Question is ⇒ The RF section of a radio transmit generally consists of, Options are ⇒ (A) master oscillator, (B) final power amplifier to feed antenna, (C) buffer stage, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The RF section of a radio transmit generally consists of, Options are ⇒ (A) master oscillator, (B) final power amplifier to feed antenna, (C) buffer stage, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The RF section of a radio transmit generally consists of
A.	master oscillator [Wrong Answer]
B.	final power amplifier to feed antenna [Wrong Answer]
C.	buffer stage [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An I/O processor control the flow of information between
cache memory and I/O devices
main memory and I/O devices
1 Two I/O devices
cache and main memories

⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111

⇒ A JFET
is current controlled device
has low input resistance
has high gate current
is a voltage controlled device

⇒ (SI - A)^-1 = adj(sI - A)/det (sI - A)
TRUE
FALSE

⇒ A phasor is
a line representing the magnitude and direction of an alternating quantity
a line which represents the magnitude and phase of an alternating quantity
an instrument used for measuring phases of an unbalanced 3-phase load
a coloured tag or band for distinguishing between different phases of a 3-phase supply

⇒ Transconductance characteristics of JFET depict the relation between
I_D and V_GS for different value of V_DS
I_D and V_DS for different value of V_GS
V_GS and V_DS for different values of I_D
V_DS and I_D for different values of V_GS

⇒ For transistor 2 N 338 the manufacturer specifies P_max = 100 mW at 250°C free air temperature and maximum junction temperature of 125°C. Its thermal resistance is
10° C/W
100° C/W
1000° C/W
5000° C/W

⇒ The emission of light is LED due to
emission of holes
emission of electrons
generation of electromagnetic radiations
conversion of heat energy into illumination

⇒ Varactor diodes use
silicon
GaAs
either (a) or (b)
neither (a) nor (b)

⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above

⇒ Which of the following Boolean Expression correctly represents the relation between P, Q, R and M_{1M₁ = (P OR Q) XOR R
M₁ = (P AND Q) XOR R
M₁ = (P NOR Q) XOR R
M₁ = (P XOR Q) XOR R}

⇒ In which of the following 8085 instructions no condition flags are affected?
INX rp
INR r
SBI data
INR M

⇒ The constant magnitude of G(s) plane are
a family of straight horizontal lines
a family of straight inclined lines with positive slope
a family of straight inclined lines with negative slope
a family of circles

⇒ In a bipolar junction transistor the base region is made very thin so that
recombination in base region is minimum
electric field gradient in base is high
base can be easily fabricated
base can be easily biased

⇒ In figure the output V₀
2V₁ + V₂ - 2V₃
2(V₁ + V₂) - V₃
V₁ + V₂ + V₃
V₁ + 2V₂ - V₃

⇒ Half power point directions for broadside is
60°
30°
45°
at any angle

⇒ As the diameter of a wire is doubled, the resistance becomes
twice
one half
one fourth
four times

⇒ Am equivalent 2's complement representation of the 2's complement number 1101 is
110100
1101
110111
111101

⇒ Which of the following pulse-time modulation is least used?
PDM
PPM
PWM
PAM

⇒ Zoning is used with a dielectric antenna in order to
permit pin-point focusing
reduce the bulk of the lens
increase the bandwidth of the lens
correct the curvature of the wavefront from a horn that is too short

⇒ Which of the following is a circularly polarized antenna?
Horn
Dipole
Helical
Pyramidal

⇒

Assertion (A): A band elimination filter attenuates signals whose frequencies lie between the cutoff frequencies.

Reason (R): A band elimination circuit is very different from band pass circuit.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For attenuation of low frequencies we should use
shunt capacitance
series capacitance
shunt inductance
series inductance

⇒ The following circuit is implementation of:

sum of full adder

carry of half adder

difference of full subtractor

1 only
3 only
2 only
1 and 2 both

⇒ Capacitive transducer is superior to inductive type for measurement of capacitance because of
absence of non-linearity
high frequency response
small size
high accuracy

⇒ A material has conductivity of 10^-2 mho/m and a relative permittivity of 4. The frequency at which conduction current in the medium is equal to displacement current is
45 MHz
90 MHz
450 MHz
900 MHz

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ A zero mean white Gaussian noise is passed through an ideal low pass filter of bandwidth 10 kHz. The output of the samples so obtained would be
correlated
statistically independent
uncorrelated
orthogonal

⇒ Fourier transform of non periodic DT signal is
aperiodic
Periodic
both a and b
None of these

⇒ Which of the following is a digital modulation technique?
PCM
PSK
DM
All