Question is ⇒ In a FM waveform, the side bands are spaced at intervals equal to, Options are ⇒ (A) four times the modulating frequency, (B) twice the modulating frequency, (C) half the modulating frequency, (D) modulating frequency, (E) , Leave your comments or Download question paper.

Question is ⇒ In a FM waveform, the side bands are spaced at intervals equal to, Options are ⇒ (A) four times the modulating frequency, (B) twice the modulating frequency, (C) half the modulating frequency, (D) modulating frequency, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a FM waveform, the side bands are spaced at intervals equal to
A.	four times the modulating frequency [Wrong Answer]
B.	twice the modulating frequency [Wrong Answer]
C.	half the modulating frequency [Correct Answer]
D.	modulating frequency [Wrong Answer]
View Answer 5 -5 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following applications

Switch
Attenuator
Phase shifter
Oscillator

In which of the above can a PIN diode be used?
1 2 3 and 4
1 2 and 3 only
1 and 2 only
2, 3 and 4 only

⇒ Which of the following are the memory performance parameters?

Access time and latency
Block size and Block access time
Cycle time and Bandwidth

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ The derivative of unit step function is
unit impulse
ramp with slope 1
impulse
either (a) or (b)

⇒ A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?
n remains constant over the temperature range
n increases monotonicaliy with increasing temp
n increases first remains constant over a range and again increases with increasing temperature
n increases show a peak and then decrease with temperature

⇒ Which one of the following is the correct sequence of the numbers represented in the series given below?
2, 3, 4, 5, 6......
2, 4, 6, 8, 10 .....
2, 4, 6, 10, 12......
2, 4, 6, 10, 16 .....

⇒

Match the following:

	List I		List II
A.	Reflex Klystron	1.	High efficiency
B.	Dielectric loaded wave guide	2.	Slow wave structure
C.	TWT	3.	Cross field device
D.	Multi Cavity Klystron	4.	Oscillator

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-4, C-1, D-3
A-3, B-1, C-4, D-2

⇒ A pulse train can be delayed by a finite number of clock periods by using
serial in-serial out shift register
parallel in serial out shift register
serial in-parallel out shift register
parallel in parallel out shift register

⇒ A₁₆ X 2₁₆ __________ .
16₁₆
15₁₆
14₁₆
13₁₆

⇒ In an FM signal, the power
increases as the modulation index increases
reduces as the modulation index increase
increases as the modulation index decreases
remains constant when the modulation index increases

⇒ The collector voltage V_C of the circuit shown in the given figure aside is approxima
2 V
4.6 V
8 V
8.6 V

⇒ Which of the following is correct in FORTRAN 77?
PARAMETER PMOS = 9.8, NMOS = X
PARAMETER (PMOS = 9.8, NMOS = X)
PARAMETER PMOS = 9.8, NMOS = X
PARAMETER PMOS, NMOS = 9.8, X

⇒ Compared to bipolar junction transistor, a JFET has
lower input impedance
high input impedance and high voltage gain
higher voltage gain
high input impedance and low voltage gain

⇒ If the transmission parameters of the given networks are A = C = 1, B = 2 and D = 3, then the value of Z_{m12/13 Ω
13/12 Ω
3 Ω
4 Ω}

⇒ The colour coding of a resistors shows 100 K, ± 10%. When the resistance was measured with an ohmmeter, it read
95 K
80 K
120 K
85 K

⇒ Which of the following characteristics is not true for TTL Logic?
Good speed
Low power dissipation per gate
High cost
None of these

⇒ Electromagnetic cavity resonators (energy storage devices) are used in
wave meters
bandpass filters
high frequency tubes
all of the above

⇒ Which of the following values represents the open loop gain of typical op-amp?
100
10000
100000
1000000

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒ In 8085 microprocessor, what is the memory word addressing capability?
32 K
64 K
256 K
512 K

⇒ The input 3-dB frequency is :
100 Hz
148 Hz
100 kHz
None

⇒ In telecast
video and audio signals are frequency modulated
video signals are frequency modulated but audio signals are amplitude modulated
both audio and video signals are amplitude modulated
video signals are amplitude modulated and audio signals are frequency modulated

⇒ When a p-n-p transistor is operating in active region, the current in the n region is due to
only holes
only electrons
mainly holes
mainly electrons

⇒ Which of the following is invalid in Basic?
A ** B - C
5.2 ** 4.3
5.2 ** (- 4.3)
(- 5.2) ** (4.3)

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The input voltage to the amplifier is
0.1 m V
0.4 m V
1 m V
4 m V

⇒ In an ideal junction transistor the impurity concentration in emitter (E ), base (B) and collector (C) is such that
E > B > C
B > C > E
C > E > B
C = E = B

⇒ To find current in a resistance connected in a network, Thevenin's theorem is used V_TH = 20 V and R_TH = 5 Ω. The current through the resistance
is 4 A
is 4 A or less
is less than 4 A
may be 4 A or less or more than 4 A

⇒ Consider the program segment written for 8085 based sys
41
69
44
Indeterminate

⇒ A computer program is used to read N and compute N !. IF N = 6, the result will be
6
12
720
1040

⇒ The Fourier series representation of a periodic current (2 + 62 cos ωt +48 sin 2ωt) A. The effective value is
(2 + 6 + 24) A
0.333333333333333
0.25
0.0833333333333333

⇒ The maximum power handling capacity of a resistor depends on
total surface area
resistance value
thermal capacity of the resistor
resistivity of the material used in the resistor