Question is ⇒ Thevenin's theorem is used to find current in a branch of a network. It is now desired to find current in another branch of the network, Options are ⇒ (A) the same Thevenin's circuit can be used, (B) the same Thevenin's circuit with some modification can be used, (C) it is necessary to find new Thevenin's circuit, (D) either (b) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ Thevenin's theorem is used to find current in a branch of a network. It is now desired to find current in another branch of the network, Options are ⇒ (A) the same Thevenin's circuit can be used, (B) the same Thevenin's circuit with some modification can be used, (C) it is necessary to find new Thevenin's circuit, (D) either (b) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Thevenin's theorem is used to find current in a branch of a network. It is now desired to find current in another branch of the network
A.	the same Thevenin's circuit can be used [Wrong Answer]
B.	the same Thevenin's circuit with some modification can be used [Wrong Answer]
C.	it is necessary to find new Thevenin's circuit [Correct Answer]
D.	either (b) or (c) [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Gauge factor of a strain gauge is
unit change in resistance per unit change in length
change in resistance per unit change in length
unit change in length per unit change in resistance
none of the above

⇒ The antenna diameter of a radar system is doubled. The maximum range will
be doubled
become four times
be halved
decrease to one fourth

⇒ Silicon diodes have __________ reverse resistance than germanium diodes.
a much smaller
a much larger
an infinite
a negligible

⇒

Match the following:

	List I (Set operation)		List II (Set operator)
A.	Set equality	1.	-
B.	Set inclusion	2.	=
C.	Set intersection	3.	< =
D.	Set difference	4.	∗

A-2, B-3, C-4, D-1
A-3, B-2, C-4, D-1
A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1

⇒ The voltage across a zener diode
is constant in forward direction
is constant in reverse direction
is constant in both forward and reverse directions
none of the above

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	? :	1.	Modulus
B.	[ ]	2.	Array expression
C.	%	3.	Conditional

A-3, B-2, C-1
A-1, B-2, C-3
A-1, B-3, C-2
A-2, B-3, C-1

⇒ In 8085 the pins for + 5 V input and ground are
20 and 40 respectively
40 and 20 respectively
1 and 2 respectively
1 and 1 respectively

⇒ The resistance of a standard conductor.
increases with frequency
same for ac and dc
increases with frequency
increases as square root of frequency

⇒ Time delay of a TTL standard family is about
180 ns
50 ns
18 ns
3 ns

⇒ Consider the following statements

An assembler is a program having assembly language program as input and machine language program as output.
A macro assembler is an assembler with additional macro facilities.
A cross assembler for a μP X is an assembler which executes on source microcomputer with a different CPU than X bit generates code for X.
Assemblers generally do not provide macro facilities.

Of the above statement
All are correct
only 1, 2, 3 are correct
only 1, 2, 4 are correct
only 1, 3, 4 are correct

⇒ In a class C amplifier, full cycle conductor of the current is achieved by employing
tuned circuit
transformers
complementary pair
Push pull configuration

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ If INT = 50 and LOOT = 30, the result of assignment statement SAL = INT + LOOT is
50
80
8
5

⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies

⇒ In a communication system, noise is most likely to affect the signal
at the receiver
at the transmitter
at the information source
in the channel

⇒ For a reactance function H(s)
Re [H(jω)] is positive for ω ≥ 0
Re [H(jω)] is zero for ω ≥ 0
Re [H(jω)] is positive or zero for ω ≥ 0
Re [H(jω)] is zero or negative for ω ≥ 0

⇒ A step up chopper can give an output voltage
higher than input voltage
lower than input voltage
both higher and lower input voltage
all of the above

⇒ Consider the following statements about Java variables

Java variable must start with a letter or underscore or dollor sign.
Java variable can not start with a digit.
After the first character the variable can have any combination of letters or numbers.
Capitalization of letters must be consistent.

Which of the above are correct?
All
1, 2 and 3 only
2, 3, 4 only
1, 2 and 4 only

⇒ The realization of the term Ks yields
a resistance of value K ohms
a capacitances of value K farads
an inductance of value k farads
either (b) or (c)

⇒ A typical signal strength received from a geosynchronous communication satellite is of the order of a few
milliwatts
kilowatts
picowatts
watts

⇒ A person with a receiver is 5 km away from the transmitter. What is the distance that this person must move further to detect at 3 dB decrease in signal strength?
942 m
2070 m
4978 m
5320 m

⇒ While using Maxwell bridge, the Q factor of a coil is obtained as
1/ωCR
ωCR
ωC/R
R/ωC

⇒ As compared to tuned radio frequency receivers which of the following is the advantage of using superheterodyne receivers?
High gain and better sensitivity
Better selectivity at high frequencies
Stability
Noise suppression

⇒ A parallel plate capacitor with air as dielectric has a capacitance C. If the dielectric has a dielectric constant ∈_r and the remaining dimensions are the same, the capacitance will be
C/∈_r
∈_rC
∈²_rC
∈³_rC

⇒ Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.
TRUE
FALSE

⇒ In an ac circuit, the maximum and minimum values of power factor can be
2 and 0
1 and 0
0 and -1
1 and -1

⇒ The circuit of the given figure gives the output YAB
A + B
A B
A + B

⇒ An MTI compares a set of received echos with those received during the previous sweep.
TRUE
FALSE

⇒ The magnetic quantum number determines the component of angular momentum along a prescribed direction.
TRUE
FALSE

⇒ Consider the following stateme
1 and 2
2 and 3
3 and 4
4 and 5

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math