise

⇒ Which of the following is true about an impulse voltage?

It is a unidirectional voltage

Chopped impulse flashover does not occur

Time taken to rise is equal to time taken to fall

RMS value is always less than 50% of average value

⇒ For the system in the given figure, the transfer function C(

*s*)/R(

*s*

G

_{1}+ G

_{2}+ G

_{3}

G

_{1}G

_{2}+ G

_{3}

G

_{1}G

_{2}G

_{3}

(G

_{1}+ G

_{2}) G

_{3}

⇒ In the given fi

0 rad/sec

2 rad/sec

3/2 rad/sec

None of these

⇒ Equation

*x*

_{l0}= 11001001

_{2}when solved for

*x*gives the value of

*x*as

8

111

152

201

⇒ Which chopper circuit operates in quadrants 1 and 4?

A

B

D

E

⇒

**Assertion (A):** In hot wire instrument the material of hot wire in generally platinum iridium.

**Reason (R):** A hot wire ammeter is suitable for ac only

Both A and R are true and R is correct explanation of A

Both A and R are true but R is not correct explanation of A

A is true R is false

A is false R is true

⇒ A signal having uniformly distributed amplitude in the interval (- V to + V) is to be encoded using PCM with uniform quantization. The signal to quantization noise ratio is determined by

dynamic range of signal

sampling rate

number of quantizing levels

power spectrum of signal

⇒ Which of the following is anti-ferromagnetic material?

CrSb

NIO

MnO

All of the above

⇒ The cut off wavelength λ

_{c}for TE

_{20}mode for a standard rectangles waveguide is

2/

*a*

2

*a*

*a*

2

*a*

^{2}

⇒

Match the following:

List I (Oscillator) | List II (Features) | ||
---|---|---|---|

A. | Wien Bridge | 1. | RF oscillator, uses two inductors and one capacitor |

B. | Colpitt's | 2. | LC oscillator for radio frequencies uses three capacitances and one inductance |

C. | Hartley | 3. | RC oscillator for audio frequencies |

D. | Clapp | 4. | RF oscillator, uses two capacitances and one inductance |

A-2, B-1, C-4, D-3

A-2, B-4, C-1, D-3

A-3, B-4, C-1, D-2

A-3, B-1, C-4, D-2

⇒ Which of the following microphones has lowest output impedance?

Moving coil

Ribbon

Crystal

Condenser