Question is ⇒ The rate of change of digital signals between High and Low level is, Options are ⇒ (A) very fast, (B) fast, (C) slow, (D) very slow, (E) , Leave your comments or Download question paper.

Question is ⇒ The rate of change of digital signals between High and Low level is, Options are ⇒ (A) very fast, (B) fast, (C) slow, (D) very slow, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The rate of change of digital signals between High and Low level is
A.	very fast [Correct Answer]
B.	fast [Wrong Answer]
C.	slow [Wrong Answer]
D.	very slow [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the given fi
42737
42739
2
1

⇒ A half adder can be used only for adding
1 s
2 s
4 s
8 s

⇒ In the signal flow graph of figure below, the gain C/R will
43048
22/15
24/23
44/23

⇒ The input impedance of short-circuited line of length l where λ/4 < l < λ/2, is
resistive
inductive
capacitive
none of the above

⇒ In a P-N-P transistor, with normal bias
the collector junction has negligible resistance
only holes cross the collector junction
the collector-base junction is reverse biased and the emitter base junction is forward biased
only majority carriers cross the collector junction

⇒ If e = 110 sin (ωt + p/3) and i = 5 sin (ωt - p/3), the impedance of the circuit is
22 Ω
16 Ω
30.8 Ω
11 Ω

⇒ For parallel plane waveguides, which is the mode with lowest cut-off frequency?
TE₁₀
TM₁₀
TEM
TE₁₁

⇒

Assertion (A): For a reciprocal microwave junction the S matrix is symmetrical.

Reason (R): In a symmetrical matrix S_ij = S_ji.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If we need a low noise device, we should use
BJT
FET
thyristor
UJT

⇒ DOS has a command named ' DIRECTORY '.
TRUE
FALSE

⇒ A 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ then Resolution in percent and volt is __________ .
1%, 1 mv
10%, 10 mv
10%, 1 mv
1%, 10 mv

⇒ CMOS is widely used in
digital wrist watches
analog circuits
high power circuits
all of the above

⇒ The input impedance of CRO is about
zero
10 Ω
100 Ω
one mega ohm

⇒ In a certain inverter circuit each thyristor carries 26.67 A for 60°, 13.33 A for 120° and zero A for 180° of the cycle. The rms current of thyristor is
20 A
13.33 A
6.67 A
3.33 A

⇒ In bridge circuit of figure, equivalent resistance between A and B
1 Ω
0.5 Ω
2 Ω
1.5 Ω

⇒ Energy density function is always
even
odd
neither even nor odd
both (a) and (b)

⇒ If a sample of germanium and a sample of silicon have the same impurity density and are kept at room temperature
both will have equal value of resistivity
both will have equal negative resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than that of germanium

⇒ At resonance the network function magnitude will be
k/a
k/b
c
k/a + b

⇒

Match the following:

	List I		List II
A.	R = 0	1.	Undamped oscillation
B.	R < 2 L/C	2.	Damped oscillation
C.	R = 2 L/C	3.	Critically damped response
D.	R > 2 L/C	4.	Non-oscillatory response.

A-1, B-2, C-3, D-4
A-1, B-4, C-3, D-2
A-3, B-2, C-1, D-4
A-3, B-4, C-1, D-2

⇒ The Nyquist plo
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the second quadrant
will start from (ω = ∞) in the fourth quadrant and will terminate (ω = 0) in the second quadrant
will start form (ω = ∞) in the second quadrant and will terminate (ω = 0) in the fourth quadrant
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the fourth quadrant

⇒ A 4 bit shift register is initialized to value 1000 for (Q₃, Q₂, Q₁, Q₀). The D input is derived from Q₀, Q₂ and Q₃ through two XOR gates as shown in figure. The pattern 1000 will appea
3rd pulse
7th pulse
6th pulse
4th pulse

⇒ Diffraction of electromagnetic waves
may occur around the edge of a sharp obstacle
is caused by reflections from the ground
arises only with the spherical wave fronts
will occur when the waves pass through a large slot

⇒ In a tuned class C power amplifier the quiescent value of collector to emitter voltage is equal to (V_CC denotes collector battery voltage)
V_CC
0.5 V_CC
0.25 V_CC
either (b) or (c)

⇒ Which of the following statements is correct?
In the magnetic circuit energy is needed continuously to maintain the flux
In the magnetic circuit energy is needed continuously to maintain the flux
The flow of current in the electric circuit involves discontinuous expedition of energy
The flow of current in the electric circuit requires energy for creating the current but not to maintain it

⇒ In a series resonant circuit, the resonant frequency is
geometric mean of half power frequencies
arithmetic mean of half power frequencies
difference of half power frequencies
none of the above

⇒ If RADIUS = 3.0 the result of the following FORTRAN 77 program will be 1.5708
1
28.2744
18

⇒ Which of following antenna produces elliptical polarisation?
Helical
Parabolic
Dipole
None

⇒ The multiplication time for 10-bit numbers with 1 MHz clock will be
32 μ sec
20 μ sec
21 μ sec
22 μ sec

⇒ What would be the reading of voltmeter as shown in below figure. The voltmeter has a 0-1 V scale and is a 20000 Ω/V me
0.4545 V
0.082 V
0.82 V
4.54 V

⇒ An advantage of memory interlacing is that
a larger memory is obtained
effective speed of memory is increased
cost of memory is reduced
a non-volatile memory is obtained