Question is ⇒ An m derived low pass filter has fc = 1000 Hz, f∞ = 1250 Hz and m = 0.6. If m is increased, then, Options are ⇒ (A) both fc and f∞ will increase, (B) both fc and f∞ will decrease, (C) fc will remain constant but f∞ will decrease, (D) fc will remain constant but f∞ will increase, (E) , Leave your comments or Download question paper.

Question is ⇒ An m derived low pass filter has fc = 1000 Hz, f∞ = 1250 Hz and m = 0.6. If m is increased, then, Options are ⇒ (A) both fc and f∞ will increase, (B) both fc and f∞ will decrease, (C) fc will remain constant but f∞ will decrease, (D) fc will remain constant but f∞ will increase, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An m derived low pass filter has f_c = 1000 Hz, f_∞ = 1250 Hz and m = 0.6. If m is increased, then
A.	both f_c and f_∞ will increase [Wrong Answer]
B.	both f_c and f_∞ will decrease [Wrong Answer]
C.	f_c will remain constant but f_∞ will decrease [Wrong Answer]
D.	f_c will remain constant but f_∞ will increase [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As per Shannon-Hartley theorem, a noise less Gaussian channel has
zero capacity
infinite capacity
small capacity
none of the above

⇒ In radio receivers, the value of IF is
100 kHz
225 kHz
455 kHz
850 kHz

⇒

Assertion (A): In angle modulation the transmitted amplitude is constant.

Reason (R): Angle modulation has good immunity to noise and interference.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An op-amp has
low input and output impedance
low input impedance and high output impedance
low output impedance and high input impedance
high output impedance and high input impedance

⇒ Which of the following circuits come under the class of combinational logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 only
3 and 4
4 and 5
1, 2 and 3

⇒ A capacitor is considered to be completely charged in __________ time constant.
one
three
five
eight

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured at the highest crossover frequency.
TRUE
FALSE

⇒ The classes of solid dielectrics are
A, B, C, D, E, F, H
A E B F H C D
Y A E B F H C
A E B F H C

⇒ Which one of the following is a D to A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒ In a two tone AM system the two modulating frequencies are 2000 p and 4000 p rad/sec. If carrier frequency is 2p x 10⁶ rad/sec the frequencies of upper sidebands are
1.002 MHz and 1.004 MHz
1.001 MHz and 1.002 MHz
1.001 MHz and 1.004 MHz
1.002 MHz and 1.008 MHz

⇒ The greatest negative number which can be stored is 8 bit computer using 2's complement arithmetic is
-256
-128
-255
-127

⇒ The load end of a quarter wave transformer gets disconnected thereby causing an open-circuited load. What will be the input impedance of the transformer?
Zero
Infinite
Finite and Positive
Finite and Negative

⇒ A n-channel JFET has I_DSS = 2 mA, Gate to source voltage V_GS = - 2 V and trans-conductance is 0.5 mW then pinch-off voltage is __________ .
- 2 V
2 V
- 4 V
4 V

⇒ Symbol shown in figure represen
P-channel enhancement MOSFET
N-channel DEMOSFET
UJT with P-type base
UJT with N-type base

⇒ The density of dynamic RAM is
the same as static RAM
less than that of static RAM
more than that of static RAM
either equal or less than that of static RAM

⇒ The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figur
L₁ + L₂ + M
L₁ + L₂ - M
L₁ + L₂ + 2M
L₁ + L₂ - 2M

⇒ Of the various capacitances associated with a junction transistor the gain bandwidth product is affected to maximum extend by
base collector parasitic capacitor
base collector space charge layer capacitance
base emitter space charge layer capacitance
base emitter diffusion capacitance

⇒ A single phase series converter is used for
high voltage output
high current output
high voltage and high current output
improving the circuit efficiency

⇒ Consider the following statements as regards noise

If Gaussian noise is applied at input of a rectifier, the output is not gaussian
The noise encountered on a telephone line consists of short, pulse type disturbances whose amplitude distribution is not Gaussian
Shot noise results from random emission of electrons from a cathode
Shot noise results from phenomenon associated with the flow of current across semi conductor junctions

Which of the above are correct?
1, 2, 3, only
1, 2, 4 only
1, 2, 3, 4
2, 3 only

⇒ Which among the following waveforms can be reconstructed from its samples without distort
1 and 2
2 and 3
1 and 3
Only 2

⇒ The problem of logic race occurs in
SOP functions
POS functions
Hybrid function
SOP and POS functions

⇒ Which of the following integer expressions is incorrect in Pascal?
L div M + P
A * * B
A div B - C
A mod B

⇒ In which of the following circuits is op-amp used in open loop configuration?
Comparator
Summing amplifier
Integrating amplifier
Logarithmic amplifier

⇒ When analysing two port networks in parallel it is more convenient to use
z parameters
h parameters
T parameters
y parameters

⇒ As compared to their values in free space
velocity of electric wave in dielectric is smaller but wave length of electric wave is more
both velocity and wave length of electric wave in dielectric are higher
both velocity and wave length of electric wave in dielectric are smaller
wave length of electric wave is less but velocity is more in dielectric

⇒ Ideally an attenuator pad should not change
voltage level
impedance level
power level
voltage, power or impedance level

⇒ Which inductor is used at high frequencies?
Cast iron cored
Sheet steel cored
Iron alloy cored
Ceramic cored

⇒ Which one is time invariant system?
y[n] = x[2n]
y[n] = x[n] x[n - 1]
y[n] = x[n/2]
all

⇒ The amplitude of a modulated RF aerial current is 6 A on the peaks of modulation and 4 A on the troughs of modulation. The value of carrier amplitude is
5
15
20
30

⇒ Nichrome is used in
heater coils
underground cables
overheated wires
lamp filament