Question is ⇒ The instrument used to check insulation of household wiring is, Options are ⇒ (A) megger, (B) ohmmeter, (C) multimeter, (D) high resistance voltmeter, (E) , Leave your comments or Download question paper.

Question is ⇒ The instrument used to check insulation of household wiring is, Options are ⇒ (A) megger, (B) ohmmeter, (C) multimeter, (D) high resistance voltmeter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The instrument used to check insulation of household wiring is
A.	megger [Correct Answer]
B.	ohmmeter [Wrong Answer]
C.	multimeter [Wrong Answer]
D.	high resistance voltmeter [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒ In figure, the capacitor is charged to 1 V. At t = 0 the switch is closed so that i = e^-t. When i = 0.37 A, the voltage across capacito
1 V
0.63 V
0.37 V
0.185 V

⇒ Ferromagnetic materials exhibit
a linear B-H behaviour
a non-linear B-H behaviour
an exponential B-H behaviour
none of the above

⇒ A half adder adds
2 bits
3 bits
4 bits
2 or 3 bits

⇒ Consider the following statement: In case of a superconductor

B = 0
μ_r is high
diamagnetism is high
transition temperature varies with isotopic mass.

Of the above statements
1 and 2 are correct
2, 3, 4 are correct
1, 3, 4 are correct
2, 4 are correct

⇒ Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹⁰ per cm³. Take μ_e = 1500 cm²/V-sec, μ_h = 500 cm²/V-sec at room temperature,
5.12 x 10^-16
5 x 10⁺¹⁶
10¹⁶
5 x 10²⁰

⇒ A signal g(t) = A then g(t) is a
energy signal
power signal
neither energy nor power signal
insufficient data

⇒ It is required to measure the true open circuit emf of a battery. The best device is
dc voltmeter
ammeter and known resistance
dc potentiometer
either (a) or (c)

⇒

Match the following:

	List I (Operator in C)		List II (Priority of Operation)
A.	!	1.	1
B.	< >	2.	2
C.	∗	3.	3
D.	=	4.	4

A-1, B-2, C-3, D-4
A-1, B-3, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4

⇒ In a synchro transmitter
input is angular position of rotor shaft and output is stator voltages
input is stator voltages and output is angular position of shaft input is rotor voltage and output is angular position of rotor shaft
input is rotor voltage and output is angular position of rotor shaft
input is angular position of rotor shaft and output is rotor voltage

⇒ Which of the following is a valid integer variable in FORTRAN 77?
ALPHA
NEXT
BANGLORE
ABC

⇒ A frequency multiplier stage should operate as
class A
class AB
class C
either of the above

⇒ A temperature sensistive transducer is subjected to sudden temperature change. It takes 10 seconds for transducer to reach equilibrium condition (five times time constant). The time taken to reach half of temperature difference will be
1.38 s
5 s
8.62 s
0.9 s

⇒ Assuming that k is an integer what would the result of following expression
8
7
7.5
zero

⇒ The v-i characteristics of a diode may be linear or non linear.
TRUE
FALSE

⇒ Consider the following statements about instrument landing system of aircraft

It ensures correct landing under conditions of low visibility.
It consists of runaway localizer, glide path equipment and marker beacons.
It is basically a blind landing system.

Which of above statements are correct?
All
1 and 2 only
1 and 3 only
2 only

⇒ In the given figure the line voltage after a number of reflections wil
30 V
-30 V
10 V
-10 V

⇒ Choose the correct statement/statements :
In case of an antenna, the antenna resistance and loss resistance are not two different quantities.
The loss resistance includes loss by eddy currents, improper earth connections, insulation leakages, etc., but not I²R losses.
Radiation resistance varies directly as square-root of frequency
None

⇒ In a radar system the solution to blind speed problem is to
use MTI
use monopoles
vary PRF
change Doppler frequency

⇒ What will be minimum conversion rate in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9000
9259
1000
1000

⇒ Vectored interrupt is an interrupt that takes the program to a vector location. TRAP vectors to 0024 FI, RST 7.5 to 003 CH, RST 6.5 to 0034 H and
RST 5.5
RST 6.5
24 H to 48 H
RST 5.5 to 002 CH

⇒ In cable TV local programmes can be telecast at any frequency.
TRUE
FALSE

⇒ Which of the following is the poorest conductor of electricity?
Copper
Aluminium
Manganin
Nichrome

⇒ When a diode is not conducting, its bias is
forward
zero
reverse
zero or reverse

⇒ Find resistance R_B to bring transistor to threshold of saturation (V_CB = 0), V_BE = 0.7 V, a =
1.5 KΩ
15 KΩ
10 KΩ
1 KΩ

⇒ The bandwidth of an amplifier can be reduced by
miller effect compensation
pole zero compensation
dominant pole compensation
lead compensation

⇒

Assertion (A): In a serial in-serial out shift register, access is available only to the left most or right most flip flops

Reason (R): If the output of a shift register is feedback to serial input it can be used as a ring counter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ (FE35)₁₆ XOR (CB15)₁₆ is equal to
(3320)₁₆
(FE35)₁₆
(FF50)₁₆
(3520)₁₆

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The current amplification is
2.5
12.5
25
125

⇒ Figure repres
Adder
Multiplier
Subtractor
Log Amplifier