Question is ⇒ A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be, Options are ⇒ (A) 20 ∠20° A, (B) 10 ∠20° A, (C) 14.14 ∠20° A, (D) 10 ∠- 20° A, (E) , Leave your comments or Download question paper.

Question is ⇒ A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be, Options are ⇒ (A) 20 ∠20° A, (B) 10 ∠20° A, (C) 14.14 ∠20° A, (D) 10 ∠- 20° A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be
A.	20 ∠20° A [Correct Answer]
B.	10 ∠20° A [Wrong Answer]
C.	14.14 ∠20° A [Wrong Answer]
D.	10 ∠- 20° A [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit figure LED will be on when v_{1less than 6 V
more than 6 V
less than 12 V
more than 12 V}

⇒

Assertion (A): A small section of high impedance line is equivalent to a series inductance.

Reason (R): A small section of a low impedance line is equivalent to a series resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The radiation pattern of a parabola antenna is
omnidirectional
a figure of directional
highly directional
none of the above

⇒ In register index addressing mode the effective address is given by
index register value
sum of the index register value and the operand
operand
difference of the index register value and the operand

⇒ HVDC transmission systems generally use
12 pulse converters
6 pulse converters
3 pulse converters
either 12 or 6 pulse converters

⇒ If we need a device to shut off a few ampere current in a few nano seconds, the proper devices is
VMOS
CMOS
BJT
UJT

⇒ The current through a PN Junction diode with v volts applied to the P region to the N region, where (I₀ is the reverse saturation current to the diode, m the ideality factor, k the Boltzmann constant, T the absolute temperature and q the magnitude of charge on an electron) is
I₀ (e^-qv/mkT - 1)
I₀ e^-qv/mkT
I₀ (1 - e^qv/mkT)
I₀ (e^qv/mkT - 1)

⇒ Which of the following is correct in FORTRAN 77?
PARAMETER PMOS = 9.8, NMOS = X
PARAMETER (PMOS = 9.8, NMOS = X)
PARAMETER PMOS = 9.8, NMOS = X
PARAMETER PMOS, NMOS = 9.8, X

⇒ The materials not having negative temperature coefficient of resistivity are
metals
semiconductors
insulators
none of the above

⇒ The ripple factor for a bridge rectifier is
0.406
1.21
1.11
2.22

⇒ In the circuit of figure, PIV can be u
E_m
2 E_m
0.5 E_m
2 E_m

⇒ F = ∑(0, 3, 4, 5, 7) =
[B ⊕ C] + AC
B'C' + BC + AC
AB + BC + CA
None

⇒ For determining the network functions of a two-port network, it is required to consider that
all initial conditions remain same
all initial conditions are zero
part of initial conditions are equal to zero
initial conditions vary depending on nature of network

⇒ If f is the frequency of electromagnetic wave, f_c is cutoff frequency, then in a rectangular waveguide
attenuation is low when f > f_c
attenuation is low when f < f_c
attenuation is high when f < f_c
either (b) or (c)

⇒ The electric field on the surface of a perfect conductor is 2V/m. The conductor is immersed in water with ε = 80 ε₀. The surface charge density on the conductor is ((ε₀ = 10^-9/36p)F/m)
0 c/m²
2 c/m²
1.8 x 10^-11 c/m²
1.14 x 10^-9 c/m²

⇒

Assertion (A): In a parallel in-serial out shift register data is loaded one bit-at a time

Reason (R): A serial in-serial out shift register can be used to introduce a time delay.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ To measure dielectric loss you would use
Anderson bridge
Kelvin bridge
Schering bridge
Maxwell's bridge

⇒

Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.

Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following is likely to be associated with FM radio broadcasting?
90 Hz
90 kHz
900 kHz
90 MHz

⇒

Assertion (A): A Darlington amplifier has very low output impedance

Reason (R): The circuit has a low resistance R_E between emitter and ground

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Out of latch and flip flop, which has clock input?
Latch only
Flip flop only
Both latch and flip flop
None

⇒ Windows have a user friendly program called 'Front Page Express' for creating web pages.
TRUE
FALSE

⇒ Power factor of the following circuit will be unity
inductance
capacitance
resistance
both (a) and (b)

⇒ For a P-N junction diode, the current in reverse bias may be
few amperes
between 0.5 A and 1 A
few milliamperes
few micro or nanoamperes

⇒ In PCM the amplitude levels are transmitted in a 7 unit code. Sampling frequency is 10 kHz. The bandwidth should be
5 kHz
35 kHz
70 kHz
5 MHz

⇒ The following properties are associated with ferroelectric materials:

Its susceptibility is negative.

The susceptibility is expresse
1 only
1 and 3
2 only
1, 2 and 3

⇒ Read cycle is always followed by (during instructions execution)
read cycle
write cycle
delete signal
none of these

⇒ The maximum effective aperture of an antenna which is operating at wavelength of 2 m and has a directivity of 100 is __________ .
15.92
31.84
3.184
1.592

⇒ In high frequency region, an amplifier behaves like a
band pass filter
low pass filter
high pass filter
any of the above

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10